量热
- 与 量热 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Apply color camera as a temperature sensor,adopt heat analog technology,CAGD etc. high technology,through the image process of inner weld seam temperature distribution to identify the tolerance between the arc center and skelp joint gap accurately and timely.
摘 要 利用彩色摄象机做为温度传感器,采用热模拟技术,CAGD等高新技术,通过对内焊缝背面温度场分布情况进行图象处理,从而准确、及时地识别出电弧中心与板缝合口的偏差量,经步进电机随时调整。
-
When the replacement was increased to 10% with crystallization at 820 ℃, willemite appeared in addition to β-quartz solid solution and β-spodumene.
当 ZnO 的取代量增加到 10%时, 820 ℃高温晶化后,除了析出了β-石英固溶体、β-锂辉石固溶体外,还出现了硅锌矿相,使材料有较好的热性能和力学性能。
-
The valve setting of the TXV is determined by the amount of superheat in the refrigerant vapor.
阀门设定的txv量而定过热的制冷剂蒸气。
-
After hot carrier stress, devices were evaluated by using positive bias temperature instability test. With different trends in the time evolution of threshold voltage shift and sub-threshold swing degradation, it is found that electron trapping in the HfO2 is the major reason for the threshold voltage variation. Compared to control devices, devices with fluorine and nitrogen exhibit good passivation at the interface. Devices were measured at an elevated temperature.
在热载子效应后,接著进行正偏压温度不稳定的量测方法,从随时间变动的临界电压以及次临界摆幅,发现临界电压的变动趋势与临界摆幅变动趋势不符合,表示二氧化铪的原生缺陷补捉是造成临界电压变动的主因,而临界摆幅的变动也可得知有氟,氮处理元件具有比较好的介面可靠度。
-
Under strict quality control of CQC, kaina lead-free solder is used in high-purity refined tin and advanced smelting technology, a unique anti-oxidant formula alloy, its taphole amount is very small, bright solder joints, reliable, good wetting, it is suitable in lead-free wave soldering and hot dip soldering
在CQC严密的质量监控下,凯纳无铅焊锡条采用高纯度精锡及先进的熔炼工艺,独特的抗氧化合金配方,其出渣量极少,焊点光亮、可靠,湿润性好,适用于无铅波峰焊和热浸焊。本企业供应58℃~145℃不同熔点温度的无铅低温焊锡条。
-
The relationship of modification level and △TEG(the eutectic temperature difference between modified and unmodified alloy) was established.
利用自主开发的铝合金热分析系统,研究了Sr加入量、变质后保温时间对ZL104合金冷却曲线的影响,建立了变质等级与变质前后共晶温度的降低值△TEG之间的对应关系。
-
In the most general case the thermal conductivity is a tensor with six components.
在最一般的情况下,热导率是一个具有六个分量的张量。
-
Eliminate effects of therm al expansion, and measurements are taken from time load is
温度,以消除热膨胀的影响,测量取自负荷量为零的时刻,以消除弹性的影响。
-
The centrifugal force and content of CaF〓 in thermit can affect the surface roughness of stainless steel layer. It is important to heat the thermit before ignition to decrease the Al content in stainless steel layer.
经过反复的实验发现,制备低铝量的18—8不锈钢内衬复合钢管的修正配方为:〓采用适当的预热温度和离心力下,按上述配方配制的铝热剂经适当调整后可以制备出成分满足要求、内表面光滑、结合强度高的复合钢管。
-
Each thermocouple type is unique in terms of the amount of potential for a given change in temperature.
对于一种给定类型的热偶来说,其温度变化对应的电位变化量是一定的。
- 推荐网络例句
-
Do you know, i need you to come back
你知道吗,我需要你回来
-
Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.
1〕 杨银书,王祥生,李德昌。安徽省首次发现嗜群血蜱。
-
Chapter Three: Type classification of DE structure in Sino-Tibetan languages.
第三章汉藏语&的&字结构的类型划分。