重对的

We then show how to achieve min-round (3-round) resettable zero-knowledge arguments for NP with concurrent soundness in the WPK model.

接下来，我们显示如何在弱公钥模型下对所有NP-语言实现最少轮（3-round）同时具有并发可靠性的可重置零知识辩论系统。

The impact strength was twice of PA6/SAMH binary system with a same flame-retarded performance.

采用热重分析、扫描电子显微镜对PA6/SAMH/PE三元体系的阻燃机理进行了探讨，发现母料法体系各组分界面作用强，燃烧炭层致密，残炭率高。

In this paper numerical simulation on the mechanical expanding process of line pipe is made by means of elastic-plastic FEM analysis software-MARC. The influence of sectorial angle on deformation characters is especially analyzed, and some useful results are gained.

本文运用大变形弹塑性有限元分析软件MARC，对管线钢管机械扩径过程进行了数值模拟，著重分析了扩径模具的扇形角对扩径过程的影响，得到了一些有益的结论。

And the PLA/Chitosan/ACP barriers with additional 2 wt% chitosan still maintain 56.58 % antibacterial ability after eightieth day. The different composition of PLA/Chitosan/ACP composites was prepared by water washing solidification from NMP/water/lactic acid consolvent. After storing at room temperature for 48 hours and taking it out to obtain a shapable composites. To investigate the influence of ratio of composition with the shapable property of composites, it was analyzed by Rheometer, TGA, AFM, XRD. The result of the different APC content had different effect both water content and yield stress of composite materials. The yield stress decreased with ACP content while increases. It was derived that ions, released from ACP interact with amide groups of chitosan to form water-absorbing ionic clusters through chelating or electrostatic attraction.

另外，以聚乳酸/几丁聚醣作为基材并添加不同比例的非晶型磷酸钙，经过水洗固化后可得白色片状沉淀物，於室温下静置48小时后，复合材之体积呈现膨胀且具有可塑形之特性，以热重分析仪与流变仪分析样品之含水率与屈伏应力，结果显示不同ACP含量对复合材含水率与屈伏应力具有消长变化，而PLA/Chitosan/ACP之可塑程度与其所吸收之水份多寡有关，推测可能机制为ACP磷酸钙盐解离后之金属离子与几丁聚醣之胺基透过螯合作用或静电吸引之交互作用，形成具吸水性之离子团簇分散於疏水性之聚乳酸基材中。

Quality, and keeping promises" is a timeless transcendent subject, but also convinced that the strict requirements of product to customer satisfaction will only have "shure the survival and development.

重质量，守信用&是超然的永恒主题，同时也深信着对产品的严格要求只有对客户满意才会有&舒尔的生存与发展。

On basis of the analysis for cores and well-logging, the authors have thoroughly studied the sedimentary facies types and characters of Chang 6 oil-bearing formation of the Baibao region with casting thin sections, SEM, trace elements and porosity and permeability analysis and a great deal of indoor testing data. The authors propose that the sedimentary facies type of Chang 6 oil-bearing formation of the Baibao region is a sublacustrine slump turbidite fan for the first time, and lithology is lower componential and textural maturities micro-fine feldspar sandstone primarily, with graded bedding, fluidified convolute bedding, slipping-cut and deformational structures, minitype syngenetic faults, flute cast, groove cast, load cast and other turbidite sedimentary facies signatures.

作者在岩心描述和测井分析基础上，结合铸体薄片、扫描电镜、重矿物、微量元素和孔渗分析等大量测试资料，对该地区长6油层组沉积相类型及特征进行深入研究，首次提出白豹地区长6油层组属于湖底滑塌浊积扇沉积体系，岩性以成分和结构成熟度均偏低的微－细粒长石砂岩为主，具粒序层理、液化包卷层理、滑动截切和变形构造、小型同生断层、槽模、沟模和重荷模等浊积沉积相标志。

The serum selenium is first digested by microwave treatment and then chemically purified before analysis by using sulphydryl cotton. The optimum conditions were found to b as follows:(1) The sulphydryl cotton column is prewashed with 5 mol/L hydrochloric acid;(2) Se is desorbed by adding 1 mL of concentrated nitric acid and (3) the optimum amount of sulphydryl cotton is 0.14 g. This preconcentration step is required in order to remove matrix-interfering elements, such as Na, Mg, K and Ca.

采用微波消解－巯基棉分离对人血清样品进行前处理，通过对巯基棉分离血清中硒的条件优化，结果表明，柱条件为5mol/L HCl、解脱Se条件为1mL重蒸HNO3、巯基棉最佳用量为0.14g时，能够有效分离出人血清样品中的Na、Mg、K、Ca等碱金属和碱土金属，同时硒的回收率最高，达到92%以上。

The chemical adsorption model of titanite on the surface of finely calcium carbonate was established according to the properties of finely calcium carbonate and titanite and the mutual action mechanism.

硬脂酸钠、钛酸酯和铝酸酯对重质碳酸钙的改性与钛酸酯对硅灰石的改性导致改性剂在矿物表面的反应吸附，吸附以化学吸附为主，物理吸附为辅。

The crystalline phase, morphology, crystalline size and specific surface area were tokened by using thermogravimetric analysis and diferential thermalanalysis, X-ray difraction, transmission electron microscopy, infrared spectroscopy and BET.

同时运用热重/差热、X射线衍射、透射电镜、比表面吸附、红外等多种测试手段对Cu2+/TiO2光催化剂的晶型、粒子形貌、比表面积进行了表征。

The fourth part is to propose triply analyses to the question.

第四部分是对问题的三重建议分析。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。