输入偏置电流

Again, consider using amplifiers that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.

再者，所用的放大器也要考虑在加到输入端的整个共模电压输入偏置电流转换保持平滑。

Again, consider using AMPLIFIER s that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.

再者，所用的放大器也要考虑在加到输入端的整个共模电压输入偏置电流转换保持平滑。

As shown in Figure 2-17, the input offset current adds to the measured current so the meter measures the sum of the two currents

如2-17所示，输入偏置电流叠加到被测电流上，所以仪表测量的是两个电流之和

An electrometer makes an ideal coulombmeter because it has very low input offset current and high input resistance.

静电计是一个理想的库仑计，因为它具有非常低的输入偏置电流和很高的输入电阻。

The feedback resistance, R1, is dependent on cell sensitivity and should be chosen for either maximum dynamic range or for a desired scale factor. R2 is elective: in the case of photovoltaic cells or of photodiodes, it is not required in the case of photoconductive cells, it should be chosen to minimize bias current error over the operating range.

反馈电阻R1的取值由电池的灵敏度和要求的最大动态范围，或者需要的电流——电压转换比例决定。R2分情况选取：在光电池和光电二极管时不需要这个电阻，在光电导的时候，电阻的阻值应该能使在工作范围内，由OP输入偏置电流所带来的误差最小。

The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage.

仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。

Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.

虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。

Ffset voltage at the input of an operational amplifier is comprised of two components, these components are identified in specifying the amplifier as input offset voltage and input bias current.

P的失调电压有两个主要的来源，输入偏置电流和输入失调电压。

It is shown from the accelerated lifetime test and noise measurement for integrated operational amplifiers that if their failure is caused by the drift of input bias current or input offset current, the drift is strongly correlated with 1/f noise current in these devices, and both are proportional approximately.

摘要寿命试验和噪声测试结果表明，如果集成运算放大器的主要失效模式是输入偏置电流或失调电流随时间的漂移，则这种漂移量与运放的1/f噪声电流具有强相关性，二者近似呈正比关系。

While the most important characteristics of the electrometer voltmeter operational amplifier are low input offset current and high input impedance, the most important requirement for the nanovoltmeter input preamplifier is low input noise voltage.

静电计电压表使用的运算放大器，最重要的特性是低输入偏置电流和高输入阻抗。纳伏表输入前置放大器的最重要的要求，则是低输入噪声电压。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。