钠

The chemical stability of Vanisperse-A sodium lignosulphonate in the electrolytic enviroment simulating the floating charge of lead-acid battery was studied.

研究了Vanisperse-A木质素磺酸钠在模拟铅酸电池浮充的电解环境下的化学稳定性，利用UV-Vis和FT-IR光谱，分析了木钠分子中某些官能团的变化情况。

A method of producing crystal sodium fluoride with sodium fluosilicate and sodium carbonate is introduced.

本文介绍了以氟硅酸钠、纯碱为原料生产晶体氟化钠的工艺，并对操作条件作了详细的说明。

The main factors affecting the decompounding rate of sodium fluosilicate by calcined soda were confirmed.

探讨了碳酸化法合成冰晶石的工艺条件，确定了影响纯碱分解氟硅酸钠的分解率的主要因素，试验结果表明：氟化钠溶液的精制、n(6F)/n、反应温度等对冰晶石性能有显著的影响。

A new recovery technology of solid waste was made which is from furfuryl alcohol production by furfural hydrogenization. When the solid waste is placed in a vacuum drying box, and is under lower negative pressure and at 130℃, the organic materials in solid waste can be distilled and then returned to the refining workshop to produce qualified furfuraldehyde and furfuryl alcohol. The remainder is mixed with soda ash and roasted in a reverberating furnace. The sodium chromate can be obtained by leaching. Rough cupric oxide is dissolved in nitric acid and cupric nitrate is obtained. A new catalyst was prepared by the above sodium chromate and cupric nitrate and used in furfuryl alcohol production.

将糠醛液相加氢生产糠醇产生的废渣置于真空干燥箱中，在较低的负压状态下保持130℃的温度，蒸馏回收废渣中的有机物，返回糠醇精制车间获得合格的糠醇与糠醛产品；剩余的固体废弃物与纯碱混合，在反射炉中焙烧，浸取获得铬酸钠水溶液；最后剩下的粗氧化铜溶于硝酸得到硝酸铜溶液；将铬酸钠溶液、硝酸铜溶液按一定比例混合，加入氨水搅拌，分离出的沉淀经传统方法焙烧活化、造粒制得新催化剂，回用于糠醛液相加氢生产糠醇。

The experiment system of caustic soda in the process of Glauber's salt key point is the inclusion of sodium bicarbonate, sodium bicarbonate accession greatly improved the conversion rate of caustic soda.

本实验在芒硝制烧碱过程中的关键点是加入了碳酸氢钠，碳酸氢钠的加入大大提高了烧碱的转化率。

According to the result of experiment, 0.5% sodium hyaluronate was chosen as gel base to select the enhancers. By the result of rheology, the sodium hyaluronate gel possess the property like pseudoplastic fluid, and viscosity was high/low in low-frequency/high-frequency, which was propitious to spreading and glutinousness.

在处方前研究工作的基础上，以药物体外经皮累积渗透量为指标，考察了HPMC和玻璃酸钠对药物体外经皮渗透的影响，根据实验结果选用0.5％玻璃酸钠为凝胶基质进行促渗剂的筛选。

Both the and DtV$ for the glycyl dipeptides increase with increasing molality of sodium acetate. The interactions between charged center or glycyl units of the peptide and ions dominate those between alkyl groups of the peptide and the ions. The interaction between the peptides and sodium acetate is mainly pairwise. The results were interpreted successfully by the cosphere overlap model.

结果表明：甘氨酰二肽的标准偏摩尔体积和标准偏摩尔转移体积均随乙酸钠浓度的增加而增大，溶液中离子与肽带电基团/甘氨酰基团(CH2CONH)之间的相互作用大于离子与肽的非极性基团间的相互作用，乙酸钠和甘氨酰二肽之间主要是对相互作用。

In order to meet the needs of the practical industry, the property of ammonium phosphate and the effect of sodium humate on the habitude of slurry was investigated firstly by experiments:the relation between neutralization value of the slurry and the pH value, the relation between the boiling point and the density, water content and viscosity of slurry;the influence of sodium humate added into slurry on the relation between the neutralizing value and pH value, and on the density, water content and viscosity of the slurry.

为了工业的实际需要，通过实验，首先研究了磷铵料浆的性质以及腐殖酸钠对料浆性质的影响：料浆中和度与其PH 值的关系，料浆沸(来源：AB427242C论文网www.abclunwen.com)点温度与其密度、含水量及粘度的关系；添加腐殖酸钠对料浆中和度与其PH 值之间关系的影响，以及对料浆密度、含水量及粘度的影响。

PH of filtrate is kept below 0.65 in order to avoid the reaction between sodium formate and iodine bromide. Then iodine bromide halogenation method is used to determine quantitatively the content of the third monomer, i.

控制滤液pH在0.65以下，以防止甲酸钠和溴化碘起反应，然后用溴化碘卤化法定量测定滤液中的第三单体甲基丙烯磺酸钠的含量。

Kidney beans is a rare high potassium, high magnesium, low sodium food, hectogram 1520 mg of potassium, magnesium, 193.5 mg of sodium is only 0.8 mg, this feature come in handy in nutritional treatment.

芸豆是一种难得的高钾、高镁、低钠食品，每百克含钾1520毫克，镁193.5毫克，钠仅为0.8毫克，这个特点在营养治疗上大有用武之地。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。