退火的

Because harden steel be difficult to machine. but when anneal , It can be easily machine .

因为淬火后的钢很难进行加工，但退火后则很容易加工。

In such anodes, after they underwent a final anneal in air at 450℃ for 60 min Figs.

在这种阳极里，他们经过在450度下60分钟的最终退火处理，见图表1a-1c。

The effect of extrusion and anneal on mechanical properties and damping capacity of Mg-0.6Zr alloy was studied.

研究了挤压及退火对Mg-0.6Zr系合金力学性能及阻尼行为的影响。

This type of anneal, the steel is heated slightly above its critical range and then cooled very slowly.

对于这种退火，钢材被加热到稍高于它的临界温度范围，然后缓慢冷却。

When anneal temperature reach to 280 ℃, tensile strength and elongation obviously change, anisotropy increase with increasing temperature.

当退火温度达到280℃时，随温度的升高，抗拉强度和延伸率显著变化，各向异性增长。

For this type of anneal, the steel is heated slightly above its critical range and then cooled very slowly.

对于这种退火，钢材被加热到稍高于它的临界温度范围，然后缓慢冷却。

The influence of anneal temperature, thickness and voltage on the ferroelectric were investigated in the end.

对PZT薄膜进行了铁电性能测试，研究了退火温度、薄膜厚度及外加电压对铁电性能的影响。

The best annealing temperature is 280~350℃.

退火处理的最佳温度为280~350℃。

Simulated annealing, the neural network a good information !!!!!!!!!

模拟退火法，神经网络的好资料！！！！！！！！！

On the base of analysis mentioned above,simulated Annealing Algorithm is used to optimize the codes.

在上述分析的基础上，通过模拟退火算法优化对编码进行组合优化。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。