运行

Through the experimental research of main operating parameters of a dual air register burner boiler, which have an effect on combustion, the authors have identified the variation relationship between boiler economic performance and such factors as oxygen content, primary air flow rate, various damper openness of the burners, and coal pulverizer feed rate, etc.

通过对双调风燃烧器锅炉影响燃烧的主要运行参数的试验研究，分析得出了氧量、一次风量、燃烧器各挡板开度、磨煤机给煤量等主要燃烧参数对锅炉经济性的影响规律，并对这些参数进行优化选择，使锅炉的运行经济性得到了明显提高。

According to the characteristics of the coal management system of power plant, Proposed an intelligent decision system which realize coal categorized warehouse storage of power plant and an online coal blending optimization model suitable for plant operation.

针对电厂燃煤管理系统的运行特点，提出了一种电站燃煤分类分仓储存的智能决策系统和一种适合电厂运行的在线优化配煤模型。

Optimization of coke height control index of coker tower,decrease of circulating ratio ,revamp for perfection of the plant,and shortening coke formation period of coker tower,etc.

介绍中国石化镇海炼化分公司Ⅱ焦化装置投产后，通过采取一系列优化装置运行水平的措施：优化焦炭塔焦高控制指标、降低循环比、对装置进行完善改造、缩短焦炭塔生焦周期等，使装置处理量由设计值125 t/h提高至152t/h，能耗由设计值28.67 kg/t下降至23.2 kg/t左右，装置运行水平明显提高。

The results show that the mill current and particle filling increased with the coal feed flow when ventilation rate remained the same, mill current started to decline after rising to a peak, the beginning of the decline region corresponded to the optimal particle filling, at this point, the gap between balls were just full of coal particles, the mill was running close to maximum power, and grinding efficiency reached the highest.

研究结果表明，磨煤机通风量不变时，随着给煤量增加，磨内存煤量增加，磨煤机电流升高，电流上升到峰值后又有所下降，开始下降的区域对应的料位是最佳运行料位，此时，钢球间隙中刚好充满了煤粉颗粒，磨煤机接近最大功率运行，粉碎效率达到最高。

With the fast development of industry and environmental protection, higher requirements are is needed to its further innovation, design and installation, For example, how to confirm effects of interior structures Deformation on characteristic of cyclone separator which is working is a new project.

随着工业和环保要求的不断提高，对旋风分离器的改进和设计以及安装运行都提出了新的课题，例如，如何确定在生产运行过程中内部结构变形对旋风分离器的分离性能影响就是新课题之一。

Fans and pumps are the mechanical properties of square torque characteristics, pump run-time,* the opening of the valve regulating the flow to meet water supply requirements, working conditions and the fan is similar to,* adjusting damper, duct or valve opening tailgate degrees to adjust the blower air volume, pumps flow methods, known as cutting regulation, regulation on cost-cutting process, the fan or pump the inherent characteristics of the same, only * small throttle clearance, baffle or valve opening, artificially increase line resistance, which increases the loss of pipeline system is not conducive to fan, pump energy-saving operation.

风机和水泵的机械特性均为平方转矩特性，水泵运行时，*阀门的开度调节流量来满足供水要求，工况与风机相似，*调节风门、风道档板或阀门的开度来调节风机风量，水泵流量的方法、称为节流调节，在节流调节过程中，风机或水泵固有特性不变、仅仅*关小风门、挡板或阀门的开度，人为地增加管路的阻力，由此增大管路系统的损失，不利于风机，水泵的节能运行。

The system performance simulation includes starting and breaking characteristics and steady-state characteristics, the results validate the rationality of the model. On above basis, the fault-operation performance of the system is simulated to demonstrate the phase redundancy speciality of multi-phase motor ;then the effect on performance of synchronous motor from damper winding is analyzed to indicate the its significance.

系统性能仿真主要包括系统起动性能，突变特性(突加负载，升频，降频等)，稳态运行性能仿真，仿真结果验证了所建立模型的合理性，在此基础上，对系统故障运行进行仿真，表明了系统相冗余特性；且分析了阻尼绕组在同步电机中的作用，说明了阻尼绕组的必要性与重要性。

Under the conditions of normal and closed operation, the effects of the absorption water flow on the absorption characteristics of rotating packed bed and the performance of a closed cycle diesel engine were analyzed.

在闭式循环柴油机开式运行和闭式运行时，通过改变超重力旋转床的水流量，对吸收器的吸收特性及其闭式循环柴油机性能的影响进行了分析。

However, the generator may be disconnected from the grid in case of a disturbance such as a voltage dip even a grid fault.

然而在运行过程中，由于各种原因引起的电网电压波动、跌落甚至短路故障会影响发电机的不间断运行。

Problems porduced in the application of manipulator for dipping EPC patterns into coating have been introcuced with effective solutions that an optimal route of manipulator in the space has been designed in accordance with technology requirement of dynamic dipping and mode parameter and machine instruction have been obtained by method of teaching and programming.Hence the whole dipping process being finished by motion of manipulator via controllet.

介绍了机械手在消失模铸造模样浸涂应用中出观的一些常见问题，并提供了行之有效的解决办法结合消失模铸造模样动态浸涂的工艺要求，设计出机械手在空间运行的最佳轨迹，运用示教和编程技法获得机械手运行的模态参数和机器指令，经由控制器驱动机械手抓取消失模模样并完成浸涂涂料的全过程。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。