进料量

The experiment acquired pressure distribution and circulating rate under three fluidizing velocity (3.5m/s、4.5m/s、5.5m/s) and different media load. An experimental equation was acquired between circulating rate and the distribution of the pressure. And the relation between the circulating rate and the opening rate of the valve connecting the returner and the EHE was carefully discussed as well as the relation between the pressure of the EHE and the flow rate of the fluidizing air.

得到三种流化风速下（3.5m/s、4.5m/s、5.5m/s）不同装料量所对应的主床床体压力分布和物料循环量，得到循环量与压力的分布和流化风速的本实验台上的经验公式，并通过测量返料器通向外置换热器机械阀开度和返料量的关系，得到旋风分离器中下落物料进入换热器和直接进入主床的比例关系，同时测得换热器中压力和送风量的关系。

The simulation of drawing process is realized. The measurement of edge contraction and distribution of the thickness in a tryout piece is carried out and compared with the simulation results.

完成了该覆盖件的拉延工艺成形模拟，测量了试模时该覆盖件的拉延工序件的边缘进料量和厚度，并与模拟结果进行了比较。

The results showed that flow rate of feed, steam pressure, rotation speed are the major controllable factors. Results of the eighteen groups of experiments based on L18(21×37) orthogonal array indicated that the significance of influence is in the order of rotation speed＞steam pressure＞feed flow .

本研究选用进料量、蒸气压力、转速，作为田口法的控制因子，并以薄膜蒸发器蒸发率作为品质特性，应用田口法L18(21×37)直交表规划18组实验，所得结果再以田口方法及全因子实验法找出最佳化操作条件，并实际应用於某光电厂。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。