钎焊的

Attempting to braze a contaminated or improperly cleaned surface will result in an unsatisfactory joint.

在已经弄脏或不正确清洗的表面上进行钎焊，焊接效果就很难令人满意

Attempting to braze a contaminate d or improperly cleaned surface will result in an unsatisfactory joint.

在已经弄脏或不正确清洗的表面上进行钎焊，焊接效果就很难令人满意

Diathermy is widely used in metal forging, mechanical parts and components heat treatment hardening, brazing and hardening the surface of small parts, solar collector tubes grilled consumption devices, wire and heat treatment.

广泛应用于金属透热锻打，机械零部件热处理淬火，钎焊及微小工件的表面淬火、太阳能集热管烤消设备、线材热处理等。

Debugging characteristics of the inductive circuit were analyzed, and the circuit was applied to the induction vbrazing power.

分析了该电路中存在感性元件时的调试特点，并将它实际应用于感应钎焊电源中。

In this dissertation, joints of single crystal Al2O3 and Nb were prepared by tungsten metallization and Pd brazing.

本文通过钨金属化和Pd钎焊，成功获得了单晶Al2O3与金属Nb的连接接头。

Soldering of copper, brass, copper alloysgalvanized iron plain sheet.

铜及铜合金、镀锌铁皮的钎焊。

Soldering of copper, brass, copper alloys and galvanized iron plain sheet.

铜、黄铜、铁、镀锌铁皮的钎焊。

The method to ensure proper soldering temperature and the principle for that is also dealt with.

指出了保证钎焊温度的方法及其原理等。

In this paper an experimental investigation was made on laser soldering of diamond grain.

本文主要研究了金刚石磨粒的激光钎焊。

Meanwhile the growth behavior of IMC with the variation of soldering time is analyzed and discussed.

同时分析、讨论了界面IMC随钎焊时间变化的生长行为。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。