过大压力

The experiment results prove that the boiler coking is largely reduced and the temperature difference of two sides of horizontal gas-pass is very small, when the 330MW boiler operate, the pressure of primary hot air parison is controlled beyond 12.0～12.5KPa, the O2 content of air pheheater is controlled about 3.0%, the door of OFA is opened to 30%, the buffle of the inner secondary air sleeve is adjusted to the minimum, the outer secondary air swirling strength and the baffle of the outer secondary air sleeve is regulated to the maximum and the outlet temperature of pulvervised mill is kept in 70℃.

试验结果表明，330MW运行时，一次热风母管压力控制在12.0～12.5kPa以上、空气预热器实际氧量控制在3.0％左右、燃尽风门开至30％、内二次风量套筒挡板调整在最小、外二次旋流强度和外二次风套筒挡板调整到最大、磨煤机出口温度维持在70℃，此时锅炉结焦大幅度减轻，水平烟道两侧烟温差非常小。优化试验完成后，进行了单烧灵武烟煤对比，结果是：掺烧高灰熔点的银北煤后，炉膛结焦大幅度减轻，锅炉过热器减温水量较小，主蒸汽压力易提高，带负荷能力正常；再热器烟气挡板开度较大、减温水量较小；风机电耗较小。

Lever Ball Float Steam Traps biggest advantage is not subject to pressure,temperature,cooling water flow fluctuations,continuous drainage,a water that row,the minimum cooling degree 0℃,能使best efficiency heating equipment;lever float steam trap valve seat total in the following level,forming awater seal,no steam leakage;itsPlug Valves minimum working pressure 0.01Mpa,the maximum back pressure rate of≤85%;interior with exhaust,lever float steam traps use the most advanced components as the automatic emptying of diaphragm valves,can automatically exclude non-condensing gas,very sensitive,high quality work and long service life.

杠杆浮球式蒸汽疏水阀的最大优点是不受压力、温度、冷凝水流量波动的影响，连续排水，有水即排，最小过冷度为0℃，能使加热设备达到最佳工作效率；杠杆浮球式蒸汽疏水阀的阀座总处于液位以下，形成水封，无蒸汽泄漏；它的最低工作压力0.01Mpa，最大背压率≤85%；内部带有排气装置，杠杆浮球式蒸汽疏水阀采用最先进的膜盒元件做为自动排空气阀，能自动排除不凝结气体，非常灵敏，工作质量高，使用寿命长。

The Sulfhydryl content of glycinin and β-conglycinin are increased with the increasing of pressure and prolong of processed time; Fluorescence analysis reveals that glycinin has larger hydrophobic regions while processed by higher pressure; But to β-conglycinin, the hydrophobic regions change according to different pressure; The changes of ultraviolet difference spectra of pressured glycinin show that amino acid residues which have ultraviolet absorbance are exposed on the surface of the protein molecule with its unfolding by high pressure denaturation as well as the exposure of sulfhydryl and dissulfide groups.

处理压力的升高和时间的延长都将使大豆豆球蛋白和β-伴大豆球蛋白的半胱氨酸残基暴露，巯基含量增加。荧光分析表明，经压力处理后大豆豆球蛋白表面疏水区域增多：而对于β-球蛋白，在低压作用下，其疏水区域减少，在高压作用下，其疏水区域增加，但在过高的压力下，β-伴球蛋白中的疏水区域又呈现减少的趋势。

The experiment results show that chocking occurs when downstream pressure decreases below the saturation pressure corresponding to upstream temperature and the mass flow rate of refrigerant becomes almost independent of downstream pressure.

试验结果表明，当节流短管的下游压力小于上游温度所对应的饱和压力时，制冷剂出现壅塞现象，此时制冷剂流量不再受下游压力变化的影响；上游压力、上游过冷度、短管直径对制冷剂流量的影响较大。

When the injection pressure is about 0.1MPa, the air flow through the injector becomes critical, so if the swirl level variation reaches the required range, the pressure should be kept as low as possible.

空气射束的喷射压力越大，涡流比的变化范围也越大。而当喷射压力达到0.1MPa左右时，空气在喷嘴内的流动已接近临界状态。因此，射束喷射压力不宜过高，在满足涡流变化要求的前提下，喷射压力应尽量低一些。

Media Help Everyday we are exposed to the steam often divided into two, one, the boiler steam - saturated steam 2, thermal power plants out of steam - superheated steam 1, a relatively stable temperature and pressure saturated steam, temperature lower than 250 ℃, working pressure lower than 1.6Mpa 2, superheated steam temperature and pressure changes of a high base temperature up to 400 ℃, working pressure is lower than 4.0Mpa For the first steam, we usually use soft sealing steam solenoid valve as follows: Structural characteristics This valve is a valve and Balance valves main valve by the two vice components with the second open valve Pilot solenoid valve Heat: electromagnetic part, some with special high temperature seals and sealing materials, electrical materials, and apply a variety of insulation measures Wear: selection and reasonable Globe Valves guidance suite valve cup and clever use of fluid lubrication, reduce wear, increase life expectancy Resistance to condensation: condensation of steam pipeline valve on the steam water is an important factor in action, the valve will not affect the condensation water Other uses - soft sealing steam solenoid valve This series solenoid valve can Safety valves be widely used in textile, printing, chemicals, plastics, rubber, pharmaceutical, food, building materials, machinery, electronics, surface treatment and research sectors and bathroom, dining room, air conditioning automatic control system.

介质说明日常生活中我们接触到的蒸汽常分为两种，1、锅炉蒸汽-饱和蒸汽 2、热电厂出来的蒸汽-过热蒸汽 1、饱和蒸汽温度压力相对稳定，电动阀门执行器温度低于250℃，工作压力低于1.6Mpa 2、过热蒸汽温度压力变化基数较大温度最高可达400℃以上，工作压力则低于4.0Mpa 对于第一种蒸汽，我们通常会选用氧气专用阀、铜阀门软密封的蒸汽电磁阀如下：结构特点本阀是由副阀和主阀两大部件构成的先导式二次开阀的电磁阀耐热：电磁部分、密封件部分用特种耐高温电工材料和密封材料，并应用了各种隔热措施耐磨：选材合理，电站阀门阀杯和导向套间巧妙地利用流体的润滑作用，减少磨损，提高寿命耐冷凝：蒸汽管道的冷凝水是影响蒸汽电磁阀动作的重要因素，本阀则不受冷凝水影响其他用途-软密封蒸汽电磁阀本系列电磁阀还可广泛地应用平衡阀纺织、印刷、化工、塑料、橡胶、制药、食品、建材、机械、电器、表面处理和科研部门以及浴室、食堂、空调等自控系统。

The result show that the position of free surface is higher because of frusta of brake, especial obvious in the head of frusta of brake; flux coefficient and pressure on dam are quite influenced by type of frusta and 3 A type frusta of brake relative to 2 type frusta of brake has bigger flux coefficient and smaller pressure on dam; Obvious influence of ability of discharge flow for different ratio of thickness of frusta and breadth of brake and pressure on dam reduces with increasing ration of thickness of frusta and breadth of brake, while bigger flux coefficient is obtained when tlb = 0.2.(7)The 3D free surface turbulent model established in the paper is comparatively well and truly simulates 3D flow over spillway with frusta of brake and series waterpower computation can be completed aim at different type of dam, type of frusta and disposal on the dam and different water height on peak of

结果表明，闸墩河海大学博士论文的存在抬高了水面线的位置，其中在闸墩头部尤其明显；墩型对流量系数和坝面压力影响较大，3A型闸墩相对于2型闸墩具有更大的流量系数和更小的坝面压力：不同的墩厚闸宽比t/b对泄流能力也将产生显著的影响，随着墩厚闸宽比的增加，坝面压力降低，而当t/b二0.2时溢流坝具有更大的流量系数。7本文建立的三维自由面湍流场模型能够比较准确地模拟带闸墩溢流坝三维过坝水流湍流场，可以针对不同的坝型、墩型、坝面布置形式以及不同的坝顶水头完成系列水力计算，为泄水工程建筑物的设计提供可靠的分析依据

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

Everyone leads a busy life today. Due to increasing stressfulness in life, symptoms such as headache, gastric, back pain, constipation and insomnia has become very popular among us today.

忙碌的现代人，常因压力过大而产生各种如头痛，胃痛，腰酸背痛或便秘，失眠等文明病。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。