进行试验

We carry on a processing to the oil extraction waste water, instead in return to affusion, then not only will they satisfy the affusion of water which increase increasingly in the process of the extraction of the oil-field, but also can save the water resources and reduce pollution of the environment, bring an economic performance for the oil-field, its advantageous to the oil-field can keep on a development.

试验后水质明显改善，符合辛一站的水质标准。本论文的实验研究工作在胜利油田辛一站进行，首先分析了辛一站的采油废水的性质，用悬浮污泥过滤法简称SSF和超滤膜过滤法2种方法，分别进行了辛一站采油废水处理试验。

Research on water hammer characteristics of air valves Research on water hammer characteristics of air valves has been studied in experiments by establishing mathematical model of the air valve, using suitable method of numerical calculation, and comparing the experimental outcomes with theoretical analysis.

空气阀特性研究试验研究了作为水锤防护装置的空气阀的特性，建立了空气阀数学模型，通过合适的计算方法进行数值计算，并与试验进行了比较。

In order to prove the reliability, test studies have been primarily carried out in the indoor soil bin. The data of the vehicle driving state parameters under the same or different terrain are analyzed. The process curves are compared by different control schemes. The theoretical model of the optimum driving state is reliable and fuzzy control scheme is feasible. The disturbances and unknown factors of control system are analyzed. Test results prove that the half-tracked air-cushion vehicle can drive steadily under control of the computer. At the same time the sensors used to measure soil mechanics characteristics on line need to be developed. And it is the important problem to be solved in the future study. The necessary regulation and correction are put up. So the studies in this paper provide some instruction for the further research work.

为了验证本文提出的最佳工作状态及最佳垫压理论，并分析控制系统的可靠性和稳定性，本文在半履带式气垫车的模型车上，在室内土槽中进行了初步的实车性能和理论验证试验，考察了在同种和不同土壤条件下气垫车的行驶状态参数的测量数据，比较了采用不同控制方法下的过程曲线，验证了最佳工作状态的理论模型和模糊控制系统方案的可行性与可靠性，从而保证了采用自整定模糊PID控制器能够使半履带式气垫车在稳定行驶最佳工作状态下；同时通过试验研究，分析了系统中各干扰与未知因素，对控制方案进行了相应的调整和修正，为今后进一步的研究工作提供了一定的指导。

This thesis combined the riverbed section and plane form, from the two side of hydraulic computation and model test, put forward the method to realized the automatic computation for river closure gap hydraulic parameters and comparison and verification. And through carrying on the secondary development to AutoCAD, realized the common software of automation drawing the topographical section of model test. Based on hydraulics computation technology, finished developing the common application software for one berm-dam vertical closure hydraulic computation.

本文结合河床断面与平面形状，从水力计算与模型试验两个角度出发，提出了实现龙口水力参数计算自动化并进行验证比较的方法；并且通过对AutoCAD进行二次开发，实现了模型试验地形断面绘制自动化的通用软件；同时以水力学计算方法为基础，完成了隧洞导流条件下单戗堤立堵截流水力计算通用应用软件的开发。

The measurement results of the bridge load testing experiment were heavily influenced by the field environment. Based on the field test results of strain which were affected by simulated outside temperature, it was proposed that the compressed enameled wire could replace the traditional rubberized wire and shielded cable in bridge load testing experiments. This was supported by abundant data collected from the in-situ measurements and the results of these measurements were positive. As bridge-arm lead in the electrical resistance strain testing system, the compressed enameled wire was more stable than the rubberized wire.

摘 要：桥梁荷载试验现场测试环境的变化，对测量结果影响较大，在试验模拟室外温度变化对现场应变结果测量影响研究的基础上，提出采用高强漆包线替代传统的胶质电线、屏蔽电缆应用到桥梁荷载试验中，并进行了多个工程实例，通过大量实测的数据说明高强漆包线替代传统的胶质电线、屏蔽电缆应用到桥梁荷载试验中是可行的，测试效果是明显的。

The seal test Test the stem and the valve cover seal sealing performance of the test, Deputy Shell Test Such as the valve body and valve cover is made of the valve housing connected to the pressure test.

上密封试验检验阀杆与阀盖密封副密封性能的试验壳体试验对阀体和阀盖等联结而成的整个阀门外壳进行的压力试验。

Methods: Acute toxicity test, micronucleus test of born marrow in mice, ames test, sperm shape abnormality and thirty-day feeding test in rats were conducted in this study.

采用急性毒性试验、小鼠骨髓细胞微核试验、Ames试验、小鼠精子畸形试验和大鼠30d喂养试验进行检测。

The handling stability is analyzed, mainly the steering transient response test of steering wheel step input、 the steering transient response test of steering wheel angle pulse input、 return-ability test、 steady static circular test and central steering test are carried out. With those test, how the front suspension system can influence the handling and stability performance is investigated.

在此基础上进一步建立了整车模型，包括前悬架系统、后悬架系统、转向系统、前轮胎系统、后轮胎系统、车身系统，分析了该车的操纵稳定性，主要进行了稳态回转试验、转向盘角阶跃输入、转向盘角脉冲输入、转向回正试验、转向盘中间位置转向试验，并通过这些试验来考察了前悬架对操纵稳定性的影响。

Experiments were carried out to verify the static model. Experimental results show that the experimental curve matched well with the simulated curve, and there was certain error between them (maximal static error is 0.035 rad). The error cause was analyzed. Then the experiments were carried out to measure the dynamic performances of the side-sway joint. Experimental results show that the step response time of the joint was about 2 s steady value's tolerance zone ?

完成了侧摆关节静态特性试验，试验结果与仿真曲线基本吻合，验证了静态模型的正确性，但存在一定误差（最大静态误差为0.035 rad），分析了误差原因；对侧摆关节进行了动态特性试验，试验结果表明对于不同的期望值角度阶跃信号，侧摆关节开环阶跃响应时间大约是2 s

The results showed that the effects of nutrition level on average daily gain,feed conversion rate and meat quality had no significant difference;on fatback thickness and ham percent were significant.Composite selection index was used to evaluate the effect of nutrition level on finishing pigs,the results showed that the effect of high nutrition level on crossed finishing pigs was the best during body weight of 35~100 kg. Nutritional level ; Finishing pigs ; Growth performance ; Carcass quality ; Meat quality ; Comprehensive selection index

本试验将日粮消化能、蛋白质和赖氨酸设计高、中、低三个档次，以杜洛克公猪与莱芜猪合成系母猪配套生产的杂交猪为对象，进行了饲养试验和屠宰试验，旨在探讨日粮营养水平对杜莱杂交商品猪的生长性能及肉品质的影响，为养猪生产提供参考。1材料与方法1.1试验猪选择与分组选择出生日龄基本一致、生长发育良好、体重35 kg左右的杜莱断奶仔

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。