速率

This thesis analyzes different cases where the sampling rate ratio is integer, rational, and irrational, in which the emphases is the integer case.

本文对于速率变换的整数倍和分数倍不同情况进行了详细的分析，其中整数倍的速率变换是本文研究的重点。

The system used a high-speed data acquisition unit which frequency sampling reach to 20MHz, and used a CAN bus with strong anti-interference and high transmission s...

该系统采用了一套采样速率可达20MHz 的高速数据采集系统，并采用抗干扰性强、传输速率高的CAN 总线进行上下位机通信，同时该系统的上位机软件可实现在线监测数据的软件滤波处理、数据库的信息查询、数据的分析显示和监测信息的网络发布功能。

The initial scan of the flow rate in all the valves in the system will determine the % Design Flow Rate of each valve and consequently a procedure for proportional balancing.

系统内所有阀门的流动速率的最初纪录将决定每个阀门的%设计流动速率以及随后的比例平衡程序。

Results show that, under the conditions depicted in this paper, generation rates of characteristic products don't speed up with increase of samples' initial aging degrees, but are consistent with the change of bond scission rate of cellulose. When samples are in mid-end life and aged further, the generation rate decreases almost exponentially.

结果表明：在该文的试验条件下，处于老化中后期的油纸绝缘，在后期继续老化过程中特征产物的生成速率随油纸绝缘初始老化程度的增加并不呈现递增趋势，而是成近似指数递减关系，这与纤维素绝缘纸降解过程中断键速率的变化一致。

The formation of silique dehsicence susceptibility was investigated in terms of water content, synthetic rate of ethylene, enzyme activity of exo polygalacturonase and end cellulase , cell alteration in dehiscence zone in silique and silique dehiscence susceptibility during silique development.

从油菜角果发育过程中角果含水量、乙烯合成速率、外切 PG 酶和内切纤维素酶活性，以及角果裂区切片观察等方面研究了角果开裂敏感性形成的原因⒚花后50d 的角果果柄端壳状果瓣和线状果瓣间的裂区薄壁细胞膨大，在高倍光学显微镜下可见胞间空隙开始形成⒚此前6d 内乙烯合成速率迅速上升并出现第二次合成高峰，与之同步发生外切 PG酶和内切纤维素酶活性急剧上升，而乙烯合成第二高峰出现于角果含水量低于80％以下⒚由此看来，角果失水引起乙烯合成第二高峰出现，从而导致水解酶活性上升，最终导致果瓣裂区薄壁细胞膨大，分离和胞间空隙形成及角果开裂敏感性产生

Because of the speed of the film the fast and slow, and Fixatives on the amount of sodium thiosulfate join, high concentrations of fixative, fixing faster, if fixative of concentration above 45%, fixative is too strong, fotographic is not sensitive silver halide solubilies minimum, it reduces the cofficiency so that the inverse function of, say, fixing concentration is inappropriate, to weaken the effectiveness of fixative, at the same time fixing not 深透 and has a special interest.

由于胶片的不退影速率的迟慢，与不退影液洋的硫代硫酸钠参加度多少有干系，不退影液的淡度矮，不退影速率不离迟，如果不退影液的淡度超功45%，不退影液太淡之后，胶片未感光的卤化银凝固度最小，不正而贬低了凝固度，使得其不正的功用，所以说，不退影淡度把持得合适其时，不妨不收松不退影液的出力，同时不退影不不肤浅，并且有发黄的本体。

Because of the speed of the film the fast and slow, and Fixatives on the amount of sodium thiosulfate join, high concentrations of fixative, fixing faster, if fixative of concentration above 45%, fixative is too strong, original copy for non-sensitive silver halide solubilies minimum, it reduces the cofficiency so that the inverse function of, say, fixing concentration is inappropriate, to weaken the effectiveness of fixative, at the same time fixing not 深透 and has a special interest.

由于软片的不退影速率的迟慢，与不退影液洋的硫代硫酸钠参加度多少有干系，不退影液的淡度矮，不退影速率不离迟，如果不退影液的淡度超功45%，不退影液太淡之后，软片未感光的卤化银凝固度最小，不正而贬低了凝固度，使得其不正的功用，所以说，不退影淡度把持得合适其时，不妨不收松不退影液的出力，同时不退影不不肤浅，并且有发黄的本体。

One is the rate of solute diffusion, and the other one is phase equilibrium.

脱挥速率受到两个因素的影响，一是溶质传递速率的限制，一是热力学平衡条件的限制。

It isverified that the method for using little deformation condition was true with accurate solution of three-piece straightening curve.

文摘：基于三段矫直曲线应变速率的假设，通过计算三段矫直曲线的精确解，验证了使用小变形条件的正确性；考虑高温铸坯蠕变性能，对铸坯的力学行为进行了分析，得出了使用三段矫直曲线方法，铸坯应变速率、应力及应变在矫直区内变化较为平缓，可有效避免铸坯内裂纹的形成；使用本文三段矫直曲线精确解，调整辊列位置，可进行连铸机的在线技术改造。

It isverified that the method for using little deformation condition was true with accurate solution of threepiece straightening curve.

文摘：三段矫直曲线应变速率的假设，通过计算三段矫直曲线的精确解，验证了使用小变形条件的正确性；考虑高温铸坯蠕变性能，对铸坯的力学行为进行了分析，得出了使用三段矫直曲线方法，铸坯应变速率、应力及应变在矫直区内变化较为平缓，可有效避免铸坯内裂纹的形成；使用本文三段矫直曲线精确解，调整辊列位置，可进行连铸机的在线技术改造。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新