速度

Results showed that the grain filling rate were faster in prophase and metaphase of filling stage than anaphase, when the date of average temperature preponderate ranges 27.9℃ to 29.8℃ after heading stage 20d. But when the date of average temperature preponderate ranges 25.2℃ to 25.9℃ after heading stage 20d, the results were reverse.

结果表明：优质食用稻籽粒灌浆后20d日平均温度在27.9￣29.8℃时，籽粒灌浆前、中期速度快，后期速度慢，整精米率相对较低；籽粒灌浆后20d日平均温度在25.2￣25.9℃左右时，籽粒灌浆前、中期速度慢，后期速度快，整精米率相对较高。

The experiments showed that both rotary belt cutter and the jagged chain cutter can realize high speed cut with high ground speed, the former cut speed and operating speed can reach 17 m/s and 15 km/h separately, and the latter can reach 7 m/s and 13 km/h responsively.

试验表明，回转带式切割器和齿形链式切割器均可实现高速切割和高速作业，前者(来源：ABC55论文网www.abclunwen.com)的切割速度和作业速度分别达17m/s和15km/h，后者的切割速度和作业速度分别达7m/s和13km/h；工作平稳，割台振动小，割茬整齐，无撕裂、漏割、重割和堵刀现象；适于收割小麦、水稻等细茎秆作物和牧草。

The mean velocity distributions in turbulent boundary layers of smooth surface and two different riblet surfaces are measured with IFA300 constant-temperature anemometer in low-speed wind tunnel to validate the full development of turbulent boundary laye. Friction velocity and wall friction stress of turbulent boundary layer are obtained with the least-squares fitted curve of the sublayer velocity distribution based on Spalding formula, and virtual origin position of riblet surface can be acquired accurately.

在低速风洞中来流速度一定的情况下使用IFA300恒温热线风速仪测量了光滑表面和两种不同尺寸的脊状表面湍流边界层平均速度分布剖面，并验证了试验段湍流发展的充分性；通过应用Spalding壁面公式使用最小二乘法精准拟合了实验测量的边界层内层速度分布曲线，得到了湍流边界层壁面摩擦速度并进一步求得湍流壁面摩擦应力，较准确地计算出脊状表面的虚拟原点位置，并通过与对数律公式拟合结果比较分析，证实了该方法更加准确有效。

The coherent inversion method and rootmeansquare velocity conversion method are jointly applied to build the interval velocity model. The tomographic imaging technique is used to optimize the geologic model. Based on the research of depth migration method and comparison of migration effects, the approaches and steps for building accurate migration velocity field are summarized, thus greatly improving the effects and efficiencies of velocity modeling and migration imaging.

采用相干反演法与均方根速度转换法联合建立层速度模型，利用层析成像技术优化地质模型，通过深度偏移方法研究和偏移效果的对比，总结了建立精确偏移速度场的方法和步骤，使速度建模和偏移成像在效果和效率上都得到了很大的改善。

It was found that the slug head rose in the riser at a constant velocity in the slug formation stage.At the same time,the direction of slug tail movement was opposite to the flow direction,and the tail velocity kept constant when flowing through the inclined pipe.

结果表明：在液塞形成阶段，液塞速度随气液相折算速度的增大而线性增大；当气、液相折算速度恒定时，液塞速度随下倾管倾角的增大而稍有增大。

Semidiurnal tides spread more quickly in the south than in the north of Zhejiang seaboard. Diurnal tides spread more slowly in Zhoushan and Hangzhou gulf ocean areas, when more quickly in other ocean areas.

从潮波传播速度来看，半日潮波在浙南的传播速度大于浙北，全日潮波传播速度较小的区域主要集中在杭州湾及舟山-宁波海区，其它海区传播速度相对较大。

Through a typical Stamping example, compared and analyzed the node slip velocity curve and translational velocity curve. It proved the truth that the true loading rate simulating by Finite element software can reflect the slip velocity between sheet metal and die, providing the basis for the follow-up analysis in actual testing.

通过典型冲压成形实例，比较分析结点滑动速度和结点运动速度曲线，证明了有限元软件模拟的真实加载速度可以反映板料和模具之间的滑动速度，为后续的实际试验提供分析依据。

Once the sparger installed in the CMT, the fluid temperature above the sparger and the initial pressure of pressurizer are the key factor, which affect the condensation characteristic and temperature equilibrium time.

通过对不同初始条件下的CMT排水量进行了分析，发现CMT排水速度主要受CMT内的压力变化的影响：CMT无遮流板排水实验中所有排水量随时间的变化曲线都是单调递增的，且都有一个较为明显的拐点，在拐点后，斜率明显增大，说明排水速度增加显著；CMT加遮流板排水实验中排水量曲线的拐点不明显且出现时间较无遮流板排水实验要早，说明排水速度增加得较早；CMT加遮流板排水实验如果PRZ初始压力较大，通过改变CMT的初始温度，将会引起排水总量较大的变化；排水速度平衡时间受CMT压力平衡响应时间的影响，且较CMT压力平衡响应时间快。

He said the speed of light is much faster than that of sound.

他说光的速度比声的速度快。他说光的速度比声的速度快。

Distribution of detailed flow parameters such as liquid velocity and stream function were measured by this method.

认为反应器上升段表观气速对液相水平速度和垂直速度均有影响，其中对液相垂直速度的影响更大：表观气速增大，液相最大垂直速度一般增大，但这一变化规律并不是单调的；PIV对折流区的观测反映了该区域流场在气相通入后的最初25 s内的变化历程，流场发展的快慢与进气口的气速有关，气速越大，流场发展得越快。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。