过热的

An application study for superheated steam temperature control system is carried out.

将其应用于火电机组过热汽温控制进行仿真研究，结果表明所提出的预测控制算法具有优良的控制性能和很好的鲁棒性。

A computer simulation of the superheated steam temperature control system has demonstrated that the optimized fuzzy controller has a satisfactory control effect.

针对过热汽温控制系统进行的计算机仿真表明，优化后的模糊控制器具有良好的控制效果。

Chimneys are made of lead, iron, manganese, and zinc sulfides, through which spew superheated ocean water.

烟囱的制造是由铅，铁，锰，锌的硫化物，通过该还会过热海洋的水。

In this paper,the structure of steam superheater (A BA701) lining,its installation method and points for attention during installation are introduced in detail.

本文详细地介绍了某厂蒸汽过热器( A— BA70 1 )衬里的结构、施工方法及施工中的注意事项，对结构相同或相似衬里的施工有着指导意义。

The results show that the undissolved silicon particles in the melt become the cores of primary silicon precipitated in solidification and there is a close relationship between the shape of primary silicon and undissolved silicon particles. The growth of silicon follows not only the twin plane re-entrant edge mechanism, but also layer mechanism as well. Meanwhile, the shape of primary silicon also relies on kinetic surroundings, such as the transmitting of solute. At higher overheating temperature, the shape of primary silicon becomes the star-shape and tree-shape.

结果表明：重熔过程中熔体中未溶解的硅相粒子，在凝固过程中可成为初生硅生长核心，并且未熔颗粒与初生硅形状之间存在明显对应关系；初生硅的生长机制不是惟一的，既可以以孪晶凹角机制生长，还可以以层状机制生长，初生硅最终形状还要取决于溶质传输等动力学环境；随着熔体过热温度的升高，凝固组织中初生硅形状由多边形向星形及树枝状转变。

If you insist on worrying about the global economy, better to get riled up about a Chinese economy showing signs of overheating, North Korea's missile-happy regime, or a killer asteroid careering toward the planet unbeknownst to us all.

如果说仍难以消除对全球经济的担忧，就应将更多注意力转向中国经济发展中出现的经济过热迹象、朝鲜的导弹威胁以及其他无法预知因素。

The system can monitor on line operation state of the boiler system, including overall monitor of the boiler system, major monitor of boiler, run tending monitor, bar figure display and overrange alarm.

故障诊断根据锅炉运行状态监测情况，确定锅炉系统运行中出现的故障征兆，采用深、浅知识相结合的混合诊断推理机制，分析诊断锅炉系统在运行过程中可能出现的各种故障，如炉膛灭火，过热器爆管，省煤器磨损、泄漏，空气预热器积灰、泄漏，锅炉满水、缺水等常见故障。

A separated model is developed for the recirculating flow and heat transfer in a kettle reboiler tube bundle.

提出了釜式再沸器管束中循环流动换热的分相预报新模型，考虑了管束下部的过冷沸腾及循环液体的侧面引入。

It was observed in the Cr-Ni-Mo steels that the intergranular ductile fracture is caused by the reprecipitation of MnS particles in the steel with ordinary S content, and the overheating is also performed by the repreeipitation of AlN or VC particles along the prior austenite grain boundaries in one containing low S. Thus, a proposal seems to be made that the mechanism of overheating of Cr-Ni-Mo steels is related to the solution and reprecipitation of MnS, AlN or VC particles along the prior austenite grain boundaries.

MnS粒子的重新析出使普通硫含量的Cr-Ni-Mo钢发生沿晶延性破断，而AlN或VC粒子在高温奥氏体晶界的重新析出也能使低硫的Cr-Ni-Mo钢过热。

However, a major advantage of superheat in g steam is that for in creas in g cycle temperature and pressure, the exhaust wetness in the turb in e can be ma in ta in ed with in the physical limits.

然而，过热蒸汽的一个主要优势，就是在增加循环的温度和压力的同时，汽轮机的排气湿度可以保持在物理极限内。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。