迭代过程

In image processing, method as follows will be introduced in this paper: a method combining image threshold iterative segmentation with threshold interpolation, edge detection operator Sobel and LoG, edge linking method using delation operator based on mathematical morphology, using boundary tracking and projection method in edge distill process. Through this method, measurement of wheelset will be met precision demand.

本文阐明了图像的分通道自动采集过程，以及对采集到的原始图像进行预处理过程，达到图像去噪声的目标，本课题采用了阈值分割中迭代阈值和阈值插值相结合的方法，Sobel算子、LoG算子边缘检测算法，基于数学形态学的膨胀运算子进行边缘断点连接以及目标提取中的投影法和边缘跟踪方法，使得提取轮对图像边缘达到测量精度的要求。

On the basis of dual porosity theory,the well test interpretation model which considers the variation of krg versus the volume of liquid is also established and resolved by the implicit method numerically.

摘要通过分析凝析气藏的相图，建立了凝析液饱和度随压力降的变化规律，并回归得出了相应的公式；同时通过对气体压缩因子、黏度随压力、温度的变化，建立了这些参数和无因次压力的关系；在双重介质地层假设的基础上，建立了在试井过程中凝析气相对渗透率随凝析液饱和度变化的凝析气藏试井解释数学模型，采用隐式迭代的方法进行了求解并进行了参数敏感性分析；结果表明：凝析液的饱和度对凝析气藏试井的压力及压力导数曲线有着很大的影响，早期由于凝析液的析出，阻碍了气藏的流动，导致压力及压力导数曲线上升；在凝析液饱和度达到峰值之后，随着凝析液的挥发，凝析气的相对渗透率逐渐恢复，压力及压力导数曲线又回归到正常的径向流位置；由于裂缝和基岩之间的压力差，使得裂缝弹性储容比在测试过程中发生变化，进而影响了压力及压力导数；窜流系数和裂缝弹性储容比的变化决定了窜流段发生的早晚和程度；而基岩中气体黏度的变化使得窜流的发生稍微滞后。

According to theory analysis and example computation, the following conclusions are obtained.1. During the analysis on the cable shape in the suspension bridge"s completion state, the pre-displacement of saddle and the case that the cable and stiff girder commonly bear the second-stage dead load should be considered.2. When supposing the construction ideal initial state in the first time, if the initial state model is established according the cable"s span central sag in the bridge"s completion state, and the reasonable correction formulation is created in the iteration process, the result can converges fast.3. The cable shape in the bridge"s completion state is not parabolic, nor catenary. It is between parabola and catenary. Actually it is funicular polygon closer to the catenary.

通过理论分析和实例的计算表明：1在悬索桥主缆成桥线形分析过程中，须考虑主塔鞍座的偏位以及二期恒载由主缆和加劲梁共同承担的实际情况；2在第一次假设施工理想初态时，以成桥状态已知的主缆跨中垂度建立施工理想初态模型，同时在迭代计算的过程中，建立合理的修正公式，才能使收敛的速度快：3在成桥状态时主缆的线形既不是抛物线，也不是悬链线，而是介于抛物线与悬链线之间，更接近于悬链线的索多边形。

This paper will deduce a group of new equations from general gas flow equation and Colebrook-White friction factor expression.

将气体流动基本方程与Colebrook White 摩擦阻力公式相结合推导出新的公式，大大简化了气体流动基本方程原来需要多次试算、迭代的计算过程，并且推导过程未加任何假设。

The method of iteration is adopted for the whole development procedure.

在开发方法上，引进RUP思想，即将整个开发过程分为需求分析、概要设计、详细设计、系统实现、测试五个步骤，整个开发过程采用迭代的方式。

The new model is the same as that of traditional distillation process in expression style, and it is solved by an algorithm which combines the relaxation method with the modified Newton Raphson method.

引入变换变量的概念，将发生平衡反应的反应精馏过程模型变换为普通精馏过程模型，减少了迭代变量，避免了反应量的计算，并易于采用普通精馏的计算方法。

But it is multifarious iterative process.

可是，往往这是一个很繁的过程，也是一个迭代的过程。

In steady-state optimizing of industrial processes, iterative learning control is suggested to improve dynamic performance of transient response.

在工业过程稳态优化进程中，为了进一步改善工业过程的动态品质，提出了迭代学习控制策略。

The non-structure grid is used for complex irregular boundary processing. An efficient algorithm PISO is used for the model and it can correct the bias of the mesh, so it can reduce iterative times. The flow pattern, energy dissipation ratio and velocity field are obtained.

根据不同的运行工况，利用计算流体力学软件FLUENT对无压隧洞洞内消能工的水流流态进行了二维简化数学模型的数值模拟，在求解过程中采用混合结构网格来处理复杂的边界形状；采用了效率较高PISO算法进行计算，在计算过程中进行了相邻校正和偏斜校正，减少了达到收敛所需的迭代次数。

Then the process is iterated when a need is generated in the implementation process.

然后，这个过程是迭代时，需要在实施过程中产生的。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。