连杆

This paper presents comparisons of four technologies casting,die forging, PM forging and routine PM processing.

简要介绍并比较了用于制备汽车连杆的铸造、模锻、粉末锻造和常规粉末冶金工艺。

Operation is conveniently and quickly,and die cutting plate will not deform.

采用连杆机构垂直提拔，方便迅速，模板不变形。

The dog-leg cam, figure plate and slide block are used to realize radial multiple core pulling on the mould, and that gear-rack mechanism or connecting bar mechanism is not adopted, so that the die casting mould is simplified.

该模具利用异形弯销、转盘及滑块完成多型芯径向抽芯，而未采用一般的齿轮一齿条机构或连杆机构，简化了模具结构。

Opposite to assembling, take out one end of the two side connecting rods, move the front legs forward, and let the drill tower lay down.

同安装相反，卸下两侧连杆一端，将钻塔前支腿前移慢慢地放倒钻塔。

There are 8 oil cylinders providing clamp force for the metal plate in the driving section.

驱动段膜片夹紧力是由8个油缸及其二级连杆增力机构来完成。

The analysis provide a possibility for the optimization both of the connecting rod and engine performance.

因此，连杆的可靠性分析一直是发动机设计和改进过程中的一个重要组成部分。

Companies to raise funds to advance into automotive engine connecting rod production line technological transformation projects, and so on.

公司前期募集的资金拟投入汽车发动机连杆生产线技术改造等项目。

Has good lubrication properties, so that fuel injection pump, engine block and connecting rod to reduce the wear rate, and enhance life.

具有较好的润滑性能，使喷油泵、发动机缸体和连杆的磨损率降低，增强使用寿命。

It also shows that the simulation method introduced here can offer a new efficient and convenient way for the mechanism choosing and optimized design of crank-connecting rod mechanism in engine.

仿真结果的分析表明，仿真结果与发动机的实际工作状况基本一致，文章介绍的仿真方法为曲柄连杆机构的选型、优化设计提供了一种新思路。

Because oil is liquid and can not be compressed in combustion chamber, the engine piston rod was forced to bend and damaged to the 3 pieces.

由于石油是液体，不能在燃烧室被压缩，引擎活塞连杆被迫弯曲和断裂成3件。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新