钢线

Comparing with the old process, the new process makes the content of oxygen half remain, the lowest is 10.9ppm and the average content is 15ppm; the total content of oxide inclusion decreases 45%, the lowest is 16ppm and the average content is 17. 5ppm. The notch toughness value of wheel in the new technology is much increased than that in injecting CaSi powder, in wire-feed and in the conventional process, the notch toughness value at low temperature, such as at -40℃ and -60℃ increased over 40%.

工业性试验结果表明，采用本研究的工艺条件，不仅使车轮钢全面满足GB8601-88和GB8602-88标准中A级车轮的质量要求，而且也满足了铁道部对200km/h高速车轮提出的冶金质量要求，与原工艺相比，使钢中氧含量减少一半，最低为lO.9ppm，平均为15ppm：氧化物夹杂总量下降了45％，最低为16ppm，平均为17.5ppm，车轮的冲击韧性值得到了明显提高，其中-40℃和-60℃的低温冲击韧性值较喷粉、喂线及原工艺高40％以上。

Centrifugally casted HP-Nb superalloy pipe and ICr5Mo steel flange was welded together by manual tungsten -inert - gas arc welding with Ni - based R - N1 wire.

用Ni基R-N_1焊丝作为填充材料，采用小线能量的手工氩弧焊方法可实现离心铸造HP-Nb高温合金炉管与1Cr5Mo钢法兰异质钢的焊接。

The whole ticket hall is a roofing frame system of hyperbolic variable cross-section steel truss and monolayer steel net shell.

整个出发办票大厅为60米跨双曲变截面空间钢桁架和候机指廊，连廊的无拉杆相贯线单层钢网壳的屋面结构体系。

The author investigates the effect of mean stress and stress's amplitude with the non symmetry low cycle fatigue experiment of two kinds of PD3 rail steel (hot rolling and off line heat treatment) produced by PanZhiHua steel company.

通过对攀钢生产的两种PD3钢轨钢(热轧和离线全长热处理)的非对称低周载荷疲劳实验，比较了平均应力和荷载幅值对两种PD3钢轨钢寿命的影响。

If titanium content is less than 30ppm and nitrogen content is less than 60ppm, the inclusion precipitated below temperature of solidus has little effect on the property owing to refine grain.

将钢中的钛含量降到30ppm以下，氮含量降到60ppm，其氮化钛的析出温度降到固相线以下，析出的夹杂尺寸很小，对钢的性能影响较小，甚至有益，因为它能细化晶粒。

The higher low temperature toughness of TTS is related to the formation of intragranular acicular ferrite in the CGHAZ.

线能量大于50 kJ/cm的大热输入条件下， Ti处理钢模拟粗晶区的低温韧性明显高于Al处理钢。

After several practical problems are resolved,the relation between contents of S,Si and Al has been disclosed.The ratio of Ca to Alin in steel is 1.26∶1 after calcium treatment,the nozzle clogging does not happen and the consumption of calcium is reduced.The recovery factor fluctuation of boron are 64% and ±5×10-6, respectively.

通过硼微合金化若干工艺问题的解决和工艺优化，明确了钢水硫含量、增硅、铝控制之间的内在关系；使SPHC钢成分合格的同时，实现硼收得率达到64%，硼的质量分数波动±5×10-6；钙处理达到钢水中w∶w为1.26∶1时，确保水口浇注顺利，同时节省钙线用量。

Welding earth wire: separate copper woven wire into three pieces, weave it again and enwind the phase respectively as well as weld it on the shielded copper band with electric iron and soldering tin; polish steel band welding area with sandcloth, and firmly weld with armored cable after wrapping up with copper wire.

2焊接地线：将铜编织线拆开分成三份，重新编织分别绕各相，用电烙铁、焊锡焊接在屏蔽铜带上；用砂布打光钢带焊接区，用铜丝绑扎后与钢铠焊牢。

Our company is one of the largest steel structure and steel products company in southeast China with an annual output of 60,000 tons. It has a total of 8 product lines including H mode steel product line, digital editing hot roll H mode steel product line, C mode steel product line, Z mode steel product line,, basket mode balk product line.

公司拥有数控焊接H型钢生产线、数控热轧H型钢加工线、C型钢生产线、Z型钢生产线、箱型梁生产线、彩钢保温板生产线共8条，具有年产6万吨钢结构产品的能力，是华南地区最大的钢结构及其配套产品生产厂家之一。

The main products are as follows: straighten cutter (diameter:Φ1.0-Φ9.0 mm), multi-functional precision governor can straighten cutter, the Chen Shui-bian straighten cutter, strip-precision gears for a deduction machine, Gear-precision sheet of the Chen Shui-bian deduction, a deduction of Gear,(D deduction / 1.30 deduction / belt deduction, etc.) for a deduction, S-hooks linked to a deduction, a deduction of computer-balanced machine, racks / Pants-steel deduction for a deduction, automatic racks hook Forming / rubbing teeth Siamese mix, automatic racks hook Roll Machine, automatic keychain combination of machines, semi-automatic hydraulic bending box machine, grinding needle chamfering machine ,(Car Aberdeen axis / linked to a) spend rubbing machine, Network Rail repair Machine, Hydraulic automatic machine Daquan (diameter Φ1.5 ~Φ10 mm)(Circle Drive:Φ25-Φ1000 mm) series, such as wire and machinery specialized for processing Zero, and accessories.

主要产品如下：调直切断机（线径：Φ1.0-Φ9.0mm）、多功能精密可调速调直切断机、方扁调直切断机、扁线机、精密齿轮式打扣机、齿轮式精密薄片扁扣机、齿轮式打扣机、（D扣/三角扣/皮带扣等等）打扣机、S钩挂钩打扣机、电脑平衡杆打扣机、衣架/裤架钢扣打扣机、全自动衣架钩成型/搓牙组合连体机、自动衣架钩搓牙机、全自动钥匙圈组合机、半自动液压弯框机、磨针倒角机、搓花机、铁网修边机、液压全自动打圈机（线径Φ1.5～Φ10mm）（圈径：Φ25-Φ1000mm）等系列线材加工专用机械及零、配件。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。