边缘内的

The sedimentation is the foundation, affecting the basic pattern of the reservoir,and the sedimentary facies zones beneficial to the formation and evolution of the reservoir includes platform edge bank facies, introplatform point beach facies and acclivity sedimentary facies, etc.; the diagenesis is the key factor, determining the pattern and scope of the final distribution of the reservoir and being of great influence on reservoir structure, and the diagenesis of promoting the formation of storage rooms is mainly the dissolution occurred during hypergene stage and burial stage;and the tectonism is the condition of influencing the connectivity among various reservoir bodies and among the storage rooms within a single reservoir body.

该套储层是在4亿年左右的地质历史中，由沉积、成岩和构造作用相互影响而形成的最终成果：其中沉积作用是基础，影响着储层的基本形态，有利于储层形成与演化的沉积相为台地边缘滩、台内点滩和上斜坡等沉积相带；成岩作用是关键，决定了储层的最终分布形态和范围，对储层结构的影响至关重要，促进储集空间形成的成岩作用主要有表生期和埋藏期的溶解作用；构造作用是条件，影响着各储集体之间以及单一储集体内部储集空间的连通情况。

Further, when a is on the verge of death, at the last instant of life, when all his faculties scatter and he departs from his relatives, when all power and status are lost and nothing survives, when his Prime Minister, great officials, his inner court and outer cities, his elephants, horses, carts, and treasures of precious jewels can no longer accompany him, these Vows alone will stay with him.

此外，当一个是，濒临死亡边缘，在最后的即时的生活，当他的所有院系散射和他离开他的亲戚，当所有权力和地位的丧失，没有延续下来，当他的总理，伟大的官员，他的内院和外的城市，他的大象，马，车，和珍贵的珠宝珍品再也不能陪他，这些誓言仅留他。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

The measured object can be found within a few milliseconds in the raster-scan image. 4 . Two lines delay for the processed image is implemented using two 128×8 shift registers with the configurable logic block in FPGA. A new fully pipelined bit parallel hardware architecture for Sobel edge detection is implemented with FPGA. Furthermore, it takes no more than 2ms to complete the edge detection of an image with 128×128 pixels.

视觉检测信号的前端处理技术 1、系统地分析了视觉检测算法层次性特点和计算特点，提出了提高视觉检测信号处理速度的基本方案：采用前端处理系统，自动识别被测物体在获取图像中的位置，并将真正有用的被测物体的边缘坐标值，提供给计算机，作进一步的高精度处理； 2、系统研究了实时图像硬件处理的设计基本方法，提出了基于FPGA的视觉检测信号的低级处理算法硬件实现模块化模型； 3、提出了一种新的基于FPGA的模板匹配并行模块化结构，解决了二维图像处理高带宽要求，在几毫秒内就可以在按扫描顺序输入图像中找到检测目标物体的位置； 4、采用FPGA内部的可配置逻辑块实现了128×8移位寄存器的设计，解决了大容量移位寄存器与FPGA内部寄存器数量之间的矛盾，实现了两行图像的延迟。

The results show that, for the elasto-plastic contact of tip-substrate approach and separation process, the material plastic yielding in the atomic level is still governed by the von Mises criterion. For the adhesion of flat-ended wedges, continuum mechanics can be still applied down to a few lattice constants within the contact region, and give reasonable results, apart from the discrepancies near the contact edges. Moreover, adhesion hysteresis occurs during unloading due to the atomic steps, where the unloading curve does not coincide with the loading one. This in turn supports the presumption proposed by Pollock for the adhesion of stepped spheres.

本文首先对针尖—基体模型的弹塑性接触机理进行了深入研究，指出在原子水平上材料的塑性屈服仍由Von Mises准则控制；对平底锥冲头粘着接触的模拟表明，除了在接触区边缘附近有一定差别外，接触力学方法在接触区内几个晶格常数范围内仍能给出令人满意的结果；由于原子台阶效应，加载与卸载曲线不重合，出现粘着滞后，证实了Pollock关于具有纳米阶梯结构的球体粘着滞后现象的推测。

Ruptured aneurysms may have high density blood in basal cisterns and sulci adjacent to them, in addition to subarachnoid hemorrhage.

破裂的动脉瘤可能在基底池及邻近脑沟内有高密度出血，未破裂的动脉瘤伴有部分或完全的血栓可以表现为稍高密度影，常常会有环状钙化壁或附壁血栓，增强扫描，伴有部分血栓的动脉瘤最特异的表现是靶征，完全血栓形成的动脉瘤可以有反应性的边缘强化，没有血栓形成的动脉瘤表现为明显均匀性管腔样强化。

Culm sheaths yellow-green or pale red-brown, becoming straw-colored, with variably sized brown spots, base edged with white pubescence; auricles and oral setae absent; ligule yellow-green, truncate or weakly convex at apex, very short, 1–2 mm, margin longer pale green ciliate; blade reflexed, green, with yellow margins, linear, flat or crinkled in upper sheaths.

竿箨黄绿色或者苍白的红棕色，变得稻草色，带有易变依大小排列的棕色的点，基础随着白色的青春期推进；叶耳和口头的刚毛无；叶舌黄绿色，削去或者身体虚弱凸在先端，非常短，1-2毫米，边更长的苍绿色纤毛虫；反折，绿色的叶片，具黄边缘，在上面鞘内皱曲的线形，平或。

The rotor axis is arranged with silicon steel sheet which is piled together by many silicon steel sheets. The edge of silicon steel sheet sets many small slots. After silicon steel sheet piling up, many slots are formed.

本发明的结构中，转轴上设有若干片叠加成一体的硅钢片，在硅钢片的边缘部分设有若干小的槽体，硅钢片叠加之后相对应的构成若干通槽，在通槽内填充纯铝。

Takenouchi that the west margin of"Komarov Line"should not be encl...

最后本文提及关于竹内亮教授所倡的&Komarov 线&的位置介于长春和净月潭之间，即是满洲植物区的最西边缘只到达净月潭，从蕨类的分布亲密度来看，这种说法也是较为恰当的。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷