通电

The resultsshowed that the sample"s electrical conductivity gradually increases with the temperature increasement, the entire tenderlion"s electrical conductivity is a little bit higher than mincing meat"s when the fibre was parallel to the electric field strength and the increasement in the entire tenderlion"s electrical conductivity is more than mincings at the same temperature.

利用浸泡式通电加热实验装置，研究了不同浓度NaCl溶液对肉加热速率和电导率的影响。

The direct-current type spot welder,the circular telegram time is short,the cementing stable scope is broad,the formula memory function numerical code control spot welding power source,the single plane can correspond many kinds of weldings.

直流点焊机，通电时间短，溶接稳定范围广，各式记忆功能数码控制点焊电源，单机能对应多种材料焊接。

Don't walk on the live rail.

不要在通电的铁轨上行走。

Electrician Cheng checks and accept a standard: Switch of leakage of electricity is installed it is correct, normal to use; The installation of electric parts of an apparatus, equipment is secured should firm, level off; Experiment of electric equipment electrify, lamps and lanterns tries bright reach lamps and lanterns to control function good; The exterior of parts of an apparatus such as box of switch, electrical outlet, terminal is in good condition, insulation parts of an apparatus is flawless, installation is firm, smooth, installation means accords with a regulation; The switch of paratactic installation, electrical outlet the deviation of terminal box, the clearance of periphery of the face plate of box of dark outfit switch, electrical outlet, terminal, box accords with a regulation; Authority of function of weak cable system is complete, satisfy use requirement, implemental installation is firm, smooth.

电气工程验收标准：漏电开关安装正确、使用正常；电气器件、设备的安装固定应牢固、平整；电器通电试验、灯具试亮及灯具控制性能良好；开关、插座、终端盒等器件外观完好，绝缘器件无裂纹，安装牢固、平正，安装方式符合规定；并列安装的开关、插座终端盒的偏差，暗装开关、插座、终端盒的面板、盒周边的间隙符合规定；弱电系统功能权齐全，满足使用要求，器具安装牢固、平正。

The driver has a switch interlocked with driving operation of the ice pan. The switch is turned on/off through engaging/disengaging of contacts which engage normally when ices are made while stopping operation of the driver.

驱动装置5具有与制冰盘2的驱动相联动的开关，该开关结构是利用接点的接合和脱离进行通电／断电切换，在驱动装置5的动作停止状态下进行制冰的期间，接点始终接合。

The reliability test shall be done with the touch panel put on a flat board, and with the circuit open.

1触摸屏的信赖性测试应放置在平板上，在非通电状态下进行。

By means of coordinate transformation, the part of stresses in the expression of stress field caused by temperature at the moment of application of transient current on the plate with a side-crack was separated and expressed in polar coordinate.

采用坐标变换的方式，将单边裂纹载流薄板通电瞬间由温度产生的应力场表达式中的各应力分量分离，并用极坐标进行表示。

Electrohydraulic valve and the electromagnetic valve 8 is not energized, electrohydraulic valve in the vent of the Netherlands, electromagnetic valve to vent the Netherlands are also in a state of the main pump oil output by 21 to radiator tank.

电液换向阀9和电磁溢流阀8不通电时，电液换向阀处于中位泄荷，电磁溢流阀也处于泄荷状态，主油泵3输出的油经散热器21回油箱。

Electro-hydraulic valve and electromagnetic relief valve is not energized, the electro-hydraulic valve leakage in the medium load, electromagnetic relief valve is also in charge state of discharge, the main oil pump output back through the radiator tank.

电液换向阀和电磁溢流阀不通电时，电液换向阀处于中位泄荷，电磁溢流阀也处于泄荷状态，主油泵输出的油经散热器的回油箱。

Our company specializes in producing tungsten argon arc welding machine dedicated article, spot welding power tungsten, the molybdenum wire lamp foot, high-temperature molybdenum wire, various specifications of tungsten, molybdenum wire material, tungsten cutter silk, vacuum plating coils, cerium tungsten rod, electrode, contact materials (AC contactor contacts, etc.).

本公司专业生产氩弧焊机专用钨条，点焊机通电钨条，钼丝灯脚，高温钼丝，各种规格的钨，钼丝材料，钨绞丝，真空喷镀线圈，铈钨杆，电极，触点材料。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。