进行中的

I think when it comes to Britain and China we can co-operate carefully together in our policing and other systems.

在这个问题上，我认为英中可以进行谨慎的合作，并且和其余系统进行配合。

We use sharping processing, binary processing, smoothing processing to separate the face from the background, and then we use Integration projection to realizes the precise location of the face.

在人脸的自动识别算法中，本系统对定位后的人脸图像做了几何标准化和灰度标准化操作，采用KL变换进行降维处理，提取出人脸图像矢量，与样本库中的特征样本进行匹配，选取最为匹配的人脸图像作为输出。

The primary factors influencing the concentration of sodium hydroxide titrating solution were confirmed.

笔者对1mol/L NaOH溶液标定过程中的测量不确定度进行了分析和评定，对同种类型实验进行不

The results showed that the evaporative condenser is superior to the traditional water-cooling condenser both in energy consumption and original investment.

对蒸发式冷凝器和水冷式冷凝器从结构和能耗上进行了对比，通过举例分别对同一冷库中的两种冷凝器进行计算。

2 Vertical furnaces in the carbonization workshop, this paper makes transformation on some components such as the roller axle, and safety pin , etc.

针对炭化车间1号、2号直立炉原设计的一些机械部件中存在的缺陷，对直立炉机械排焦过程中的辊轮轴和保险销等部件进行改造，同时对垃圾门也进行了改造。

In this thesis, the influence of column force, joint hoop reinforcement, and repeat load on the stress and sheer bearing capability of inclined pressure bar is analyzed utilizing finite element software. In the case study, the column axial force's influence on the inclined pressure bar's equivalent width, stress and sheer bearing capability of RCFEN is obtained by changing the column force when modeling the RCFEN with ANSYS. In the former model, the joint hoop reinforcement influence on the equivalent width inclined pressure bar and the strength of RCFEN is achieved by changing the quantity of joint hoop reinforcement; the inclined pressure bar's equivalent width and the strength variation of RCFEN under cyclic load are gained by applying low frequency cyclic load on the inflection point of column and the middle of beam.

针对上述算例中的框架外节点采用ANSYS进行建模，运用有限元软件分析了柱轴力、节点箍筋、反复荷载对外节点斜压杆承载力、抗剪承载力的影响：改变柱轴力，研究了柱轴力对斜压杆的等效宽度、框架外节点斜压杆承载力、框架外节点斜压杆抗剪承载力的影响；在上述模型中，改变节点箍筋的数量，分析了节点箍筋对斜压杆的等效宽度、框架外节点强度的影响；在上述模型中，在柱反弯点和梁中点均进行低周反复加载，讨论了在反复荷载作用下，框架外节点的斜压杆的等效宽度、框架外节点强度的变化情况。

At last, on the basis of the constitution and work principle of brake staff, using friction tester as a testing platform, temperature measure device for the brake pad is developed, and the test data are analyzed.

本文首先对制动器和刹车片进行了简单介绍，然后从传热学的理论出发，分析了刹车片制动过程中热量产生机理，并用有限元法对刹车片的温度场进行了简单分析，最后在对制动器的结构和工作原理进行分析的基础上，运用摩擦试验机作为试验平台，研制出刹车片的温度测量装置，并对测量结果进行了分析。

In the paper, a tenon-base is added under the base of the retaining wall, on the study of the choice of the parameters and formulas used in calculation and the research of theory used in calculation, method used to deal with the load, etc, the writer gives a way to crack the nut mentioned above paragraphs and presents a qualitative and quantitative analysis about them, such as the equivalent inner friction-angle and the passive press of the clay, etc.

本文在对仰斜式挡土墙设计中有关计算参数的选择、公式的选用应该注意的问题进行了研究，对河道护岸软基础上的仰斜式挡土墙采用凸榫基础处理的方法，就其计算理论、设计验算中各荷载的具体处理方法进行了较为细致的研究，提出了解决软基础上的水工仰斜式挡土墙难以解决的难题的方法，并对有水情况下粘土等效内摩擦角Ψ_D、凸榫被动土压力E_p等在计算中的取值提出了定性和定量的分析。

This paper tries to control the coal dust by dyna-wave dust removing technology and to study the technical feasibility and adaptability of removing flying dust in coal mine by dyna-wave washer .

对煤矿逸散性煤尘采用动力波除尘技术进行试验研究，证实动力波洗涤器对煤矿生产过程中逸散性煤尘进行治理的技术可行性和适应性。

Resistance to 10 antimicrobials other than ampicillin was evaluated by determining the susceptibility of coliforms in fecal samples by using the disc diffusion method and quantifying the blaTEM genes in fecal samples by quantitative PCR.

对排泄物中的大肠杆菌用十种其他的抗生素进行药敏试验评估，用定量PCR 的方法对排泄物样品中的TEM基因进行定量。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。