量压的

This research shall be obtain that ocean-sand motor shall have more compressive strength early, but later strength shall descend, by means of non-standard sand mixing sample is quite obvious. By means of 50% ocean-sand substitutes for river-sand to mix fine aggregate compressive strength early shall be risen 20%~30%; Adds slag to ocean-sand or a half of river-sand and ocean-sand to make motor test sample, Compressive strength、bending strength and tensile strength shall be according to slag additament, by means of. slag add itament substitutes for cement 40%~60% is most. But slag be able to substitute for cement is too enough, 1ater strength shall be descent.

由本研究可得知海砂拌和的水泥砂浆，其早期抗压强度较高，而晚期强度则有下降的趋势，其中以非标准砂拌和效果最为明显；若以50%海砂替代河砂做为拌和细骨材，其早期抗压强度约上升20%~30%；添加炉石於海砂或河砂、海砂各半的水泥砂浆，其抗压、抗弯及抗拉强度，会随著炉石添加量增加而增加，其中以40%~60%炉石替代量为最佳，但是炉石替代量过高，晚期强度会下降；在相同水灰比状况下以海砂拌和水泥砂浆做比较，以非标准砂拌和有较高的抗压强度，其强度约比标准砂高10%左右。

Compressed with hydraulic high density baler, the feed rate of fresh Sudan grass was designed as 5, 6, 7 and 8 kg to research the relationship between compressive force and compressed density under the conditions with same feed rate and the effect of feed rate on the compressive force under the condition of the identical compressed density.

方法］用液压高密度压捆机压缩，设计新鲜苏丹草的喂入量为5、6、7、8kg，研究喂入量相同条件下压缩力与压缩密度之间的关系以及相同压缩密度条件下喂入量对压缩力的影响。

Hemodynamic measurements, including centralvenous pressure, pulmonary capillary wedge pressure, PPV, GEDV,and cardiac output derived by transpulmonary thermodilution,cardiac output, and stroke volume index obtained by pulmonaryartery thermodilution were performed at normovolemia, and afterfluid administration, with 25 mL/kg of hydroxylethyl starch6%.

记录正常容量和输入25 mL/kg 羟乙基淀粉6%溶液后的血流动力学参数，包括中心静脉压、肺毛细血管楔压、 PPV 、用经肺温度稀释法得到的 GEDV 和心输出量以及通过肺动脉温度稀释法获得的心输出量和心搏量指数。

By means of triaxial tests, uniaxial compressive tests of a prism and bending tests of a reinforced cement-soil beam, elastic and deformation modulus of cement soil are studied and the relationships between deformation modulus and compressive strength are obtained.

通过三轴试验、棱柱体单轴抗压试验及加筋水泥土梁的抗弯试验，研究了水泥土的弹性模量及变形模量，得到了变形模量与抗压强度之间的关系，并分析了试验方法对变形模量测试结果的影响。

On the base of large amount of tests, this thesis analyzes the impacts of testing period, fiber dosage and cement dosage upon the compressive strength, splitting tensile strength, compressive resilient modulus, flexural strength and flexural elastic modulus of polypropylene fiber cement stabilized macadam, and the corresponding impact rule was found.

3在大量试验的基础上分析了试验龄期、纤维掺量、水泥掺量对聚丙烯纤维水泥稳定碎石抗压强度、劈裂抗拉强度、抗压回弹模量、抗弯拉强度和抗弯拉弹性模量等的影响，并得出了相应的影响规律。

Usually, it needs one transmitter and one pressure gauge for each pressure monitoring point in the factory. And then factory needs to spend much money to install many transmitters and gauges for complex duct system.

通常在工厂内的管路压力监测装置皆为一个压力点使用一个差压计，对於复杂的管路系统则可能多达上百个差压计的安装，本装置可有效利用电磁阀的切换来节省差压计的装设量。

Usually, it needs one transmitter and one pressure gauge for each pressure monitoring point in the factory. And then factory needs to spend much money to install many transmitters and gauges for complex duct system.

通常在工厂内的管路压力监测装置皆为一个压力点使用一个差压计，对于复杂的管路系统则可能多达上百个差压计的安装，本装置可有效利用电磁阀的切换来节省差压计的装设量。

Engine cylinder liner of the general process of measurement are: cylinder liner according to the nominal size measuring selection, that is, sub-thousand-foot-cylinder form and quantity (including the volume of cylinder rod inserted table); installation and adjustment of measuring, that is first to adjust micrometer cylinder liner the nominal size, and then loaded card good indicator of the volume of cylinder form measuring bar and the bar card inserted in the anvil micrometer measuring bar between the seat and adjust the volume of cylinder form of extended length of rod inserted, when the dial indicator of the 1.5-2.0 cells have small hands around the amount of pre-press under lock-lock female plug, and a large dial indicator to zero adjust

发动机气缸套测量的一般过程是：根据气缸套的公称尺寸选择量具，即千分尺和量缸表；安装和调整量具，即先将千分尺调整到气缸套的公称尺寸，再将卡装好百分表的量缸表的测杆和插杆卡在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2.0格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

The first direct measurement with micrometer diameter piston skirt, and then dial indicator card installed and the initial installation of the amount of good cylinder rod inserted card table micrometer mounted on the anvil between the seat and the measuring bar, adjust the volume of cylinder table Interpolation of the extended length of rod, when the dial indicator has small hands around 1.5-2 cell volume preloading lock locking rod inserted mother, and a large dial indicator to zero adjust the final stretch to the volume of cylinder table into the Cylinder Sleeve, large dial indicator hands than "zero" low value (considering the small hands reading) is the piston and cylinder liner with the space.

2先直接用千分尺测量活塞裙部的外径，然后将卡装好百分表和初步安装好插杆的量缸表卡装在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零，最后将量缸表伸入气缸套内，百分表大表针比&零&低的数值即为活塞和气缸套的配合间隙。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。