进行实验

The experimental method was improved, by using a ball to press the sclera samples, which were obtained nine months after surgery. The pretesting, relaxing and creeping experiments were carried out.

改进实验方法，采用球面致压拉伸巩膜的实验方法，对术后9月组上述5种兔眼巩膜试件进行预拉伸、应力松弛、蠕变的生物力学实验研究。

The property of mechanical erosion for different refectories at room temperature has been studied through experiment.

在金属电沉积过程中，通过装置的电流随沉积时间的变化情况，从分形维数的角度对实验获得的金属铜、金属锌电沉积产物形貌与电解实验所使用的电解液浓度、外加电压以及实验温度等条件的相互关系进行了研究。

According to the experimental abundant data the semi-empirical formula for consumed power of the absorber was established by regressing analysis.

设计了合适的实验方案并依此进行了实验，根据实验采集的大量数据经回归分析得到了计算旋转床吸收器功率消耗的半经验公式。

Secondly some explores on experiment and theory were studied, and the experimental results tallied with the theory well.

其次做了一些实验和理论探索，并根据实验结果进行了详细的计算，实验结果与理论符合较好。

Following, a experiment has been carried out, the incident waves with a frequency band of 200kHz-3 50kHz are used to the experiment, and a series of peak value-time curves are drawn each 10kHz, corresponding time are found through fitting peak value, thus the position of the defect is calculated accurately. The application of awl-shaped sensor head in the heat change water pipe experiment indicates that the ultrasonic guided waves may transmit nearly 50 meters in the pipe, which is not influenced by the elbows and makes it possible to test defects in long distance and large-scale. The water-load pipe experiment indicates that the displace and energy maybe leakage at the near-surface, which is significant for the further research.

而后，采用200kHz至350kHz频段的入射波进行了实验验证，并每隔10kHz绘出一条峰值一时间的曲线，通过拟合峰值点，找到对应的时间，从而准确的计算出了缺陷的所在；应用锥形探头的热交换水管的实验表明，超声导波可以在管道中传播了近50米的距离，且不受弯头的影响，从而使得长范围、大规模检测成为可能，水载管实验说明了离面位移和能量可能会发生泄漏的特性，为导波的深入研究和应用作了铺垫。

An improved UKF method is proposed and applied to the nonlinear initial alignment of SINS on the stationary base. Simulation results illustrate that the given method has a better performance in the estimation of the azimuth error than the EKF, traditional UKF and scaled SSUKF does. Based on the dynamic error equations of SINS, the mathematics model of the IMU/GPS integrated navigation system is derived for Kalman filtering.

此外，论文还分析和研究了捷联惯性导航系统的力学方程编排和惯性仪表的误差，建立了IMU/GPS组合导航系统的状态方程和量测方程，设计和开发了用于机载SAR运动补偿的组合导航实验系统，并对设计的组合系统进行了大量的静态实验和车载实验。

According to the test result,we determined the mixing ratio s of bottom base layer(float-dense type) and bottom layer(skeleton-dense type),based on which,we determined further the cement consumption of bottom base layer and base layer respectively according to the optimal water content and standard density of samples.

对水泥碎石基层的集料进行了筛分等各种实验，根据实验结果，确定了底基层为悬浮—密实型、基层为骨架—密实型的配合比，在此基础上根据试样的最佳含水量及标准密度确定了底基层、基层的水泥剂量，通过室内、外实验检测，取得预期效果。

The standard workpiece of the ring compression test by Lee and Altan will be used in this report. The specimen will first annealed to eliminate the internal stress and then through different ways of machining to produce different roughness of surface and different direction of machining marks. The ring compression test with various lubricants and dry friction were carried out at room temperature. The experiment results were drawn on the diagram of friction factor developed by Lee and Altan to compare the influence of the roughness of surface to plastic forming with or without lubricants.

实验将依Lee and Altan压环试验所用之标准压环试片进行，实验试片先经退火处理消除内应力，再将试片以各种不同之加工方式制作成具有不同的表面粗糙度，与不同刀痕方向之摩擦面，再於常温环境下实施乾摩擦与添加不同润滑剂之压环试验，将实验结果所得之数据绘制於Lee and Altan之定剪摩擦系数图中，以比较其不同表面粗糙度对塑性成形之影响，同时也说明在各种不同表面粗糙度下添加各种润滑剂对成形之影响。

The results show that the friction factor is decreasing with the vibration parameters, and increasing with the feedrate.

通过仿真和实验证明了新模型的正确，将钻削平均力的实验值和新振动钻削力模型和单切削力模型的理论值进行对比，证明了新钻削力模型更接近实验值，能反映钻削过程的真实情况。

This program can be used to obtain the true and high-resolved spectra by means of techniques of inverse Fourier convolution and nonlinear least squares fitting.

论文工作主要由三部分组成，一是编制了用于光谱数据和光谱图象处理以及等离子体参数诊断的程序包—ESDAP，为精密实验数据分析提供了可靠手段和得力工具；二是对X射线激光增益介质的物理特性和规律进行了实验研究；三是在对X射线激光增益介质研究的基础上，依据现有的实验条件，主要通过靶设计探索了提高复合泵浦X射线激光增益的新途径。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。