进行试验

Multiple trials is the basic concept of many parallel simulated annealing. It is to perform multiple trials at the same time to search acceptable solutions. The division simulated annealing with no communication and The clustering simulated annealing are two common types of parallel simulated annealing methods. The division simulated annealing with no communication makes each processor generate its own adjacent solution from its own current solution and compute the acceptance probability for a adjacent solution. Each of the processors searches solutions without communicating each other. Clustering simulated annealing makes each processor generate its own adjacent solution from a common current solution and compute the acceptance probability for each adjacent solution. Then, it decides which adjacent solution should be used to replace current solution according to a pre-specified rule.

许多平行模拟退火法之理论依据为多向试验，利用同一时间探索更多方向的试验来拓展搜寻的广度或深度，不进行沟通的分工模拟退火法(the division simulated annealing with no communication)以及丛集模拟退火法(the clustering simulated annealing)皆为平行化的模拟退火法，前者定义为各个处理器针对各自的起始解进行搜寻，产生各自的搜寻序列，在搜寻过程中处理器不进行任何沟通，各处理器仅针对自身之目前解进行搜寻；而后者定义为让所有处理器针对同一目前解进行运算搜寻各自的可能解，并各自决定其产出解之接受机率，最后根据事先决定之规则进行沟通比较，挑选其中一个可接受解取代目前解。

Selected the best cultivate condition by cultivated on four different media under different conditions; Observated morphology perperties; Studied on biology perperties by germ tube testing, Carbohydrate fermentation testing, Tween testing and Esculin dissociation; lysis testing.

选择四种不同的培养基分别在不同温度条件下培养，选出最优培养条件；通过光学显微镜、电子显微镜观察菌落及菌体的形态学特点；通过芽管试验、碳水化合物发酵试验、碳水化合物同化试验、沙堡培养基生长试验、过氧化氢酶试验、七叶苷分解试验、吐温试验研究该菌的生理、生化学特征；应用PCR技术通过特异性的引物扩增得到菌属特异性的片段，最后测定扩增片段的核苷酸序列，从而进行菌种的分析、鉴定。

Existing literature on the inquiry,collation and analysis,this article had the following major tasks:1st,finite element simulation of the current analytical methods are summarized,and system introduction finite element software ADINA and ANSYS applied in the reinforced concrete built-up section.2nd,system introduction reinforced concrete component material performance as well as reinforced concrete nonlinear analysis main mathematical model. 3rd,the use of ANSYS and ADINA software simply supported beam simulation were compared.4th,uses the ANSYS analysis software,conducted 7 radical center bearing reinforcing steel-side steel pipe concrete short stump simulation test research,the research had indicated the reinforcing steel the existence strengthened the pillar ductility greatly.5th,based on ANSYS,has conducted 2 radical center bearing reinforcing steel-side steel pipe concrete member in bending simulation test research.

通过对现有文献的查询、整理及分析，本文进行了以下主要工作：1、对目前有限元模拟分析方法进行了总结，并系统的介绍了有限元软件ADINA和ANSYS在钢筋混凝土组合结构中应用。2、系统的介绍了钢筋混凝土构件的材料性能以及钢筋混凝土非线性分析的主要数学模型。3、利用ANSYS和ADINA软件对简支梁进行了对比模拟分析。4、利用ANSYS分析软件，进行了7根轴心受压钢骨-方钢管混凝土短柱的模拟试验研究，研究表明钢骨的存在大大加强了柱子的延性。5、利用ANSYS分析软件，进行了2根轴心受压钢骨-方钢管混凝土受弯构件的模拟试验研究。

The predictions are performed on the test results obtained by the previous compression tests and published in the literature by Zhan and Ng (2006), which include the swelling tests under constant net stresses, isotropic compression tests and triaxial shear tests under constant suctions. The comparisons between measured and predicted results indicate that the model can quantitatively predict the hydraulic and mechanical behaviour of unsaturated expansive soils.

利用本模型对本论文中膨润土与砂混合物的吸湿试验及常吸力下的压缩试验结果进行了预测，还对詹良通和吴宏伟(2006)进行的吸力控制的非饱和膨胀土三轴试验结果进行了预测，预测结果表明本模型能够定量的统一的描述膨胀性非饱和土的水力特性和力学性质。

Frigon was chosen as the experimental, According the quality of the heavy oil materials which have high oil content and low sericin content, technical conditions were initially set at the level of low pH value 、low temperature and enforced presoaking process. And then, these surfactants and builders were chosen to test in the presoaking and refining process, getting some kinds of surfactants with lowest oil content on refined waste silk. Following that, they were tested for best oil-removing effect in mixture.

实验中，选择了滞头原料为试验原料，根据绢纺愿料冶胶量低，含油量高的特点，初步确定了低pH值、低温和加强预浸的工艺方案，然后对所选的各类表面活性剂和助剂进行了预浸、精练工艺试验，从中选出较好的几个品种进行不同类型的复配试验，在复配的基础上试验工艺条件—温度、时间、碱用量对残油率、残胶率的影响确定小样最佳工艺。

The analysis show that the project target of detaining the coarse and discharging the fine can be got with the related measures,such as placement of the warping sluice on the concave bank of a bending reach;arrangement of the overflow weir on a bending reach and reasonable zoning and scientific control of the desilting channels etc.

试验工程从规划到设计乃至试验和原型调度，始终围绕这个目标进行，整个过程包含了很高的科技含量。黄河水利科学研究院配合连伯滩放淤试验工程进行大量试验研究工作

We analyzed and discussed the characteristics of cycle of carbon and water,and after having obtained important physiological parameters based on field experiment,a process-based, multilayer two-leaf model which calculates energy and material cycle separately for sunlit and shaded leaves was developed,then characteristic of CO_2 fluxes above the canopy was simulated.The main results are as follows:1.Characteristics of carbon and water cycle in the relationship of leaf photosynthesis -stomatal conductance-transpiration.

本研究以冬小麦为研究对象，利用LI-6400R光合—蒸腾测量系统、LI-6400-09土壤呼吸室和禹城生态试验站涡度相关系统等高精度仪器设备，对2007年和2008年小麦拔节至乳熟期间涉及碳、水循环过程的叶片光合—蒸腾作用、土壤呼吸作用及相关农田气象要素和植被特征进行了野外试验测定和分析，在试验观测基础上提取了重要生理参数，建立了基于过程的农田与大气间物质输送和能量交换的多层—双叶模型，并对2008年试验期间冠层上方碳通量特征进行了模拟，试验分析和模拟的主要结论如下：1。

On the basis of the former researches and taking into account the practice of our country, this paper take the low period repeat loading experiment for three rigid conjunction node of steel beam and concrete wall, researching their load-bearing capacity and earthquake resistance performance under the low period repeat loading action, the main content concentrate on the following aspects:(1) Analyzing the three joint's damage shape、hysteretic curve、change of rigidity、yielding load、limit load、damage load、durability、energy dissipation capacity、the strain of the key position and the moment transferring mechanism.(2) Comparing the joint's load-bearing capacity and earthquake resistance performance among the joints with different stud bolt diameter and different connection plate thickness, researching some factor's influence on the work performance of the joint such as the high and strong stud bolt specification、connection plate thickness .

本文在前人研究的基础上，结合我国的实际情况，对3个钢梁-混凝土墙刚接节点试件进行了低周反复荷载试验，对其在低周反复荷载作用下的承载力和抗震性能进行了研究，内容主要集中在以下几个方面：(1)对3个节点试件在低周反复荷载作用下的破坏形态、滞回曲线特性、刚度变化、屈服荷载、极限荷载、破坏荷载、延性性能、耗能能力、关键部位的应变分布情况及节点核心区的受力情况进行了试验研究和理论分析；(2)比较了不同螺栓规格和不同连接板厚度的节点试件的承载力和抗震性能，研究了高强螺栓规格和连接板厚度这2个因素对节点工作性能的影响；(3)介绍了光纤光栅传感技术在土木工程领域中的应用研究现状及其基本原理；并通过对比试验，探讨了光纤光栅传感器用于土木工程检测的可行性及实现途径。

Two types of single-ply materials, polyester cord reinforced rubber composite and rayon cord reinforced rubber composite, are firstly studied. The essential fatigue properties and rules under cyclic loading are obtained The fatigue mechanism was analysed in terms of fatigue life curve. This part of work lays foundation for catching the experiment information, analyzing the experimental results, confirming the influence factors and explaining the experimental phenomena.

作为试验基础，首先对聚酯帘线和人造丝帘线增强的橡胶复合材料单层板的疲劳进行研究，获得了橡胶复合材料在循环载荷下基本的疲劳特性和规律，并结合疲劳寿命图对疲劳损伤机理进行了分析，在试验信息获取、试验结果分析、影响因素确定、试验现象解释等方面为橡胶复合材料的疲劳研究奠定了基础。

A three dimensional Navier Stokes equation is solved with a standard k ε turbulent model. Two experiments were carried out and the total pressure of jet flow was tested. Based on the tests, the differences between the calculated and test results were found to be 3% and 7% respectively. It proved that the results of calculation can well be used in engin...

研究采用数值计算和试验测量相结合的方法，控制方程为三维、雷诺平均 Navier- Stokes方程及 k-ε二方程的紊流模型，并且对该发动机进行了燃气流场的测试，对流场中的总压强进行了直接测量，进行了两次试验；在两次测点位置，试验结果与数值计算值相差分别为 3%和 7%；证明了对双喷管火箭燃气射流流场的数值计算具有了较好的精度，计算模拟结果可以用于工程设计中

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。