过电压

Of special interest are the effects that gain importance at high voltage levels, eg, the so-called very fast transients that occur when operating a disconnector.

设计中需要特别注意一个问题，即那些随电压等级提高而变得明显的效应，例如在操作隔离开关时出现的所谓快速暂态过电压。

However, when the switch to ground closes, Q1 functions as a nonsaturated transistor with high gain.

在这种模式下，Topswitch集成电路敏感过电压和欠电压的极限。

In this mode, the Topswitch IC senses the undervoltage and overvoltage thresholds.

在这种模式下，Topswitch集成电路敏感过电压和欠电压的极限。

Case study for regulating both the overvoltage and undervoltage cases is demonstrated by means of prototype experiment to prove its performance and effectiveness.

最后再以实验证明所提出之架构在过电压与欠电压的情况下，能有相当好的性能与效率。

The proposed idea can be used to regulate both the overvoltage and undervoltage situations with only uni-directional energy transmission control.

这个控制策略是操作在单方向的功率传输下，且可调整过电压与欠电压两种状态。

After the research it is held that when internal fault takes place in the transmission line where the series compensation device is located, the corresponding protective measures, e.g., the forced triggering the by-pass gap, etc., is the effective approach to avoid the appearance of excessing level of transient recovery voltageand oversize coupling current.

文章结合我国南方电网河池固定串补及平果可控串补工程，对超高压输电线路装设串联电容补偿装置后的系统状况进行了比较深入的研究，指出一些系统问题，如过电压水平升高、潜供电流增大和可能发生的次同步谐振均源于串联电容补偿装置的固有特性，通过研究认为当串补所在输电线路发生内部故障时，采取强制触发旁路间隙等保护措施，是避免出现系统恢复电压水平超标和潜供电流增大等问题的有效途径。

Based on the characteristics of varistor, the influence of the different impedance values between the protective devices is discussed.

结合浪涌保护器的电压—电流特性，利用推导出的公式研究由压敏电阻组成的多级保护系统，分析两保护器之间的阻抗变化对暂态过电压在两级保护器上分配的影响。

The frequency changer Surpasses the voltage fail safe is the frequencychanger middle DC voltage after achieved the degree of hazard adoptsprotective measures, this is a big flaw which the frequency changerdesigns, causes this breakdown reason in the frequency changer actualmovement many, may adopt the measure are also more, when processesthis kind of breakdown must analyze the clear breakdown reason, haspointed takes the corresponding measure to process.

变频器过电压故障保护是变频器中间直流电压达到危险程度后采取的保护措施，这是变频器设计上的一大缺陷，在变频器实际运行中引起此故障的原因较多，可以采取的措施也较多，在处理此类故障时要分析清楚故障原因，有针对性的采取相应的措施去处理。

The frequency changer Surpasses the voltage fail safe is the frequencychanger middle DC voltage after achieved the degree of hazard adoptsprotective measures, this is a big flaw which the frequency changerdesigns, causes this breakdown reason in the frequency changer actualmovement many, may adopt the measure are also more, when processesthis kind of breakdown must analyze the clear breakdown reason, haspointed takes the corresponding measure to process.

摘 要：摘要变频器过电压故障保护是变频器中间直流电压达到危险程度后采取的保护措施，这是变频器设计上的一大缺陷，在变频器实际运行中引起此故障的原因较多，可以采取的措施也较多，在处理此类故障时要分析清楚故障原因，有针对性的采取相应的措施去处理。关键词变频器电动机整流 Abstract ：The frequenc。。

Three methods of judging gap Spark-over at power frequency spark-over test on the three phase combinative surge protector of TBP type were analyzed,namely change of indication on ammeter A1,A2 or operation of current relay.

通过对TBP系列三相组合式过电压保护器的工频放电试验，分析了三种判断间隙击穿放电的方法，即电流表A1指示是否有变化；电流表A2指示是否有变化；或电流继电器是否动作及其对放电电压值的影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。