迁移数
- 与 迁移数 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
And yet no amount of government support can convince Eira that his livelihood,/intractably entwined with the reindeer, is not about to change. Like a Texas cattleman, he keeps the size of his herd secret.
阿拉斯加州也存在着海岸侵蚀的问题,这迫使美国政府打算迁移数个因纽特人的村庄,每个村庄的预计搬迁费用高达一亿多美元。
-
The electromotive force of the cell was investigated at temperature between 800 and 1000℃.
由实测电动势与Nernst方程导出的理论电动势之比求得的氧离子迁移数在测量温度范围内都大于0.96,并随着温度的升高而逐渐增大。
-
The mathematical models of the dynamics of the mass transfer based on the Nernst-Planck equation were established from which it is found that the different characteristics of the water decomposition between the cation and the anion exchange membranes or resins, is owing to the different potential gradient on the two kind of ion-exchange interfaces, which is further because of the difference between the structure and performance of the different membranes or resins, and is also because of the difference between transfer numbers of cation and anion ions.
根据所建立的传质数学模型方程获知在阴阳膜/树脂表面与水接触的界面层中发生的水解离的差异性,是在于离子交换界面电势梯度的差异,而这种差异又与膜与树脂的结构、性能以及阴阳离子在水溶液中的迁移数的差异有关。
-
When the sintering temperature was ≥ 1450 ℃, the proton transport number was approximately 1 and the fuel cell performance was good.
结果表明,烧结温度能显著影响溶胶-凝胶法合成样品的质子迁移数及燃料电池性能。
-
However, when the sintering temperature was 1450 ℃, the proton transport number was smaller than 1 and the fuel cell performance was poor.
烧结温度≥ 1450 ℃时,质子迁移数近似为1,燃料电池性能亦较高,烧结温度1450 ℃时,质子迁移数1 ,燃料电池性能亦较低。
-
The ionic conductivity of polymer electrolytes equaled 3.56×10-4 S·cm-1 when the mass fraction of silicotungstate lithium was 8.5% in polymer film. The lithium ions transference number, which was measured by the method of combination of AC impedance with DC polarization, decreased with increase of the mass fraction of Li4SiW12O40 in the porous polymer film.
为了提高聚合物电解质的Li+离子迁移数,人们设法增大阴离子的体积[6~8]使其难以迁移而达到提高Li+离子迁移数的目的,很少应用含有多个Li+离子的锂盐做聚合物电解质的Li+离子载体。
-
The observed EMF values of oxygen concentration cell coincided withtheoretical values perfectly, indicating that the ceramics were purely oxide-ionicconductors with oxygen ion transference number of 1 under oxygen atmosphere over thewhole temperature range. The electrochemical oxygen permeation rates determined were inaccordance with the theoretical rates calculated from Faradays law, verifying directexperimentally that the oxide-ionic nature of the conduction under oxygen atmosphere. Athigh oxygen partialpressure range pO_2=10~(-5~10~5 Pa, they were almost pure ionicconductors, which was consistent with the result by means of oxygen concentration cell.Whereas at low oxygen partial pressure range pO_2=10~(-5~10~(-15)Pa, the samplesexhibited mixed ionic and electronic conduction.
结果表明,氧浓差电池电动势的实测值与理论值吻合得很好,氧离子迁移数为1,表明该系列样品在该温度下氧气气氛中为纯氧离子导体;氧泵实验结果进一步证实了该系列样品在氧气气氛中为纯氧离子导体;在氧分压pO_2=10~(-5)~10~5 Pa的高氧分压气氛中,电导率与氧分压变化基本无关,表明在该氧分压范围样品为纯离子导体,这与氧浓差电池电动势测定结果相吻合:在低氧分压为10~(-5)~10~(-15) Pa范围,总电导率随氧分压降低而稍有升高,表明在该氧分压范围样品为氧离子与电子的混合导体。
-
The ion transfer number is introduced in the formula describing the relationship between ionic limiting molar conductivity and ionic concentration based on mode coupling theory. A series of calculated for the ionic limiting molar conductivity are present.
在模式耦合理论推导的低浓度时离子摩尔电导率与离子浓度的关系式中,引入离子迁移数,提出了求离子极限摩尔电导率的新方法。
-
The results are in good agreement with the literature′s results which are calculated either from transport number obta...
计算结果与文献中采用经验公式计算迁移数得出的结果和文献中根据电化学电池法测定迁移数得出的结果相符。
-
The experiment results showed that the addition of ZSM5 could improve the lithium ion transference number and enhance the ionic conductivity of PEO-LiClO4 at the same time.
利用交流阻抗-稳态电流相结合的方法对CPE的锂离子迁移数进行了测定,结果表明掺入ZSM5后锂离子迁移数明显升高。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。