量热

Results 72 patients were eutrophy,5 patients were innutrition,41 patients were overweight and 7 patients were adiposity by BMI method;the absorption of diversified nutriment were lower than recommended nutrient intake;the percent of the caloric produce by fat was 32.71%,produce by protein was 18.07%,produce by carbohydrate was 49.22%.

结果 采用BMI法认定体重正常者72例，低体重者5例，超重41例，肥胖7例；各营养素的摄入均低于推荐量；三营养物质中脂肪产热占32.71%，蛋白质产热占18.07%，碳水化合物产热占49.22%。

The discrete heat and moisture transfer equation and control conditions are obtained with finite volume method. The temperature and moisture distribution and transient heat and moisture absorbing and desorbing of porous envelop are calculated with numerical method. The program for porous envelop heat and moisture transfer are developed by use of FORTRAN. The heat and moisture transfer model is verified using the examples given out in the reference [41] and testing data of funk hole located in A zone Chongqing university.

采用有限体积法对多孔材料热湿传递方程及控制条件进行离散，用数值方法求解多孔围护结构温湿度分布和壁面的瞬时热湿吸放量，采用FORTRAN语言编写了围护结构热湿传递计算程序，并用文献[41]给出的算例和重庆大学A区防空洞的测试数据对模型进行了验证。

Calculating the pavement fragment adoptioning contradicting -cleft -glue and glass fiber grille ,deal with the existing crevasse, at kaminaka surface layer install rubber asphalt water proof adhesive layer , at the same time guarding against water coming into nakashita surface layer、enhanced interlamination bonding ...

论文进行橡胶沥青混合料的主要试验内容有：1、根据京秦高速公路管理处提供的石料进行目标配比设计；2、进行混合料马歇尔击实及相关性能试验确定最佳油石比。3、根据冷料配比进行热料仓筛分，确定热料仓配比；4、根据热料仓配比进行马歇尔击实试验。4、进行混合料的路用性能试验，分析橡胶粉的掺入对沥青的高低温性能、弹性性能、抗老化性能的改善情况，分析橡胶粉的掺量、目数、胶源、加工工艺和基质沥青对橡胶沥青性能改善的影响程度。

Thermal simulation experiments has carried out on mudstone,marlite and limestone,three kinds of typical Ordovician source rock samples,from foreland basin of western Ordos,not only revealed the evolve process and characteristics of hydrocarbon generation indoors but also provided important parameter for calculation the amount of hydrocarbon generation in this region.

通过对鄂尔多斯盆地西缘奥陶系3类代表性的烃源岩即泥岩、泥灰岩和灰岩进行热模拟试验，不仅在室内再现了各类岩样的生烃演化过程及特点，而且为该地区生烃量计算提供了重要依据。试验结果表明，泥岩的生烃能力最强，最终产气率达527 m3/tTOC，泥灰岩次之，最终产气率为512m3/tTOC，纯灰岩最差，最终产气率仅267 m3/tTOC；气态烃的产出与热成熟度密切相关，较高的热演化程度对气态烃的生成是有利的。

Glass ceramics with α cordierite(2MgO·2Al 2O 3·5SiO 2) as main crystal phase, having excellent dielectric property, are perfect materials for microwave parts of a medium apparatus However, the thermal expansion coefficient of the material is not high enough for some special applications Now, a novel glass ceramics with suitable thermal expansion coefficient (47 7×10 -7 / C) and excellent dielectric property (ε=5 1,tgδ0 -3 ) was developed Crystallization process and the th...

本文以堇青石微晶玻璃为研究对象，首次研制得到了一种低介（ε＝ 51）、低损耗（tgδ＜10－ 3）、热膨胀系数（46 ～48 ×10－ 7' C）能与其它器件相匹配的新型微晶玻璃介质材料通过 X射线衍射分析，扫描电镜观察等测试手段，研究了该材料的晶化过程和热膨胀系数的变化规律发现样品的热膨胀系数随温度的变化行为是与样品中析出的晶相种类及析出量随温度的变化规律相对应的

According to thermal conduction theories of anisotropic materials that are irradiated with continuously modulated laser, a photothermal measuring method about the thermal conductivity tensor and the orientation of the principal axis of the conductivity of arbitrarily opaquely anisotropic materials is given based on the theories of So(3) group rotation.

以在连续调制光辐照下的各向异性介质的热传导理论为基础，通过So(3)群转动理论，导出不透明各向异性介质的热导张量和热导主轴方向的光热测量方法。

The relative output factors of Cyberknife were also measured by the radiophotoluminescent glass dosimeters, thermoluminescent dosimeters and Kodak EDR2 films. Phantom study was also performed to estimate the difference between the experimental measurements and dose calculations by treatment planning system.

同时，利用照射发光玻璃剂量计、热发光剂量计以及EDR2胶片剂量计进行相对输出因子之量测，以验证电脑刀模拟之正确性，此外，本研究中亦会模拟电脑刀实际治疗程序进行拟人形假体剂量量测，评估剂量量测值与电脑治疗计画系统之计算值进行比较。

The coarsened long strip-like Cu6Sn5 with a length of more than 80μm growing from upper interface of IMC layer to solder matrix and its length of more than 80μm in the matrix are observed in the solder with 1.5wt-%Cu addition after thermal storage.

在含Cu量大於1.0 wt%时，会有金属间化合物Cu6Sn5在焊料内析出，大小随Cu量的增加而增大，当添加量达最高的1.5 wt% Cu时，焊料在长时间热储存后，从焊料/Cu界面的IMC层上表面向焊料成长的Cu6Sn5长度超过80μm，而焊料内最长的甚至超过100μm。

Hydrogen production of heat treatment sludge, acid treatment sludge, normal sludge, base treatment sludge and ultrasonic sludge from simulated wastewater by anaerobic sewage were investigated. The substrate containing glucose was treated with anaerobic heat treatment sewage sludge. The biohydrogen was produced through anaerobic hydrogen fermentation.

试验研究了酸处理、碱处理、热处理、超声波预处理厌氧污泥发酵产氢的产氢量，选择产氢量最高的热预处理后的污泥作为混合微生物系，以葡萄糖为基质，研究了温度、pH值、底物浓度对厌氧污泥发酵产氢量的影响。

Biodegradable composites reinforced with bagasse fibre were prepared by a press forming,and the thermal properties of fibre and the flexural modulus of composites were investigated in view of the fibre content and length.

利用压制成型制备了甘蔗渣纤维增强可降解复合材料，分析了纤维的热分解性能，研究了纤维含有量和纤维长度对材料弯曲模量的影响，利用Cox剪滞法和材料的结构特点，探讨了一种新的修正模型对弯曲模量的预测。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。