辐射热

A prediction model has been proposed to deal with threshold voltage shift as a function of 1MeV neutron flux and gate oxide thickness, and to deal with room-temperature annealing of threshold voltage shift induced-by 〓Coγ as a function of electric field and gate oxide thickness. The commonness and individuality of MOS device degradation between hot-carrier effect and ionizing radiation were investigated. The dependence of substrate current, gate current and threshold voltage shift due to hot-carrier on gate oxide thickness were simulated with MEDICI-2D simulator. The photocurrents of PN junction and bipolar transistor were studied. Their transient responses on varied bias voltages, pulse durations and absorbed doses were simulated. The influences of NPN base width on base and collector photocurrents were investigated. We also studied 1MeV neutron displacement damage in PN junction, and calculated reverse current leakage under the neutron flux of 2. 67×10〓 per square centimeter. 3 The study of nondestructive screening method for MOS radiation tolerance A theoretical and experimental study of nondestructive screening methods for radiation tolerance of nMOS and pMOS were firstly fulfilled. We determined the informative parameters pertinent to the method and proposed how to deal with experimental data and verify obtained results statistically, as well as make the required steps for nondestructive screening. Based on the experimental data of 180 samples of discrete pMOS devices, the relation between sample quantity and correlation coefficient, screening equation, and other significant results were obtained from the threshold voltage shifts of pre-and post-irradiation samples.

二、分立器件电离和位移辐射损伤响应研究在国内首次开展了电离辐射引起的氧化层阈值电压漂移和退火理论研究，编程计算了1MeV中子引起的MOS器件阈值电压漂移与中子通量及栅氧厚度的关系，计算了〓Coγ光子引起的阈值电压漂移及退火的时效曲线与纵向电场和栅氧厚度的关系等，对评估MOS型集成电路电离损伤和加固方法研究，以及论文中开展的MOSFETs无损筛选方法研究奠定了基础；分析了MOS器件热载流子损伤效应与辐射电离损伤效应之间的异同性，利用二维模拟软件MEDICI-2D模拟了衬底电流和栅电流，在不同栅氧厚度下随栅压的变化曲线，计算了热载流子效应造成的阈值电压漂移，研究结果对当前存在的以热载流子效应研究取代电离辐射损伤实验研究的设想，具有重要的参考价值；开展了PN结和双极晶体管电离光电流研究，计算了不同偏压、不同辐射脉宽和不同吸收剂量下PN结光电流的瞬时响应，计算了不同辐射脉宽下NPN晶体管基极电流和收集极电流的瞬时响应，以及基区宽度对NPN晶体管光电流的影响，研究结果对双极器件抗电离辐射损伤响应及加固方法研究具有重要意义；在国内首次开展了器件位移损伤的理论研究，分析了辐射产生的缺陷对电性能的影响，计算了注量为2.67×10〓cm〓的1MeV中子产生的缺陷对PN结反向电流的影响。

Through experimental study of typical crown fire using pine tree, we first measuredits heat release rate and the inter-space thermal radiation variation of crown fire ofsingle pine tree and compared the experimental data with the model prediction,validating the rationality of the thermal radiation model of single tree.

通过对典型树冠火热辐射的实验研究，以雪松为实验树，测量了实验树的热释放速率、由单颗雪松产生的树冠火的空间热辐射随时间的变化，并将测量值与利用单树热辐射模型计算出的理论值进行了对比分析，验证了单树热辐射模型的合理性；然后测量了由多个雪松同时燃烧产生的空间热辐射随时间的变化，并将测量值与利用多树热辐射模型计算出的理论值进行了对比分析，验证了多树热辐射模型的合理性。

The results show that the maximum detectivities of a-Si and polySiGe bolometers are 2.23×108 and 3.75×108 cmHz1/2W-1 respectively, and TFT-based room-temperature infrared detectors have a maximum detectivity of 1.02×109cmHz1/2W-1, which reaches the same highest level in performances in the world.

结果表明，斩波频率为30Hz时，a-Si和polySiGe测辐射热计的最高探测率分别达到2.23×108和3.75×108cmHz1/2W-1，TFT室温红外探测器的最高探测率可达1.02×109 cmHz1/2W-1，达到目前国际先进水平。

The range of the spectrum in which heat is radiated mostly lies within the infrared portion.

辐射热的光谱段大部分落在红外区。

Sunlight shines on the selected sorption layer coated on the outer surface of inner glass tubes through the outer glass vacuum heat collecting tubes; the coated layer sorbs the sunlight radiation energy, changes it into the heat energy and transfers it into the liquid form medium i.e.

它像拉长的保温瓶胆，内管外表面采用磁控溅射工艺，沉积多层渐变选择性涂层，在内外管空间抽成真空，消除了气体的对流与传导热损，并应用选择性吸收涂层，使真空集热管的辐射热损降到最低。

The subway radiates with heat, We barely met, and still I cross the street, to your door.

地铁辐射热，我们勉强满足，我还是过马路，你的门。

The main contents of the present paper include: 1、The mechanism of fouling accumulation and the effects of fouling and slagging on boiler performance are analyzed. The model of fouling increasing is developed on the basis of sediment rate and denudation rate. The fouling monitoring models for boiler furnace and convective sections based on heat balance, the ones for air heater based on converted pressure difference are given. The implement results show that these models can reveal the cleanliness of boiler heat transfer surface. 2、The disadvantages of the model for boiler furnace fouling and slagging monitoring based on heat balance are discussed, and the calculation of radiant heat flux is considered as the primary difficulty.

主要包括以下内容： 1、分析了锅炉受热面污染形成的机理，从灰污的沉积率和剥蚀率角度出发，推导了受热面灰污增长的基本模型，分析了灰污热阻随积灰时间和烟气流速变化的规律，并通过大量现场试验，得到了沉积常数与时间常数的取值范围； 2、针对炉膛、对流受热面和空气预热器等不同受热面的传热特性，分别建立了基于热平衡和折算压差的污染在线监测模型，经实践验证，其监测结果能够满足现场工程应用的精度要求； 3、分析了基于热平衡原理的辐射、半辐射污染监测模型的不足之处，指出了机理模型因对炉内辐射换热量计算不准确，导致对以辐射换热为主的炉膛和以半辐射半对流的屏式过热器监测效果不够理想。

Ah, radiant heat travels in a straight line.

啊，辐射热以直线传播。

Experimental observations are presented of the effect of the flow velocity and oxygen concentration, and of a thermal radiant flux, on the transition from smoldering to flaming in forward smoldering of small samples of polyurethane foam with a gas/solid interface.

试验主要观察处于阴燃状态的少量聚氨酯泡沫样品的流速、氧气浓度和辐射热通量对气/固界面的影响。

The ionized tracks are measured by optical probing technique. Collimated ionization tracks lasting for 60 picoseconds and extending 150 to 300 micrometer in length and 8 micrometer in diameter are observed.

实验观察到了在镀铝膜石英玻璃靶中在激光入射方向近似各向同性的辐射热传导，并在其前端有几条离化径迹，这些离化径迹是相互平行且等间距的，径迹之间的间距约13微米，其宽度约8微米，所观察的径迹从产生到消失的时间约60ps，在这个时间段内径迹的长度从 100-300微米变化。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。