酸化剂

The control group including 55 cases （60 teeth） was treated by 75% sodium fluoride glycerin.

目的：对比观察3M Adper Prompt自酸蚀粘结剂和75%氟化钠甘油糊剂治疗牙本质过敏症的临床疗效。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

Water,propylene glycol,butylene glycol,glyceryl polymethacrylate,peg-7 glyceryl cocoate,biosaccharide gum-1,phenoxyethanol,hydroxyethylcellulose,ppg-26-buteth-26,chondrus crispus,peg-40 hydrogenated castor oil,sodium hydroxide,methylparaben,benzophenone-4,disodium edta,citrus aurantium dulcisoil,sorbic acid,butylparaben,ruscus aculeatus root extract,glycyrrhiza glabraroot extract,aesculus hippocastanumseed extract,pentadecalactone,iris germanica root extract,rentinyl palmitate,tocopheryl acetate,sodium hyaluronate,citrus aurantium amaraoil,sorbitol,propylparaben,ethylparaben,limonene,linalool,yellow 5,red 4,red 33

水，丙二醇，丁二醇，甘油聚甲基丙烯酸酯，PEG-7 椰子油酸单甘酯，多醣物质，苯氧乙醇，羟乙基纤维素，PPG-26-丁醇聚醚-26，卡拉胶，PEG-40氢化蓖麻油，氢氧化钠，羟苯甲酯，二苯酮-4，乙酸乙二胺二钠，甜橙油，山梨酸，羟苯丁酯，假叶树根萃取，甘草根萃取，欧洲七叶树籽萃取，环十五内酯，鸢尾花根萃取，维他命A酯，醋酸盐维他命E ，透明质酸钠，苦橙油，山梨醇，羟苯丙酯，羟苯乙酯，柠檬精油，芳樟醇，黄5，红4，红33水：几乎所有护肤品成分第一位都是水。丁二醇：保湿剂及溶剂，质地温和

Silver nanoparticles with average particle size ranging from 2 to 131nm were manipulatively synthesized starting from silver nitrate using 10 kinds of different functional group-containing organic modifiers, such as polyvinylpyrrolidone, tween-80, sodium dodecyl sulfate, sodium polyacrylate, polyethylene glycol, D-sorbitol, sodium dodecyl sulfonate, sodium dodecylbenzene sulfonate, polyvinyl alcohol, cetyltrimethylammonium bromide, at room temperature.

摘 要：选择10种含有不同官能团的有机物为表面修饰剂，如聚乙烯吡咯烷酮、吐温-80、十二烷基硫酸钠、聚丙烯酸钠、聚乙二醇、山梨醇、十二烷基磺酸钠、聚乙烯醇、十二烷基苯磺酸钠和十六烷基三甲基溴化铵等，在室温下进行了平均粒径在2～131nm范围内纳米银颗粒的控制合成研究。

And the polycarboxylate based superplasticizer prepared by the macromer under optimal condition has good plasticizing and fluidity-retaining ability, the initial fluidity of cement paste reaches 303 mm, and the fluidity after 1 h is 297 mm.

以最佳酯化工艺制得的大单体为原料制备的聚羧酸系减水剂，具有良好的分散性和保塑性，掺该减水剂0.15%的水泥净浆的初始流动度达303mm，1h后其流动度为297mm。

To assess which Ser/Thr residue could act as a phosphate acceptor upon agonist stimulation, truncation mutants of DORs were constructed by removing the last 15 ( D 15) or 31 ( D 31) residues containing the last three or six potential phosphorylation sites from the C-terminus of the wild-type receptor.

为了研究激动剂诱导下DOR的磷酸化发生于哪一个位点，我们首先构建了C末端区缺失六个丝/苏氨酸残基及三个丝/苏氨酸残基的DOR突变体 D 31和 D 15。

Adopting condensation copolymerization between alkylphenol polyoxyethylene ether and methyl aldehyde and using concentrated sulfuric acid sulfonation, which it with sodium hydroxide neutralization, finally acquired sulphonate anionic surfactant, utilize as temperature resistance 、mineral salt tolerance for heavy oil viscosity reducer , research on the performance evaluation, the result indicate, the amount of sulphonate anionic surfactant to be used at 0.2wt%, viscosity reducer rate reached 92.1%; added with 0.5wt%, the calcium and magnesium ions resistance in mineral water up to 800mg/L.

采用辛基酚聚氧乙烯醚和甲醛的共缩聚物与浓硫酸磺化后，再用氢氧化钠中和后得到磺酸盐阴离子表面活性剂作耐温抗矿盐稠油降粘剂，并对其进行性能评价，结果表明，辛基酚聚氧乙烯醚甲醛共缩聚物磺酸盐阴离子表面活性剂加量为0.2wt%时，降粘率高达92.1%，抗钙、镁离子能力达800mg/L。

In this report, half-esterification between these pendent hydroxyl groups of hydroxyl-PU and maleic anhydride could lead to new pendent groups, carboxylic groups. These highly polar carboxylic groups in the side chain of PU could play the role of internal emulsifier. They had self-dissociation ability in the water or were neutralized first by appropriate amount of base. Then, PU bearing carboxylic group could dispersed steadily in the water, named aqueous-based polyurethane dispersion.

在本论文中，利用原来亲油性Hydroxyl PU主链段上悬挂的羟基经由与琥珀酸酐的半酯化(Half-esterification Reaction)反应后，使PU在侧链上悬挂具有强极性的羧酸基，其可作为聚胺酯分子中的内乳化剂，羧酸基能在水相中自身解离产生离子或加入适量碱使之中合，使聚氨酯高分子能够稳定分散於水中，即所谓水性PU分散液(Aqueous-based Polyurethane Dispersion)。

The esterification reaction was carried out in isooctane solvent at 50℃, with 0.15mol/L of substrate and 1:1.4 of acid-alcohol molar ratio.

研究了反应温度、溶剂、底物浓度、底物摩尔比、吸水剂用量等因素对酯化反应的影响，确定了正戊酸异戊酯的最佳合成条件为：反应温度为50℃，异辛烷为反应介质，底物浓度为0.15mol/L，酸醇摩尔比为1：1.4。

A process for making an electronic device which comprises applying a nonaqueous plate-resistant ink by ink jet printing to selected areas of a dielectric substrate, optionally laminated with an electrically conductive metal, exposing the plate resistant ink to actinic and/or particle beam radiation to effect polymerisation, adding one or more metal layers by electrolytic or electroless deposition, the upper layer of which is an etchresistant metal, removing the polymerised plate-resistant ink with alkali and finally removing the electrically conductive metal which are optionally directly laminated to the dielectric substrate and not protected by an upper layer of etch-resistant metal by chemical etching wherein the plate-resistant ink is substantially solvent-free and comprises: A 30 to 90 parts acrylate functional monomers free from acid groups comprising mono- or higher functionality wherein 5 to 95% by weight are mono-functional monomers; B 1 to 30 parts acrylate functional monomer containing one or more acid groups; C 0 to 20 parts polymer or prepolymer; D 0 to 20 parts radical initiator; E 0 to 5 parts colorant; F 0 to 5 parts surfactant; and where the ink has a viscosity of not greater than 30 cPs at 40 DEG C and all parts are by weight.

一种制备电子装置的方法，所述方法包括以下步骤：通过喷墨印刷在任选层压了一种或多种导电金属的介电底材的选定区域涂覆非水的阻沉积油墨，将所述阻沉积油墨暴露在光化辐射和/或微粒束辐射中以完成聚合，通过电解沉积或无电沉积增加一层或多层金属层，其中最上层的金属层为一种或多种阻蚀刻金属，用碱除去聚合的阻沉积油墨，最后通过化学蚀刻将任选直接层压在所述介电底材上并且不被一种或多种阻蚀刻金属的上层保护的导电金属除去，其中所述阻沉积油墨基本不含溶剂，并且包含以下组分：A30-90份不含酸基团的丙烯酸酯功能性单体，所述单体包括单官能或多官能单体，其中5-95％重量为单官能单体；B1-30份包含一个或多个酸基团的丙烯酸酯功能性单体；C0-20份聚合物或预聚物；D0-20份自由基引发剂；E0-5份着色剂；和F0-5份表面活性剂；其中所述油墨的粘度在40℃下不高于30cPs，并且所有的份数以重量计。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。