酸化剂

The company mainly engaged in a number of products have the following series: 1, highly efficient environment-friendly metal surface treatment series: stainless steel pickling passivation cream, stainless steel pickling passivation fluid, stainless steel pickling passivation head hot paste, ultra-low carbon steel acid Passivation wash cream, stainless steel high-performance cleaning fluid, stainless steel passivation fluid, carbon steel pickling paste, pickling paste titanium, stainless steel brightener washing, descaling Wang, copper surface detergent cleaning agent, electric stainless steel polishing fluid, anti - welding slag splashing paint, universal cleaning agent, senior metals rust oil, phosphating solution, degreasing agents, rust-proof paper, waterproof moisture-proof wrapping paper series.

高效环保型金属表面处理系列：不锈钢酸洗钝化膏，不锈钢酸洗钝化液，不锈钢热压封头酸洗钝化膏，超低碳钢酸洗钝化膏，不锈钢高效清洗液，不锈钢钝化液，碳钢酸洗膏，钛合金酸洗膏，不锈钢清洗光亮剂，除垢王，铜制品表面除垢清洗剂，不锈钢电抛光液，防焊渣飞溅涂料，万能清洗剂，高级金属防锈油，磷化液，脱脂剂，防锈纸，防水防潮包装纸系列。

These changes were prevented by genistein (a protein tyrosine kinase inhibitor) and antioxidant N-acetyl-L-cysteine, but promoted by sodium orthovanadate (a protein phosphatase inhibitor), which were administered to the SD rats 20 min before ischemia.

进一步的研究表明，缺血前20 min腹腔注射给药，然后缺血30 min，发现蛋白酪氨酸激酶抑制剂染料木黄酮和抗氧化剂N-乙酰半胱氨酸能显著地抑制核内STAT3的磷酸化水平及DNA结合活性的增加(磷酸化水平从2.3和2.5倍分别降为1.2和1.4倍， DNA结合活性则从2.8和3.7倍分别降为1.1和1.5倍)，而蛋白酪氨酸磷酸酶抑制剂矾酸钠则能明显地促进他们的增高(磷酸化水平从2.0倍增到3.4倍， DNA结合活性从3.1倍增为5.1倍)。

The synthetic route starts from penicillin G, peroxyacetic acid(8.5%) as Oxidizing Agent to get penicillin G sulfoxide; esterifided with p-nitrobenzyl bromine to synthesize penicillin G sulfoxide ester; we synthesize 3-exomethylenecepham sulfoxide ester with phthalimide potassium and 4A molecular sieve as acid scavenger to open the ring, SnCl_4 as catalyzation to close the ring. The yield is over 60%.

本研究采用的合成路线为：以青霉素G钾盐为原料，选用工业过氧化氢制备的过氧乙酸(22.3%)稀释至8.5%为氧化剂，氧化得青霉素亚砜；采用对硝基溴苄为酯化试剂，制备青霉素亚砜酯；以NCP(N-氯代邻苯二甲酰亚胺)为开环试剂，酞酰亚胺钾和4A型分子筛为酸清除剂，顺利开环；再经无水SnCl_4催化闭环得3-环外亚甲基头孢亚砜酯，最终产率在60%以上。

Comparison was synthesized from undecylenic acid and iso-propyl alcohol over HPWA-SBA-15. Comparison was made among different catalysts, and influence of composition and repeated use of the catalyst were investigated.

将该催化剂用於催化以十一碳烯与异丙醇为原料合成十一碳烯酸异丙酯，进行了不同催化剂化剂的对比实验以及催化剂组成和重复使用的考察。

The rubber accelerator M contains a great deal of water after the acidifying process.

由于橡胶促进剂M在酸化后含有大量的水分，前期研究表明通过添加表面活性剂预处理可以有效降低固液分离后滤饼的含水量。

Optimal reaction conditions were as follows: PAAS and SMA at weight ratio of 4:1, stirring for emulsifying at speed of 1500 rpm and last 60 min, acidifying for 90 min, and the curing temperature under 50℃for 90 min.

优化配方及工艺条件为：聚丙烯酸钠和苯乙烯-马来酸酐按4：1混合作乳化剂，1500rpm搅拌，分散乳化60min，酸化90min，50℃固化90min作为制备二甲戊乐灵微胶囊的优化工艺条件，在此条件下可以得到平均粒径为9.6μm、粒度分布均匀、包封率在99%以上的球形微胶囊。

Acetylated starches with high degree of substitution were synthesized from cornstarch with acetic anhydride as esterifying agent and methanesulphonic acid as catalyst.

以玉米淀粉为原料，醋酸酐为酯化剂，甲烷磺酸为催化剂，制备高取代度淀粉醋酸酯。

Preparation of starch succinate with low substitution degree was studied by using corn starch as raw material,succinic anhydride as esterifying reagent,water as solvent and sodium hydroxide as catalyst.

以玉米淀粉为原料，丁二酸酐为酯化剂，以水为媒介，氢氧化钠为催化剂对低取代度淀粉丁二酸酯的制备工艺进行了研究。

By studying effects of the amount of NaOH, CS2 and dissolving water and xanthation conditions on the viscose quality, the optimal technology of viscose-making was obtained. By studying the effects of H2SO4 concentration in coagulating bath, NaOH concentration in desulfurating bath and plastifier content on the physical strength of mulch sheet, the optimal sheet forming technology was found out.

通过研究制备粘胶时NaOH用量、CS2用量、溶解用水量以及黄酸化条件对粘胶品质的影响，确定制备粘胶的最佳工艺；通过研究成膜过程中凝固浴H2SO4浓度、脱硫浴NaOH浓度、增塑剂用量等对薄膜物理强度的影响，确定了成膜的最佳工艺。

The comprehensive electroplating wastewater from a large-scale electroplating industrial area in Shenzhen has been studied. Its treatment method has been investigated. It is ascertained that acidification-oxidation decomplexation and chemical precipitation of hydroxide and sulphide process are used. The best decomplexation agent chosen is bleaching liquid NaClO. The operational parameters are as follows: dosage of bleaching liquid 1.2 mL/L wastewater, reaction pH 2.3, and reaction time 2 h. Under these conditions, the requirements of the discharge standard of electroplating wastewater can be met effectively by adjusting the pH and adding sodium sulphide, overcoming the deficiencies of traditional processes of electroplating wastewater treatment.

以深圳某大型电镀工业园产生的综合电镀废水为研究对象，对其处理方法进行了探索，确定了酸化-氧化破络反应及氢氧化物和硫化物共沉淀的处理方法；通过实验选择漂水为最佳破络剂，最佳破络操作参数为漂水用量1.2 mL/L，反应pH为2.3，反应时间2.0 h，在此基础上调节pH并加入硫化钠即可实现电镀废水的达标排放，克服了传统电镀废水处理工艺的不足。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。