量过的

In order to understand the mechanism of anti-inflammatory effect of PA and carvacrol, the superoxide dismutase, glutahoine reductase, glutahoine peroxidase activities in liver and malondialdehyde , cyclooxygenase 2 (COX-2), tumor necrosis factor-α levels were eveluated. Also observed inducible nitric oxide synthase and cyclooxygenase-2 (COX-2) expression and the pathological histology in λ-carrageenan induced paw edema in mice.

本研究首先以醋酸扭体试验评估左手香水抽提物及其活性成分香芹酚是否具有镇痛效果，以福马林舔足试验辨别其镇痛作用是在周边或是中枢，再以λ-角叉菜胶诱导小鼠足跖肿胀试验探讨其抗发炎作用，并分析其肝脏组织中的超氧歧化酶、麸胱甘肽还原酶、麸胱甘肽过氧化酶活性、发炎足跖组织中的脂质过氧化指标产物丙二醛、肿瘤坏死因子-α及环氧化酶-2之含量变化，观察诱导型一氧化氮合成酶及环氧化酶-2之蛋白质表现量，并将肿胀足跖做病理切片观察之，以探讨左手香水抽提物及香芹酚之抗发炎机转。

With the increasing of irrigation , chlorophyl 1 content of three turfgrasswould go up , but to some degree,over-irrigation would also result in the decline of chlorophyll content.

叶绿素含量总体都是随灌溉量的增加而增大的，过高的灌溉量甚至会引起叶绿素含量的下降。

The stress-strain curves of Cu-Zn-Al alloys at different temperatures have been plotted on the tensile machine with the aid of electrometry. The main results were as follows: 1. When specimens were deformed within the range of M_s and M_d, the critical stress for inducing martensitic transformation increased with the temperature, and there existed a linear relationship between them. 2. When specimens were deformed above Af, complete pseudoelasticity might be obtained theoretically, which might be damaged, h...

在拉力试验机上用电测法测绘了Cu-Zn-Al合金在马氏体相变点上下各温度的σ-ε曲线，所得主要结果如下：(1)试样在M_s与M_d之间加载，随着温度升高，诱发马氏体相变所需临界应力增大，且加载温度与临界应力之间存在着线性关系；(2)在A_f点以上加载，理论上可获得完全的伪弹性，但加载温度过高或应变量过大，均会损害伪弹性；(3)试样在M_s点上下温度区域变形，得到的伪弹性回复和形状记忆回复之和在80%以上，但在M_s点附近总回复量出现一极小值，且伪弹性回复在M_f点以下又有所回升。

The study also showed that too much more hydroxide sodium and higher...

研究结果表明，过高的糊化温度和过大的碱量都不利于成胶。

In speak of how to click the website bulkily quantity translate into to click a quantity effectively, when the active force that makes network profit, chen Tong combines sina net to be analysed actually, sina from establish the loss that 8 years experienced first period, had not earned a minute of money.

在谈到如何将网站庞大的点击量转化为有效点击量，成为网络盈利的主动力时，陈彤结合新浪网实际分析，新浪从组建初经历了8年的亏损期，没有赚过一分钱。

However, during borehole grouting pile construction of the present, round section piles are used universally. Generally speaking, the boreholes are drilled by a large diameter round piling bit. Because of the restriction of factors of the mud pumps, and drilling equipments, and drilling technique, it would result in such problems as fol lowing: a bigger cutting area and overlarge cuttings volume, and more hole bottom sediments, difficult cuttings discharging, and serverely repeat cuttings breaking, and using more concret grouting amount, and lower drilling speed, faster bit wearing, and longer working period, bigger material and labor ex haust, and higher engineering cost, unreasonable ratio of loading capacity to volume of pile foundation, and lower comprehensive economic benefits, and so forth.

然而，钻孔灌注桩施工中，目前最为普遍采用的是圆形断面桩基，一般采用大口径圆形基桩工程钻头，由于国内生产的泥浆泵、钻具及钻进方法等因素的限制，从而使钻孔破岩面积和体积过大，造成孔底沉渣过多，排渣困难且排浆量大，重复破碎问题突出，混凝土灌注量大，直接反映为钻进效率低、钻头磨损快、施工工期长、材料能耗和劳动消耗大、工程成本较高、桩基荷载能力与体积比不合理、综合经济效益不理想等，这些问题严重影响和制约着钻孔灌注桩施工技术的发展和进步。

The laser-cladding layeron the alloy consists of matrix phase of over-saturation solid solution γ and complexhexagonal carbide M_7C_3. Under certain condition, with fast laser scanning speed, the oversaturation solubility of elements increases in γ, and the precipitation of the complexcarbide M_7C_3 decreases, so that the microhardness increases and the wear resistance de-creases. But at slower laser scanning speed, more complex carbide M_7C_3 may precipitate, andthe wear resistance may be improved. Therefore, it is believed that the principal factor in im-provement over wear resistance is the precipitation of carbide M_7C_3, while overmicrohardness is the over-saturation solubility of elements in matrix phase.

表明：(1)激光熔覆合金层是由过饱和的γ基体相和复杂的六方M_7C_3碳化物相所组成(2)在其他参数不变的情况下，随激光扫描速度的提高，γ基体相过饱和度增大，而析出的碳化物含量减少，因而合金层的硬度升高，耐磨性有所下降；而降低激光的扫描速度，碳化物M_7C_3析出增加，有利于提高合金层的耐磨性、因此碳化物M_7C_3析出量是提高耐磨性的主要因素，而增加基体相γ的过饱和度则是硬度提高的主要因素

Based on the theory of elasticity, the variations of lower limit and upper limit of the interference value of a hollow iron roll with the axle sleeve were determined as a function of paper machine speed.

应用弹性理论导出了纸机中具有闷头的空心铸铁辊结构的过盈量上下限相对变化与车速的关系式，提出了极限车速的概念与计算方法，从而为过盈量的动态估算提供了量化依据。

When the amount of fluid into the evaporator, the evaporator heat load is less than required, then the evaporator superheat steam export increases, the pressure is greater than the bottom of the top diaphragm pressure to force the diaphragm down so that bulge through the mandrel compression spring, and the valve pin to open the top, so that valve to open big holes are for fluid volume increase.

当进入蒸发器的液量小于蒸发器热负荷的需要时，则蒸发器出口蒸气的过热度增大，膜片上方的压力大于下方的压力，这样就迫使膜片向下鼓出，通过顶杆压缩弹簧，并把阀针顶开，使阀孔开大，则供液量增大。

The results show:the amount of tar is declining when flue-cured which is low tar,combustion-supporting,the use of additives,reconstructed tobacco,expended tobacco while the amount of tar is same when cigarettes paper which is high porosity which are pereated are used. But if the porosity of cigarette paper are too high,the quality of cigarettes inside will be effected.

结果表明：采用焦油含量低的烤烟烟叶、膨胀烟草、烟草薄片、合适的烟用添加剂，则焦油量呈下降趋势；在辅助材料方面，使用高透气度盘纸，则焦油量呈下降趋势，但通气度不易过高，否则影响卷烟的内在质量。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了