钛

Some reduction methods in titanium metallurgy ,such as the manganese reduction process,the calcium reduction process,the natrium reduction progress,reduction of titanium by electrolyzing of molten salt,etc were introduced.

未来钛冶金的发展方向是用还原二氧化钛为基础的连续式生产技术代替间歇式的Kroll法生产技术，并大力降低原材料和生产的成本。

At first, the method of preparing nanometer doped TiO2 by the hydrolyzing Ti4 was investigated.

为了提高二氧化钛的催化活性，本文对二氧化钛的掺杂进行了研究。

The results indicated that the effect that light catalysis oxidation treated leach was related to the kinds of catalyst, and the result of treatment using autanse-TiO2 is better than rutile. Catalysis capability is improved obviously after autanse-TiO2 was calcined at 600℃, and the way of calcine had large actions for catalysis.Photo-catalytic degradation of organic compound in leaches was carried out with TiO2,-Fe2O3 and ZnO,the following conclusion can be attained.

研究结果表明半导体光催化剂TiO2对垃圾渗滤液的光催化效果和TiO2的晶型有很大的相关性，锐钛型TiO2的光催化效果明显优于金红石型TiO2；高温处理锐钛型TiO2改变其晶型和表面结构，600℃煅烧TiO2的光催化活性有较大提高；光催化剂的活化方式亦影响光催化效果。

Eventually, he settled on outfitting modified TIE/ln starfighters with them, which he dubbed TIE Phantoms.

最终，他从中选定了改进装具后的隐形钛战机，并将其称为鬼怪型钛战机。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

The preparation of titanium alloy powder's slurries with high solid loading was investigated.

但是，钛及钛合金价格高，耐磨性、铸造性和加工性能差，因而制约着它的广泛应用。

The development of metal-air battery and air electrode is briefly introduced in this paper. Then, the catalysts for oxygen reduction, especially perovskite-type oxide, are reviewed in detail. Meanwhile, the principle of sol-gel technology is summered, and then their preparation with Sol-Gel method has been briefly introduced.

本论文简述了锌-空气电池及空气电极，介绍了金属-空气电池用催化剂特别是钙钛矿型复合氧化物催化剂的研究现状及进展，并对溶胶-凝胶制备法制备钙钛矿型复合氧化物作了简要的介绍。

The results show that magnesium and aluminum theoretically can be thoroughly dissolved from the blast furnace slag by diluted sulfuric acid pretreatment on the blast furnace slag even if the ended concentration of sulfuric acid is 0.001mol/L, while the titanium basically could not be dissolved. Therefore it is theoretically indicated that the separation of the magnesium and aluminum from the slag with the least titanium loss by diluted sulfuric acid pretreatment is possible.

结果表明，采用稀硫酸对高炉渣进行预处理，当终酸浓度即使为0.001mol·l~(-1)时，镁、铝理论上也能全部被酸浸出，而钛在0.001 mol·l~(-1)的酸浓度条件下基本不被浸出，从而从理论上可以说明对高炉渣采用稀酸预处理可以很好的将炉渣中的镁、铝等杂质分离出来，而钛极少被浸出。

Has completed major projects including the world-famous giant white horse in Panzhihua City, vanadium and titanium magnetite, vanadium and titanium magnetite red grid, Lala Copper Mine, the largest long-Salt Salt Group, the Duke of Zhou Spa, Luofu Spa, Hai Luogou Spa , Sino-foreign joint ventures, wholly-owned cement with limestone, Chongqing Municipality in Yangsan, Yong-rong, Tianfu, South-tong, pine species, Sichuan climbing coal, can be wide, bamboo and other mining bureau of coal mine owned a large number of small and medium-sized coal mine restructuring , The continuation of Nanchuan bauxite, gold agate shell, Guizhou Hezhang siderite, Fuquan phosphate rock and phosphate rock Xundian Yunnan, Tibet, such as gold sand.

已完成的主要项目包括世界著名的攀枝花市白马特大型釩钛磁铁矿、红格釩钛磁铁矿、拉拉铜矿、久大盐业集团盐矿、周公山温泉、罗浮山温泉、海螺沟温泉、中外合资、独资水泥用石灰岩、重庆市中梁山、永荣、天府、南桐、松藻、四川攀煤、广能、达竹等矿务局所属煤矿、大量中小型煤矿改制、延续、南川铝土矿、玛瑙壳金矿、贵州赫章菱铁矿、福泉磷矿、云南寻甸磷矿、西藏砂金矿等。

Meanwhile, the processing technique of the titanium alloy balance wheel was analyzed, and the machining process was designed too.

同时还对钛合金摆轮的加工工艺性进行了分析，并且设计了这种摆轮的加工过程。最后，总结出应用钛合金材料摆轮的优缺点。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。