连杆

Specialize in various of standard machine parts, like bolt, nut, screw, connecting rod shaft, bearing, lifter, piston,engine parts, automobile parts and so on.

专业生产各种标准件，如：螺栓，螺母，螺钉，连杆，轴承，挺杆，活塞，发动机配件，汽车配件等，欢迎广大客户及新老朋友洽谈合作。

Unlike typical in-line-four engine design, where the two outer and two inner pistons move together in pairs with 180°intervals, the crossplane crankshaft has each connecting rod 90° from the next with a unique firing order of 270°–180°– 90°– 180°.

与典型的线路四个发动机的设计，而这两个外部和两个内部活塞此举对一起与180 °的间隔，曲轴的crossplane了每个连杆90 °从明年了一个独特的发射命令的270 °-180 °-9 0°- 18 0°。

This paper discusses the existing conditions of planar five bar linkages with double cranks .

对平面五连杆机构曲柄存在条件进行了探讨，并提出了机构类型的判别方法。

Resorting to the Roberts-Chebyshev theorem,we replace the two cranks of a crank-rocker cognate mechanism with a double bar,which is required to satisfy certain geometrical and motion conditions,and we change the mechanism thus reformed into a geared five-bar mechanism so that one of its links can fully rotate with the link connected with it.

借助于Roberts-Chebyshev定理，将曲柄摇杆轨迹同源机构的两曲柄分别用一双杆组代替，并要求双杆组满足一定的几何尺寸条件和运动条件，使变形后的机构为齿轮五杆机构，且满足机构的一个连架杆以及与其相连的连杆能够整周转动。

This paper discusses the methods for treating the connecting rod by finite element analysis.

通过大量的数值试验，对连杆有限元分析的边界条件的处理方法进行了探讨。

The use of boring machine can be better to complete the processing of the small connecting rod.

利用金刚镗床可以较好的完成小连杆的加工。

The connecting rod must be very strong and rigid and also as light as possible.

连杆必须具有足够的强度和刚度，并且要尽可能轻。

So we can analyse the force for the connecting rod accurately on the whole to meet the need.

有限元法给连杆的结构分析提供了一种可靠的理论计算方法。

Finally,a series of conclusions significant to the finite element analysis for the connecting rod are given.

文中给出了连杆有限元分析的一系列结论。

This method can not evaluate the reliability of a connecting rod fully.

这种方法不能完整、有效地评价整个连杆的安全性。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。