输入电流

Input signals can be signal current or voltages originating from corresponding measurement transducers or measurement value acquisition systems.

输入信号可以电流或电压信号，由相应的测量传感器或测量值采集系统的来源。

When operating with maximum input voltage the load current and/or the ambient temperature will be limited.

当输入电压工作，最大负载电流和/或周围环境温度将是有限的。

When operating with maximum load currents the input voltage and/or ambient temperature will be limited.

当最大负载电流，输入电压和/或环境温度将是有限的操作。

Another way to subtract the input offset current from measurements is to use the relative function of the ammeter.

从测量结果中减去输入偏置电流的另一种方法是使用安培计的相对功能。

Its input signal should be large-signal, the collector current cosine pulse for a month.

其输入信号应为大信号，集电极电流为一个个余弦脉冲。

The input common-mode voltage for current-sense amplifiers is allowed to exceed the power-supply voltage.

输入共模电流检测放大器电压可以超过电源，电源的电压。

The two kinds of control schemes can make corrector have characteristics of nearly-close-to-1 power factor and low current harmonics.

两种控制策略都可以使校正器具有输入功率因数接近于1及低电流谐波的特性。

The relations between the potential difference and the discharging time when the discharge current is a step function as well as a step function containing high frequency vibrations, the relations between one-dimensional and two-dimensional spark locations and potential difference based on the thin wall model and the thick wall model have been studied.

仿真研究了放电电流为阶跃函数以及含高频振荡时电位差与放电时间的关系；基于薄壁模型和厚壁模型，仿真研究了电极下表面一维放电点位置和二维放电点位置与电位差的关系；对于确定的电位差，仿真研究了放电点位置的分布情况，说明两点输入不能唯一地检测出放电点位置，从而引入四点输入检测的思想。

Adopt one kind of design plan that PLC controls in the protection the main body of a book has been introduced succeeding an electricity in electric system, that capital is designed time is that the KV circuit imports 10 mainly , change into 380 V voltage grades, before the PLC front and back add front to passage and the queen to passage, change before to passage middle course electric current , voltage a train of, the wave filtering the general is exchanged changing waking up with a start for direct-current, the entering carrying out comparison and switch amounts again , controlling conducting entering PLC, by PLC, The malfunction signal is shown out by lamp light or the alarm signal.

本文介绍了在电力系统继电保护中采用PLC控制的一种设计方案，本次设计主要是将10KV线路输入，转化为380V电压等级，在PLC前后加入前向通道和后向通道，在前向通道中经过一系列的电流、电压转换，将交流转换为直流，进行滤波，再进行比较和开关量的输入，传入PLC，通过PLC的控制，将故障信号通过灯光或者报警信号表现出来。

The properties are the dispersion equation of IREBs drifting in the tube, and the transmission line model of IREBs interacting with the gap electrical field of input cavity of RKA and bunching in the drift tube. The expression of modulated current after the gap of input cavity is got, which is content with the experimental results.

建立了IREBs在漂移管中传输的色散方程，以及IREBs与RKA输入腔间隙电场相互作用和IREBs在漂移管中群聚传输的传输线模型，获得了电子束经过输入腔间隙后产生的调制电流表达式。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。