速率

The results indicate that, in either single or double blowing, larger erosion rate is mainly found in the slag line and near purging plug area of ladle lining; erosion is accelerated when gas flow rate increases; the erosion rate of ladle lining with double blowing is larger than that of single blowing; erosion rate distribution is obviously different as gas flow rate increases; in heavy blowing, serious erosion centers around slag line area and expands gradually outwards; as purging plug gets close to lining wall, malconformation of erosion rate in ladle lining becomes more prominent and the erosion rate of lining near purging plug increases.

结果表明，无论单吹还是复吹，较大的蚀损速率主要分布在钢包渣线及近透气砖区域，吹气量的增大会加速钢包内衬的蚀损。采用复吹时，钢包内衬的蚀损较单吹时更快。随着吹气参数的改变，钢包内衬蚀损速率的分布状况差异明显。大吹气量下，较大的蚀损集中在渣线区域且呈环向扩展；透气砖安装距包壁越近，钢包内衬蚀损不均衡性也越突出，近透气砖内衬蚀损加重。

Finally this paper simulates GaAs material including the average energy, velocity, and time occupation rate in different energy valley of it. And this paper simulates GaAs diode including the average energy, velocity, and the mean free path of it, and derives the thermal conductivity from the simulation result of it.

最后，使用蒙特卡罗方法模拟了GaAs材料的平均速率、平均能量以及载流子在不同能谷中的时间占有率，GaAs二极管的平均能量、平均速率以及平均自由程并推导出了其热导率。

So, a roll gyro in an aircraft in a coordinated turn with a 60 degree bank will be measure a rate of zero, same as an aircraft flying straight and level.

因此，在60度横滚角的飞机上的陀螺仪测得的横滚角速率值为零，同样在飞机做水平直线飞行时，角速率值为零。

The increase in photosynthetic rate was due to the increase in apparent leaf mesophyll conductance.

随着品种产量的增加，单叶净光合速率显著增加且与产量呈正相关，光合速率增加主要是由于品种表观叶肉导度随育成年代推延而显著增加所致。

Effect of cooling speed,stirring speed,seeds on metastable zone has been reviewed.

考察了降温速率、搅拌速率、晶种对介稳区的影响。

During 6:00-10:00 o'clock period, climbing of photosynthetic rate P(subscript n was primarily caused by photosynthetic active radiation, leaf temperature, relative humid. Descending photosynthetic rate P(subscript n from 10:00 o'clock to 14:00 o'clock, especially "middy depression" was mostly caused by stomata factor.

早晨6：00-10：00期间，光合速率的上升主要是光合有效辐射、温度和相对湿度造成的。10：00-14：00期间，光合速率的降低，尤其是"午休"期间的下降，气孔因素是主要限制因子。

Under optimal conditions, the rates at which white rot fungi mineralize lignin rival their rates of polysaccharide degradation.

在理想的条件下，白腐真菌矿化木质素的速率与降解多糖的速率相当。

A data fusion algorithm is adopted to enhance the performance of auto rate selection mechanism in IEEE 802.11 based on fuzzy system theory,and with the application of this mechanism,the misjudgement of channel state which estimated by single channel parameter is eliminated.

为了提高IEEE 802.11中速率选择机制的性能，提出了一种基于多信道参数数据融合算法的自动速率选择机制，克服了采用单一参数进行信道状态估计的误差和误判。

Studies on photosynthetic characteristics of Chinese cabbage satellite monosome, diploid or trisome;2. Characteristics of Photosynthesis in Seed Plants of Satellite Chromosome Monosome, Diploid and Trisome of Chinese Cabbage

以大白菜随体单体、三体和二倍体为试材，在自然条件下，对生殖生长期的功能叶的叶绿素含量、希尔反应活性、净光合速率、光合速率日变化、Rubisco活性等生理生化指标进行了测定，以研究同源染色体的附加和减少对光合特性的影响，为开展染色体工程育种提供参考。

Feature and use: It tests melt flow rate of high polymer under mucosity flow state.It was expressed by MFR or MVR.It suits for testing polycarbonate,FI plastic and nylon under higher melt temperature. It suits for testing polyethylene、polystyrene、polypropylene、ABS colophony and polyformaldehyde colophony under lower melt temperature.

特点及用途：熔体流动速率仪是用来测定各种高聚物在粘流状态时的熔体流动速率，在一定的温度和负荷下，熔体每10min通过标准口模的质量或体积，用MFR或MVR来表示，它既适用于熔融温度较高的聚碳酸脂、聚芳砜、氟塑料、尼龙等工程塑料，也适用于聚乙烯、聚苯乙烯、聚丙烯、ABS树脂、聚甲醛树脂等熔融温度较低的塑料测试，广泛应用于塑料生产、塑料制品、石油化工等行业及有关院校、科研单位和商检部门。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。