过饱和的

Are you searching for work in a waning industry or oversaturated field?

你是在一个"夕阳产业"或"过饱和"的领域中求职吗？

The addition of Re slightly decreased the formation temperature of MC carbides and promoted the precipitation of μ phase from the oversaturated γ matrix.

Re不进入MC碳化物，Re的加入可降低MC形成温度并促进μ相从MC周围过饱和的γ基体中析出，进而诱发MC不稳定分解。

Effect of recovery methods after thawing After thawing, the highest viability was obtained when beads of Pavlova viridis were incubated in culture medium for 48h in darkness at room temperature. As to other two algae,the suitable recovery method was to incubate beads over saturated NaCl solution in a closed jar for 12h in darkness at room temperature.

化冻后恢复方法的影响化冻后，绿色巴夫藻的胶球在培养基中室温下暗放置48h后存活率最高；另两种金藻在含有过饱和的NaCl溶液(75%RH)的密闭气相中室温下暗放置12h存活率最高。

Precipitation of calcium phosphates in saliva is inhibited by an acidic phosphoprotein, statherin, which contains 43 residues.

人体的唾液是一种过饱和的磷酸钙溶液，可以给与牙齿很好的保护，但同时也容易在牙齿的珐琅质表面产生沉淀。

In this paper, the undercutting rate of silicon tips are improved by adding supersaturated iodine and KI in KOH solution.

通过在KOH溶液中添加过饱和的碘单质(I2)，显著减小了快腐蚀面的削角速率，在较小的掩膜下腐蚀出高的硅尖。

The phase made up of iron-carbon with a body-centered tetragonal structure is called martensite.

铁和碳以碳在体心立方晶格中过饱和的方式组成的相称之为马氏体。

The microsturcture of ZE series alloys was composed of fine dentritic or equiaxial α-Mg solid solution and interdendritic Mg-Zn-RE phase formed by divorced eutectic reaction.

研究表明， ZE 系合金的铸态组织细小，由树枝状和等轴状过饱和的α-Mg 固溶体以及分布在晶间连接成网状的 Mg-Zn-RE 三元中间相组成。

The laser-cladding layeron the alloy consists of matrix phase of over-saturation solid solution γ and complexhexagonal carbide M_7C_3. Under certain condition, with fast laser scanning speed, the oversaturation solubility of elements increases in γ, and the precipitation of the complexcarbide M_7C_3 decreases, so that the microhardness increases and the wear resistance de-creases. But at slower laser scanning speed, more complex carbide M_7C_3 may precipitate, andthe wear resistance may be improved. Therefore, it is believed that the principal factor in im-provement over wear resistance is the precipitation of carbide M_7C_3, while overmicrohardness is the over-saturation solubility of elements in matrix phase.

表明：(1)激光熔覆合金层是由过饱和的γ基体相和复杂的六方M_7C_3碳化物相所组成(2)在其他参数不变的情况下，随激光扫描速度的提高，γ基体相过饱和度增大，而析出的碳化物含量减少，因而合金层的硬度升高，耐磨性有所下降；而降低激光的扫描速度，碳化物M_7C_3析出增加，有利于提高合金层的耐磨性、因此碳化物M_7C_3析出量是提高耐磨性的主要因素，而增加基体相γ的过饱和度则是硬度提高的主要因素

The results indicated that with solution time increasing,Mg_(17)Al_(12) phase was dissolved into the Mg matrix and Al_2Ca phase became thinner and shorter,then gradually broken and began to spheroidize;with aging time increasing,Mg_(17)Al_(12) phase was precipitated from the Mg matrix as the form of small particles and Al_2Ca phase was stable and its shape and quantity change...

随着时效时间的增加，Mg17Al12相以细粒状从过饱和的镁基体中析出；而Al2Ca相比较稳定，其数量和形状变化极小。固溶处理后，合金硬度和拉伸强度有所下降；时效处理后，合金硬度增加到峰值后下降，拉伸强度略有升高。固溶、时效处理后轧制AM50和AM50+1Ca镁合金的塑性有所增加；而轧制AM50+2Ca镁合金固溶后塑性有所增加，时效后塑性有所下降。

This paper mainly described the pertinent knowledge about the generalization of gas supersaturation, the reasons and factors for gas supersaturation. Furthermore, the relations among life stage, hydrostatic pressure, temperature, intermittent exposure, detection, avoidance and the tolerance of fish to supersaturation were analyzed, AndKey words: dam; dissolved gas supersaturation; gas buhhle disease

本文主要就气体过饱和及气泡病做了具体描述，首先叙述了气体过饱和的研究概况、导致气体过饱和的原因和水温、压强等影响气体过饱和的因素，具体分析了鱼类不同生活阶段、液静压、温度、间歇性的暴露、探知和躲避能力导致其对气体过饱和忍耐大小的状况，并对气泡病的内部损伤如血液中形成的气栓、外部症状如身体各个部位形成的气泡做了具体的描述。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失