连接

Multistory steel frames are more and more widely used in our country and bolted end-plate connection s are often adopted.

实际工程中运用的全部连接都处在完全刚性和理想铰接两种情况之间，端板连接更是典型的半刚性连接。

We study the recursive structure of the twisted-cube connected network sufficiently, and prove that the twisted-cube connected network is an n regular graph with connectivity n: point out that the twisted-cube connected network is a cube-free network, which is an essential distinction with the hypercube and other variations of the hypercube; prove that the diameter of n dimensional twisted-cube connected network is [ (n+1)/2] , which is almost the half of hypercube's.

首先对其结构的递归性进行充分地研究，证明它是连通度为n的n正则图；指出扭立方体连接网络无立方体子图，这是扭立方体连接网络与超立方体及其其它变种的本质差别；证明了n维扭立方体连接网络的直径为[（n+1）/2]，它几乎是超立方体直径的一半；最后，给出超立方体及其变种的等价定义，并对它们的结构递归性、网络参数和拓扑性质等作了简单的分析、综合和比较。

Friendship join is too little, next I look for familiar friend and him to make connection, leave the high ground of the station PR of others alone, as long as it is normal website, can exchange join with him.

友情连接太少，然后我就去找熟悉的朋友和他做连接，别管别人的站PR的高底，只要是正规的网站，都可以和他交换连接。

At present, the printer through the parallel port, USB interface to connect with the computer, which can support USB interface for maximum speed of around 12Mbps Print speed, parallel port can be the maximum print speed of around 1Mbps only, so if the network printer to support the USB interface connector, then , we should allow it to interface with the computer through the USB connection.

目前打印机可以通过并口、USB接口来与电脑连接，其中USB接口可以支持最大速度为12Mbps左右的打印速率，并口所能达到的最大打印速率只有1Mbps左右，因此如果网络打印机支持USB接口连接的话，我们就应该让它通过USB接口与计算机连接。

The paper holds the idea that, parallel bus can;t adapt to high-speed transfers due to self-limitations, and high-speed serial point-to-point bus will substitute for traditional parallel bus; data transfer will not be carried out simply by drive circuit and parallel bus, but by special high-speed serial bus; the traditional mode of single bus loading multi-device is disappearing, and a centralized switch module is replacing the bus function in a mode of one switch module connecting all devices via high-speed point to point serial bus.

文章认为并行总线由于自身缺陷，已经不适合进行高速传输，高速串行点对点连接将代替传统的并行接口；数据交换也不再是简单地通过驱动电路和并行数据线进行，而是通过特殊的串行高速总线连接；传统的在一条总线上同时挂载多个设备的模式正逐渐消亡，总线功能已被一个集中式的交换模块取代，而交换模块和各个设备都是通过高速串行点对点的方式进行连接。

Still have the thing in if do not use Phobos warehouse,having, with respect to mistake of meeting occurrence join, I used operation of array join ~, it is relevant join symbol was not found it seems that.

还有就有如果不使用phobos库中的东西，就会出现连接错误，我使用了数组连接~运算，似乎是相关的连接符号没有找到。

Joining of ceramics and ceramic matrix composites by using preceramic polymer s is a novel technique with lower cost and higher joining strength.

用陶瓷先驱体有机聚合物连接陶瓷及陶瓷基复合材料是一种成本低廉、工艺新颖、可满足特殊高温条件下连接件要求的新型连接技术。

The factors influencing on press fit load in assembly were analyzed by the FEM numerical simulation,and the press fit load ,static torque and fatigue torsional strength were experimentally verified.

本文阐述了装配式凸轮轴的技术优势，介绍了装配式凸轮轴的滚花连接机理，采用数值模拟的方法对影响滚花连接压装力的各种因素进行了分析，并完成滚花连接压装实验、静扭强度和疲劳强度试验。

Adjacent joint edges (3, 4) of two panels (1, 2) engage each other to provide a first mechanical connection locking the joint edges (3, 4) in a first direction (D1) perpendicular to the principal plane of the panels.

两块镶板（1，2）的相邻连接棱边（3，4）相互啮合，以提供一个第一机械连接，从而在垂直于镶板基本平面的第一方向（D1）锁紧连接棱边（3，4）。

The strip (6) has an upwardly protruding locking element (8) engaging in a locking groove (14) in the rear side (16) of the other joint edge (4) to form a second mechanical connection locking the panels (1, 2) in a second direction (D2) parallel to the principal plane of the panels and at right angles to the joint.

簧片（6）具有一个向上凸出并能与另一连接棱边（4）的背面（16）上的锁定槽（14）啮合的锁定件（8），以便形成第二机械连接，在平行于镶板基本平面并与连接棱边成一直角的镶板第二方面（D2锁紧(1，2)。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。