达到

Research makes clear as a result: TC measure has apparent seasonal change feature, average scale is in the biggest April, achieve 230.4km, the smallest Feburary, for 69.5km;TC measure apparent area distributings inhomogenous sex, the area of TC measure occurrence maximum is located in 28.6 ～ 29.5 ° N, 133 ° of 131.1 ～ on the offing of E, and it is to the south of 123 ° E with 12 ° N with south area, TC measure often is under 200km; the TC to different intensity, its measure and intensity luffing have apparent difference, tropical storm (the 24h measure luffing of TS) is the biggest, and typhoon (the dependency of measure of the biggest;TC and intensity is in the 24h intensity luffing of TY) is discrepant below different method, on northwest travel, westing, north model TC measure and intensity show remarkable positive to close, both correlation coefficient achieved 0.93 above, northeast travel and whirly model the correlation coefficient of TC measure and intensity is adjacent 0.6, change direction model the correlation coefficient of TC is in 0.85 or so; in addition, the dependency of TC measure and intensity in its the different level of life history also is put in notable difference, sending exhibition period, the dependency of measure and intensity is best, its correlation coefficient...

探究结果表明：TC尺度有明显的季节变化特征，平均尺度在4月份最大，达到230.4km，2月份最小，为69.5km；TC尺度有明显的区域分布不均匀性，TC尺度出现最大值的区域位于28.6～29.5°N，131.1～133.0°E的海面上，而在123°E以东和12°N以南地区，TC尺度往往都在200km以下；对于不同强度的TC，其尺度和强度变幅有明显差异，热带风暴的24h尺度变幅最大，而台风的24h强度变幅最大；TC尺度和强度的相关性在不同路径下是有差异的，西北行、西行、北上型的TC尺度和强度呈显著的正相关，两者的相关系数达到了0.93以上，东北行和回旋型的TC尺度和强度的相关系数接近0.6，转向型TC的相关系数在0.85左右；此外，TC尺度和强度的相关性在其生命史的不同阶段也存在显著差异，在发展期，尺度和强度的相关性最好，其相关系数。。。

The throughput of the mineral terminals would reach to 8,620,000 tons and that of the finished- product terminals 1,800,000 tons by the means following:Enlarge the 6#,7#,8# and 9# quay,connect the wharfage of 6# quay with that of 7# quay,connect the wharfage of 8# and 9# quay,make the operation in the quay harmonious,improve the management of logistics and make the type of arriving ships more reasonable,etc..

通过采取扩建6、7号码头和8、9号码头库场或将6号与7号码头的库场和8号与9号码头的库场相连通，增加码头作业的协调性，优化货源组织与库场管理、优化到港船型等措施后，可使工业港矿石码头综合通过能力达到862万吨，成品码头综合通过能力达到180万吨。

The results show that signal in FEL amplifier with a coaxial hybrid wiggler can get an efficient amplification even at a low voltage of 205 kV.

粒子模拟结果表明，这种同轴摇摆器结构FEL在工作电压较低(205 kV)的情况下仍可以得到较好的放大输出，效率达到27.3％，饱和功率达到兆瓦级；等离子体填充对器件的性能有一定的影响，改善了束流传输特性。

Targeting the biomass rice stalk,we use linestone as catalyst and cracking catalyse the tar which was pyrolysised from the target.We build the rice straw biomass gasification tar removal catalytic cracking process model by the least squares support vector machine model and optimize the model parameters through genetic algorithm.We also has gotten the best catalytic cracking temperature and gas residence time, making the highest rate of catalytic cracking tar.We made wood biomass as a target analysis so that we can thermally crack tar,and we can use genetic algorithms to optimize the model parameters that is based on the wood biomass gasification pyrolysis tar removal process model through the least-squares fitting method,then we got the best pyrolysis temperature and equivalence ratio,so that it is possible to make the tar content reach the minianum.Based on the least squares support vector machine model,we had established the model of the biomass sawdust Compression molding process and fit the Optimization Parameters objective function of the molding process .

以生物质稻秆为对象，采用石灰石作为催化剂对稻秆热解焦油进行催化裂解，由最小二乘支持向量机模型建立了生物质稻秆气化焦油催化裂解脱除过程的模型，并用遗传算法对模型参数进行了优化，得到了最佳的催化裂解温度和气相停留时间，使得焦油催化裂解率达到最高；以生物质木屑作为分析对象，对其进行热裂解脱焦，并依据最小二乘曲线拟合方法建立了生物质木屑气化焦油热裂解脱除过程的模型，用遗传算法对模型参数进行了优化，得到了最佳的热裂解温度和当量比，使得焦油含量达到最小。

The company more than 2500 kinds of wrought iron products which are all exported to foreign countries, such as Italy, France, England, Portugal, Sweden, Spain, Canada, etc., that it occupies 1/5 of European market.

公司生产的锻件铁艺产品已达到2500多种，全部出口，产品市场占有率达到欧洲市场的1/5，现在与意大利、法国、英国、葡萄牙、瑞典、西班牙、加拿大等国家的客户建立了贸易合作关系。

Results The ovarian artery of 68 cases in 1 056 uterine fibroids or adenomyoma cases who treated by uterine artery embolisation were visualized distinctly during uterine artery angiography before and/or after embolization,manifestation as type Razavi-Ⅰ UA-OAa for all.

结果 在1 056例UAE病例中显示68例共有47侧左卵巢动脉和57侧右卵巢动脉存在Razavi-Ⅰ型UA-OAa.20例左侧子宫动脉和27例右侧子宫动脉达到肌瘤动脉栓塞，而UA-OAa保持。68例UAE全部达到技术成功和临床成功，无肌瘤复发和卵巢衰竭病例。

But the positiverate was up to98.51%while AFP combined with AFU and GGT in diˉagnosis for PHC.

AFP+AFU检测总阳性率达到97.01%。AFP+AFU+GGT检测总阳性率达到98.51%。

After several practical problems are resolved,the relation between contents of S,Si and Al has been disclosed.The ratio of Ca to Alin in steel is 1.26∶1 after calcium treatment,the nozzle clogging does not happen and the consumption of calcium is reduced.The recovery factor fluctuation of boron are 64% and ±5×10-6, respectively.

通过硼微合金化若干工艺问题的解决和工艺优化，明确了钢水硫含量、增硅、铝控制之间的内在关系；使SPHC钢成分合格的同时，实现硼收得率达到64%，硼的质量分数波动±5×10-6；钙处理达到钢水中w∶w为1.26∶1时，确保水口浇注顺利，同时节省钙线用量。

E. value of productions were detected by high performance liquid chromatography. Results The chiral aminoalcohol ligand compound Ⅰ can promote the asymmetric allylation of acylhydrazones and the yield was 57%; The highest values of e. e. obtained for this reaction was 22%.

结果 手性氨基醇配体化合物Ⅰ能够促进烯丙基三氯硅烷和酰腙的烯丙基化加成反应，在它的辅助作用下，烯丙基化加成产物的产率可达到57%，对映体过量值最高达到22%。

Through researching the mechanism of biological nitrification and denitrification and actual project application of the technology and related literature materials, the obtained results are as follows:(1) Anoxybiosis is effective to the removal of COD; after the anoxic process, BOD/COD of the outflow increases, it shows that the degradation ability of wastewater is improved; anoxybiosis is insensitive when shock loading of inflow wastewater varies greatly;(2) It is demonstrated by the operation of inoculation and cultivating that biofilm takes two weeks to succeed in cultivating on packings and the removal ratios of NH3-N and COD get 50% and 70% respectively, when gas-water ratio is 6:1, HRT is 7.3 hour, water temperature is above 15°C;(3) It is demonstrated that gas-water ratio, hydraulic loading, HRT, temperature, pH etc are important factors which influence the removal effect of pollutants, when the gas-water ratio is 6:1, hydraulic loading is about 0.38kgNH3-N/m~3.d, water temperature ranges from 15°C to 27°C, pH ranges from 7.5 to 8.0, the BIOFOR removal effect of pollutants is the best;(4) The operation indicated that, this technology has strong ability of nitrification and denitrification; it has extremely vital significance for reducing the water body eutrophication;(5) It is confirmed the feasibility and the usability of preanoxic-BIOFOR process to treat L-lactic acid production wastewater. The experiment indicated that the treatment effect of this technology is very good and also shows that the technology has many advantages, such as small volume, high treatment efficiency, good effluent quality and strong endurance to load variation, this technology is a new and economical wastewater treatment process.

通过对生物脱氮机理的研究和该组合技术的实际工程应用，并结合有关文献资料，取得如下结论：(1)预缺氧池对L-乳酸生产废水中的COD去除具有一定的效果；废水中难降解的高分子物质经过缺氧工段分解为易于氧化降解的物质，浮状有机物在水解菌的作用下，将不溶性有机物水解为溶解性物质；预缺氧池具有较强的抗冲击负荷能力；(2)BIOFOR接种挂膜过程表明：HRT为7.3h、气水比为6：1、水温保持在15℃以上，经过半个月生物膜即以形成，NH_3-N和COD的去除率分别达到50％和70％左右；(3)研究表明：气水比、水力负荷、HRT、温度、pH等是影响污染物去除效率的重要因素，在气水比为6：1，NH_3-N容积负荷为0.38kgNH_3-N／m~3·d，温度在15℃-27℃，pH在7.5-8.0之间的条件下，BIOFOR对污染物的去除效率达到最佳；(4)运行表明，该组合技术具有较强的脱氮能力，对于减少水体富营养化具有十分重要的意义；(5)经过半年多实际工程的现场调试与运行，验证了利用预缺氧—BIOFOR组合工艺处理L—乳酸生产废水的可行性和实用性，得出该组合技术具有占地面积小，处理效果好，运行费用省，耐冲击负荷能力强等优点，是一项新型、经济的污水处理技术。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。