输出量

A first light receiver and second light receiver output detected results corresponding to the amounts of received light to a comparator, respectively.

第一光接收器和第二光接收器分别将对应于所接收光量的检测结果输出到比较器。

The maximum of the sinusoidal solution equals approximately to that of the output voltage, if the circuit's parameters are reasonable.

在合理参数下，可以用该相量的最大值，近似作为输出电压最大值。

This dissertation introduces the whole scheme、the hardware electro circuit design and software design, the result of experiment on salinometer is preferred at the end of the dissertation. Salinometer is base on SOPC technology, and use digital technology to design circuit: the excitation source for balance bridge is generated by digital method, its shape、amplitude and frequency can be control by digital signal, the standard branch of bridge is composed of three digital-analog-conversion, and uses the method of successive approximation to regulate the balance of bridge.

盐度计以SOPC技术为基础，通过数字化方式设计测量电路：电桥的激励源由数字化方式产生，激励源的波形、幅值和频率等可由数字量控制；平衡电桥标准支路由3个数模转换器组合实现，测量时以逐次逼近的方式调整电桥的平衡度；检测电桥平衡度的高灵敏度数字检流计同样以数字化方式设计，它的增益由程序控制，将电桥的输出电压数字化，以软件判断电桥平衡度。

The experimental results testify that the water-cooled silicon mirror with linear type microgroove runner can make the stability of laser output better and meet the need of stability in practical application although its absolute distortion is tinily larger compared with the water-cooled mirror with spiral type runner.

大量的台架实验结果和现场试验结果证明，虽然直线型微沟槽流道结构水冷硅镜镜面绝对热变形量与螺旋型流道相比略大，但动态热特性较好，激光器输出稳定性较高，能满足实际应用中对稳定性的要求。

Application of proportional controller to active vibration control incorporated with passive vibration isolator to suppress its resonant oscillation of natural frequency is proposed in this paper. Vibration acceleration acquired from accelerator is inputted to controller as feedback signal. The processed signal from controller is transmitted to voice coil actuator to control vibration.

本文主要是运用比例控制器进行被动式隔振系统自然频率共振抑制之主动控制研究，控制回馈讯号采用加速规量得之振动加速度值，经由控制器计算输出控制讯号驱动音圈致动器进行主动控制。

In the experimental work, application of proportional controller to active vibration control incorporated with passive vibration isolator to suppress its resonant oscillation of natural frequency is studied in this project. Vibration acceleration acquired from accelerator is inputted to controller as feedback signal. The processed signal from controller is transmitted to voice coil actuator to control vibration. Firstly, based on the theoretical equations which govern the system vibration, the physical mechanism of active control in total system is studied.

在实验部分，则运用比例控制器进行被动式隔振系统自然频率共振抑制之主动控制实验，控制回馈讯号采用加速规量得之振动加速度值，经由控制器计算输出控制讯号驱动音圈致动器进行主动控制。

First,by choosing a control function for a local adaptive optimal neighborhood,the filter window is set in the region with similar normals to avoid the problem of shrinkage and over-smoothing.

首先通过自适应选取最优邻域控制函数来将滤波窗口限制在顶点法向量相近的区域，以防止滤波后模型的收缩和过光顺；然后运用协方差矩阵分析的方法，在最优邻域内计算出各采样点的法向量和曲率；最后以采样点滤波参考平面为基准，分别平滑采样点的法向量和位置，即先对采样点的法向量进行多边平滑，然后根据新的法向量来多边平滑输出各采样点的位置偏移量，最后在法向方向上移动该顶点，以达到降噪的目的。

In case of high input dimension system model, taking norm of input vector as the input of wavelet network instead of using tensor product method to construct wavelet network ,which could solve the problems of high computation and curse of dimensionality.

在模型结构方面，对于多维输入输出系统建模，本文放弃选用传统的标量积确定小波基函数的方法，将输入矢量的范数作为小波网络基函数的输入变量，从而避免了高维输入所带来的可用小波基数量巨大和计算复杂的缺点。

It gives out the peripheral equipment on-line signals to allocate reasonable input and output points according to customers' peripheral equipment conditions, so as to enable them of fully automatic operation mode.

具有周边设备联机信号。可以根据客户使用周边设备情况合理配量输入输出点，使之具备全自动工作模式。

Combine to emphasize the software design that introduced thought and design methods of the direct current servo control system, it included the design of the main procedure, give the design that settle the procedure, modify the design of the procedure and start the design of the procedure to break off the design of the procedure with the T0, passing to the fixed amount with comparison and PID that feedback measures control procedure, output the certain electric voltage, realize system opposite angles degree of accurate follow.

本文介绍了以 MCS—51单片机为控制核心的直流伺服控制系统的工作原理，并着重介绍了直流伺服控制系统的软件设计的思想及设计方法，它包括了主程序的设计、给定程序的设计、修改程序的设计、启动程序的设计和T0中断程序的设计，通过给定量和反馈量的比较及PID控制程序，输出一定的电压，来实现系统对角度的准确跟踪。

Singer Leona Lewis and former Led Zeppelin guitarist Jimmy Page emerged as the bus transformed into a grass-covered carnival float, and the pair combined for a rendition of "Whole Lotta Love".

歌手leona刘易斯和前率领的飞艇的吉他手吉米页出现巴士转化为基层所涵盖的嘉年华花车，和一双合并为一移交&整个lotta爱&。

This is Kate, and that's Erin.

这是凯特，那个是爱朗。