进行实验

It is found that using iron pipe for magnetic screen in Bartlett s experiment is unreasonable,and therefore their experimental conclusion is questionable.

简单地回顾了单极感应现象的历史现状，详细地分析了被认为是判定性的Bartlett等人的单极感应实验，发现该实验使用铁管进行磁屏蔽是不合理的，指出其实验结论是值得怀疑的，并给出可能的改进方法。

The concordance between the observation phenomena of metalloid alloy and the experimental results of metal alloy is discussed in detail, and the resolving degree of problem unable to be overcome in actual solidification experiment is analyzed.

介绍了用于研究凝固过程的实时观察法的发展情况，同时综述了目前用于实时观察法研究的合金类型和现有的实验仪器和装置，分类探讨了类金属合金实时观测现象与金属合金实验结果的吻合程度，和对实际凝固实验中无法克服的困难的解决情况，并对国内外的发展情况和存在问题进行了分析和讨论。

Based on field work in fourteen typical ore districts of China, the author made experiments on contact metasomatism of ultrabasic-acid intrusive rocks with carbonate rocks, interaction between volcanic pneumatolyto-hydrothermal solution and volcanic rocks, and metasomatism in the process of sedimentary metamorphism and migmatizatiun.

本文作者在全国14个典型矿区的野外工作基础上，进行了超基性-酸性侵入岩与碳酸盐岩的接触交代实验；火山气热液与火山岩的相互交代实验；区域沉积变质和混合岩化过程中的交代作用实验。

This article , having studied experiments on saccharose inversion with sodium bisulphate as catalyzer , discovers that sodium bisulphate is more appropriate than muriatic acid for experiments on saccharose inversion .

以硫酸氢钠为催化剂，对蔗糖转化反应实验进行了研究，实验结果表明：用硫酸氢钠代替盐酸做蔗糖转化实验效果更好。

The effects of equilibrium time,acidity of the solution,temperature,concentration of redox reagents on the adsorption of neptunium by silica gel were carried out.

进行了吸附平衡时间、酸度、温度、氧化还原剂浓度等条件对硝酸溶液中Np、Np和Np在硅胶上吸附的影响的实验，与吸附时同酸度条件下的洗脱实验，用浓度为3mol／L的硝酸作为解吸剂的解吸实验。

However, there is no requirement for balcony in the present building fire design code and the building designers put no consideration on the fire-prevent function of the balcony.

在建筑火灾的研究中，根据相似理论建立对应模型进行模拟研究是很有用的，其优点是没有实际现场实验的高额费用，还可以根据要求灵活地改变实验参数，并能够容易地获得较高精确度的理论实验结果。

As an important part of the current work, great effort has been made in the experiment It is shown by mass of experimental results that the vehicle with ECC is placidity when it is starting-up and changing-gear, and the longitudinal comfortability and security are achieved anticipant.

实验研究是本项研究的重点工作之一，本文的所有实验均在Santana LX型轿车上实车进行，大量实验结果表明，装有电控离合器的车辆起步和换档平稳，纵向舒适性和安全性均达到要求，该系统开发是成功的。

This study I would adopt the plan law of experiment, which will assess to important parameters including O3, H2O2, pH and response time.

本实验将采实验计划法，针对O3、H2O2、pH及反应时间等重要参数进行评估，利用统计手法整理实验数据，以期达到较客观之最佳运转条件。

Firstly, full factorial experiment method is implemented to achieve an optimization of longitudinal microstructure design in the incidence plane of a LGP for LED BLUs. There are three control factors involving in the optimization process: the pitch and depth of both V-cut and U-cut, and angle and radius for V-cut and U-cut, respectively. Each individual control factor has three levels. It leads to a total of 27 sets of experiments.

本实验先行讨论全因子实验求取发光二极体背光模组之导光板入光侧纵沟微结构最佳化设计，选定入光侧V-cut纵沟微结构控制因子：V-cut角、V-cut间距、V-cut深及入光侧U-cut纵沟微结构控制因子：U-cut半径、U-cut间距、U-cut深等项目，其中各一因子分别有三个水准变化，依控制因子及其水准的目各进行27组实验。

Finally, the best values of the diameter of prefabricate hole and extrusion speed is determined through optimize simulation results,In the end, forming experiments study of cold extrusion is processed, experiments results shows that internal thread of C195 knuckle axis can be formed by cold extrusion method, and the extrusion torque is varied when diameter of prefabricate hole and extrusion speed is a series of different value.

最后对挂钩轴内螺纹的加工进行了一系列的实验研究，经过多次实验的失败反复，最终挤压加工出了符合要求的内螺纹；实验结果表明该零件内螺纹时可以采用冷挤压成形方法加工的，并且验证了成形过程中挤压扭矩是随着工件底孔直径和挤压速度的变化而变化的。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。