迭代的

In contrast to conventional optimization algorithms whose iterates are computed and analyzed deterministically, randomized methods rely on stochastic processes and random number/vector generation as part of the algorithm and/or its analysis.

传统的最佳化演算法中迭代的计算和分析是确定的，与之相比，随机方法依靠随机过程和乱数字/向量的生成作为演算法和演算法分析的一部分。

In contrast to conventional optimization algorithms whose iterates are computed and analyzed deterministically, randomized methods rely on stochastic processes and random number/ vector generation as part of the algorithm and/ or its analysis.

传统的最优化算法中迭代的计算和分析是确定的，与之相比，随机方法依靠随机过程和随机数字/量的生成作为算法和法分析的一部分。

This method can be applied in large resistivity contrast area. This is very important in metal mine area.

通过对Born迭代的改进，本文中提出的成像算法可以适用于电阻率变化剧烈的地区，这对在金属矿地区的应用是十分重要的。

A kind of finite element analyzing software "ANSYS" is used to calculate the temperature field of cable system; Finally, Subtense truncation approach is used to calculate the ampacity of cable system with equal load.

根据地下直埋电缆的温度场特性，将开域场转化为四个边分别符合第一、二和三类边界条件的四边形有界热场问题，然后利用有限元法计算场域内的温度场分布，最后用迭代的方法确定电力电缆的载流量。

If the target list is a comma-separated list of targets: The object must be an iterable with the same number of items as there are targets in the target list, and the items are assigned, from left to right, to the corresponding targets.

如果target list是一组用逗号分隔的目标，该对象必须是可迭代的，并且其子项个数与target list中的目标个数相同。这个对象的子项从左到右地逐个赋予对应target。

They are solved iteratively to approach the solution of joint optimization problem.The simulation results show tha...

实验证明，在给定传输总功率的情况下，与传统的等功率分配相比这种迭代的优化方案可以获得较高的系统性能优势。

In contrast to conventional optimization algorithms whose iterates are computed and analyzed deterministically, randomized methods rely on stochastic processes and random number/vector generation as part of the algorithm and/or its analysis.

传统的最优化算法中迭代的计算和分析是确定的，与之相比，随机方法依靠随机过程和随机数字/向量的生成作为算法和算法分析的一部分。

Power optimization of amplify-and-forward relay aided OFDM communication system is discussed in this paper.

讨论了AF型中继辅助OFDM通信系统中的功率优化方案，并针对最优的功率优化方案很难得到闭合解的问题，提出了一种迭代的功率优化算法。

This new method mainly comprises three steps: firstly, normalize the point-gradient vectors and calculate the block-gradient vectors and the corresponding block-coherence; then detect the noisy areas to eliminate the side effect of noise diffusing; finally, re-estimate all block- gradient vectors based on iteration and transform the gradient field to orientation field.

提出了一种基于梯度的健壮的指纹方向场估计算法，新算法首先归一化点梯度向量并计算块梯度向量及相应的块一致性；然后估计噪声区域；最后采用基于迭代的方法，重新估计所有块梯度向量并将梯度向量场转化为方向场。

The flow stress was repeated by calculated using the "single factor" flow stress formula, the metal machining process was simulated interatively with new flow stress. When simulating value was in good consistent with experimental result, the "three-high" data and flow stress data were obtained.

由&单因素&流动应力公式反复计算与模拟应变率对应的流动应力，基于新的流动应力有限元模拟迭代的进行并追求模拟值与实验结果的一致，获取能反映切削材料力学性能的&三高&数据和流动应力数据。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。