输出信号

Suction superheat control system consists of electronic expansion valves, pressure sensors, temperature sensors, controller, working hours, the pressure evaporator outlet pressure sensor P1, temperature sensors compressor suction superheat will be passed to controller, controller After signal processing, followed by the output commands acting on the main electronic expansion valve stepper motor to open the valve to the desired location.

吸气过热度控制系统由电子膨胀阀、压力传感器、温度传感器、控制器组成，工作时，压力传感器将蒸发器出口压力P1、温度传感器将压缩机吸气过热度传给控制器，控制器将信号处理后，随后输出指令作用于电子膨胀主阀的步进电机，将阀开到需要的位置。

This paper studies the design and the realization of missiles wing and rudder load simulation system based on DSP and DTC servo driver after introducing the basic principles of electric loading system .

本文在分析电动加载系统基本原理的基础上，研究了以数字信号处理器和具有直接转矩控制输出的ACS600伺服驱动器为核心的弹用加载控制系统的设计及实现方法。

The design and the realization of missile wing and rudder load simulation system based on digital signal processor and direct torque control servo driver are discussed.The structure,strategy of control and operation principle of the system are presented.The reason of the superabundant torque and the method which can eliminating the superabundant torque are analysed.

研究以数字信号处理器和以直接转矩控制输出的伺服驱动器为核心的导弹弹翼尾翼加载控制系统的系统结构、控制策略、工作原理及实现方法，详细分析加载系统中多余力矩的产生及抑制方法，解决电动加载系统关键性的两个难点，即快速性和多余力消除。

LabVIEW Simulation Software by 1.5MW wind turbines on the change in wind direction in the input signal, power and yaw motor motion simulation and analysis results show that the strategy will enable effective power output of wind turbines increases, making the cabin has the right wind fast, stable characteristics.

通过LabVIEW仿真软件对1.5MW的风力发电机在输入变化的风向信号时，功率和偏航电机动作进行仿真分析，结果表明该策略能够使风力机的输出有效功率增加，使得机舱具有对风快，平稳的特点

The main idea is to use the successive outputs from SIC as additional pilots and conduct channel re-estimation recursively.

主要的想法是利用从SIC的输出来当做额外的已知信号并且递回地接续著通道重新估计。

Information by opening the valve D / A converted into analog signal output, is used to access indicator shows valve opening or connection to other control equipment.

阀门的开度信息通过D/A转换后变成模拟信号输出，用来接显示仪显示阀门开度或连接其他的控制设备。

Supply touch spot signal output, apply to be used when adopting along line cable

KG9001A--Z 提供触点信号输出，适合采用沿线电缆时使用

Supply touch spot signal output, apply to be used for such ground equipment as coal factory

KG9001A—D 提供触点信号输出，适合选煤厂等地面设施使用

Using LM135 semiconductor temperature sensor, CPU and digital tube interface, a digital display free-air thermometer for helicopters has been developed sucessfully, which will take the place of the bimetal pointer thermometer.

半导体温度传感器具有较高的精度和良好的线性输出。采用LM135型半导体温度传感器，与CPU、数码管接口，经A/D和V/F转换等信号处理，成功研制了某直升飞机数字大气温度显示器，取代了双金属片指针式温度计。

Cable .Make use of this principle, we can quickly locate the target cable or break point from large amount of cables, under carpet, the inner of decoration wall and over ceiling1 operation is simple , reliable , the interface is nimble , use is broad , bionic form , carry-over are convenient, since our link tester has two signal output port, it can work when switch is running, this is very convenient. 2 applies to all metal cable such as network cable , tele phone line cable , video cable , automobile circuit .it can not be work with high voltage(above 80V),if you want to locate it ,please turn off the cable power supply3 can test the telephone line polarity, connectedness, rough position of breaking point.4 uses the two crocodile clamp to avoid getting rid of the job of make network cable. Use the RJ45/RJ11 interface can connect to the network and the telephone line directly.5 link tester can find out that pair of circuit line cable from large mount of cables. 6 high amplitude ranks 200 times amplification circuit is sui table to locate long distance cable.7 two-sided network lines sequence indicator is easy to examine the network line cable whether or not correctly conveniently. 8 portable types multifunctional bag can encase most of your engineering tools; remit your messy carry-over of implement bothering. 9 adopt two 9V batteries.

线路通产品特点：1 操作简单、性能可靠，接口灵活、用途广泛，仿生外形、携带方便，由于本设备采用了信号双路输出方式，可以解决交换机工作状态下使用，避免了关掉交换机影响其他线路的使用的麻烦。2 适用于查找网络电缆、电话线路、视频电缆、汽车电路、无强电状态下的所有金属电缆。3 可以测试电话线路极性、连通性，断点大概位置。4 两个鳄鱼嘴夹，避免了去做水晶头的麻烦，RJ45/RJ11接口线，可直接连接网络和电话线模块。5 寻线器快速地在众多紊乱的线路中找出需要查找的那一对线路线缆。6 高音频振幅级别200倍的放大电路，适合长距离电缆定位。7 双面网络线续灯可以更直观方便的检查校正网络线续线路连接是否正确。8 便携式多功能软包，可以把您工程施工、维护的基本工具装齐，免除您工具散乱携带的麻烦。9 本寻线器采用2节9V电池。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。