量尺寸

Air temperatures;Atmosphere;Biological;Chemical;Classification;Classification systems;Climate;Contamination;Definition;Definitions;Degree of sharpness;Electric appliances;Electrical components;Electrical engineering;Electrical equipment;Electrically-operated devices;Electronic equipment and components;Environment;Environmental and safety engineering;Environmental condition;Environmental conditions;Environmental effects;Environmental factor of influence;Environmental testing;Humidity;Influence quantity;Limits;Long-time storage;Mechanic;Open air climate;Parameters;Preferred sizes;Preferred value;Temperature;Testing;Weathering

中文主题词生物的；参数；环境影响；锐度；露天气候；优先尺寸；影响的环境因素；优选值；长时存储；影响量；电气元件；空气温度；化学的；气候；污染；分类系统；湿度；环境条件；环境条件；极限；力学；电子设备及元件；电驱动装置；环境试验；电气设备；定义；温度；环境与安全工程；风化；分类；电气工程；大气；电气器具；试验；环境

Increasing the calcining temperature at 1500℃ 5h, the morphologies of the product became the big and wide vermiform-fiber form particles, the length was about 2.5 μm, and the width was about 700 nm. In addition, the vermiform-fiber form particle could be found in the filtrated precipitate with the additional ammonium sulfate. If the ratio of ammonium sulfate to alum is above 1, the vermiform-fiber form particle was formed. After calcined at 1500℃ 5h, the particle grow up to 2μm. Adding ammonium sulfate was also reduced the particles size of alumina because the surface area of the products was increased by increasing the quantity of ammonium sulfate.

在明矾与氨水沉淀物经过滤后再额外添加不同硫酸铵的比例，1200℃ 1hr煅烧后，发现添加硫酸铵比例在1以上，其型态亦为蠕虫状纤维，当以1500℃ 5hr煅烧，蠕虫状纤维型态粒子亦变为又大又胖，其粒子尺寸长度约为 2 μm 宽度约为 500 nm；且将煅烧1200℃ 1hr测其比表面积值，会随著硫酸铵的添加量增加，粉体的表面积会增加且粉体变细，添加硫酸铵比例为 4 者所得粉体粒径最小，从比表面积所得结果估计约 150 nm 。

Analytical results of differential scanning calorimetry DSC and X-ray diffraction XRD indicated that after compression molding,the melt temperature of PLLA crystals decreased while the degree of crystallinity increased.

差示扫描量热DSC分析和X-射线衍射XRD分析表明PLLA模压成棒后，PLLA的结晶熔点下降，微晶尺寸变小，而结晶度增大。

Then we establish a polynomial equation representing the relation between the distance of CCD apart from human face and the gap of human eyes in the CCD image through a set of experimental data.

最后是探讨CCD拍摄的不确定性，对影像量测工作可能造成的影响，并藉由统计的方式计算拍摄不确定性的范围，以调整齿轮尺寸的公差，提高量测的可信度及检验的准确度。

The results showed that the fiber had the function of absorbing toluene and trichloroethylene after introducing HEMA into macromolecules, and the absorptive process obeyed Hill equation of sigmoidal model.Toluene and trichloroethylene absorbency increased with the increase of mass fraction of HEMA,and their maximum absorbency was 10 g/g and 21 g/g,respectively.The ratio of remaining fiber also increased with the increase of mass fraction of HEMA to make organic liquid retention ratio strengthen.Furthermore,dynamic mechanical performance of the fiber was affected by mass fraction of HEMA obviously, and the segments movement was influenced more obviously.At the same time,mass fraction of HEMA had a great impact on the surface and cross section morphologies,especially,many cavities existed in surface, and cross section had a lot of holes with asymmetric size when mass fraction of HEMA was equal to 15 wt%.

结果表明，HEMA引入大分子后，所得纤维对有机液体甲苯、三氯乙烯具有吸附功能，且吸附过程符合sigmoidal模型中的Hill方程；随HEMA质量分数的增加，纤维对甲苯和三氯乙烯的饱和吸附量增大，对甲苯和三氯乙烯的最大吸附量分别可达10 g/g和21 g/g；随HEMA质量分数的增加，纤维剩余率增加的同时，使纤维对甲苯和三氯乙烯的握持能力增强；HEMA质量分数对纤维动态力学性能有突出影响，特别是链段运动受其影响更为明显；HEMA质量分数对纤维表面和断面形貌均有显著影响，特别是当HEMA质量分数为15 wt%时，所得纤维表面出现了许多空洞，其断面存在许多尺寸不均的空洞。

The result shows that the chest measurement increment and the dispersion of the upper and lower chest measurement will increase by equidifferent with chest height increasing by 1 cm, the variable is all provided by the front bodice, the breast convex amount, shoulder dart and waist dart will increase correspondingly, and the measurement size of the back bodice don't change.

结果显示：胸高每增高1 cm，胸围增量、胸上下围差量呈等差增加，变量都由前衣片提供，乳凸量、肩省、腰节省都相应增大，后衣身各项围度尺寸没有变化。

The results show that the SAPO–5 has a pillar-like morphology with the size of about 20 μm×5 μm×5 μm.The ratio of P:Al:Si is 1:1.19:0.67 in its crystal structure, the content of Si is high. The total acidimety fo the SAPO–5 is 578.0 μmol/g , hihger than that of prepared by one step crystalline hydrothermal method.And its initial catalysis character performance on normal butane isomerization reaction reach 24.8 %, higher than that of prepared by one step crystalline hydrothermal method.

实验结果表明：产物为柱状的磷酸硅铝分子筛，其晶粒尺寸大约为20 μm×5 μm×5 μm，其晶体结构中P：Al：Si＝1：1.19：0.67，硅含量较高；采用分段晶化方式制备的SAPO-5分子筛的总酸量为578.0 μmol/g高于一段晶化方式制备的SAPO-5分子筛的总酸量；采用分段晶化生成的SAPO-5分子筛的催化正丁烷异构化反应初始活性可达到24.8 %，远高于一段晶化制备的SAPO-5分子筛的初始活性14.1 %。

The present paper is intended to offer a method that can be used to revise measured value of cam outline according to the identified mounting eccentric magnitude of the camshaft,as well as the given base circle radius of the cam.

凸轮轴在检测仪上的安装偏心量会影响凸轮轴上凸轮廓形尺寸测量的准确性和复现性。本文提出了根据辨识获得的安装偏心量和已知的凸轮基圆半径来修正凸轮廓形测量值的方法。此方法在实际测量中获得了满意的效

From fixed-size systems for high volume inspection to range adjustable systems for maximum versatility, standard Johnson Gage Inspection Systems are ideally suited to your application, UN, UNJ, Metric, NPT, Acme, Buttress as well as other thread profiles are easily incorporated into the basic design.

从适用于大批量检测的固定尺寸螺纹量仪到具有最大多用途的范围可调的量仪，章森螺纹测量仪将会是非常完美的满足您的测量需求 UN ， UNJ ， Metric，NPT，Acme，Buttress 和其它的螺纹轮廓将会非常容易与基础设计整合在一起。

Shoes boots! We measure the leg quantity foot, the design size all take responsibility by you, we design specially for you, hit the version, makes the shoetree, making only belongs to your classical and the comfort.

之鞋靴！我们量腿量脚，款式尺寸全由您做主，我们专门为您设计，打版，制楦，打造只属于您的经典与舒适。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。