轴管

In the spiral pipe heat exchanger exports terminal, the ammonia steam temperature has been heated up 85 ℃--95 ℃, by now, the ammonia steam had the 45kg-55kg/cm2 ammonia steam pressure, sent in the ammonia steam turbine through the constant temperature pipeline, impelled ammonia steam turbine revolving, led the generator electricity generation;After the ammonia steam makes the merit release energy, the temperature drop, the returns ammonia storage tank, passes through again adjusts the press pump to press into the spiral pipe-type heat exchangers to carry on the next circulation;Including the ammonia steam turbine entire ammonia steam road is becomes the independent closed cycle system, is isolates completely with the outside air;The ammonia steam only plays the carryhome and the shift energy role, in the electricity generation process does not consume the actuating medium, the stored energy carrier water also is only gets up the carryhome and the shift energy function,The waterway also is from becomes the independent closed cycle system, in the electricity generation process also the needless water consumption, through the actuating medium ammonia steam and the stored energy carrier water unceasing shuttle service, transforms through the heat interchanger the solar energy as the actuating medium ammonia steam heat energy and the kinetic energy,With the aid of the ammonia steam turbine heat - machine transformation function and the generator machine - electricity transformation function, has realized the solar energy hot - electricity entire conversion process, transforms continuously the solar energy into the electrical energy, power supply for foreign;The low temperature generating system must solve three big technical keys:One, the anticorrosion (has actuating medium has strong corrosiveness), two is Explosion-proof (Some actuating medium Can have the detonation with the air mix when divulging, controls warm malfunction, elevates temperature suddenly also can have detonation), three is guards against the revolution axis divulging

以太阳能低温发电系统为例，低温发电方法是这样进行的：以水作为储能载体的太阳能采集器将太阳能采集起来，将水温提升至85℃--98℃；用氨作为工作介质储于氨储罐及氨汽路中；采用螺旋管型热交换器；用调压泵将氨储罐中的氨汽压入螺旋管型热交换器的螺旋管内，用调压泵将携带太阳能的85℃--98℃的储能载体热水压入螺旋管型热交换器的螺旋管外壁空间进行循环式热交换，在热交换器的螺旋管出口端，氨汽温度已被加热到85℃--95℃，这时，氨汽具有45kg—55kg/cm2的氨汽压力，通过恒温管道送入氨汽轮机，推动氨汽轮机旋转，带动发电机发电；氨汽作功释放能量后，温度下降，返回氨储罐，再经调压泵压入螺旋管型热交换器进行下一次循环；包括氨汽轮机在内的整个氨汽汽路是自成独立的封闭循环系统，与外界空气是完全隔绝的；氨汽只起携带和转移能量的作用，发电过程中并不消耗工作介质，储能载体水也是只起携带和转移能量的作用，水路也是自成独立的封闭循环系统，发电过程中也不消耗水，通过工作介质氨汽和储能载体水的不断循环运行，通过热交换器将太阳能转化为工作介质氨汽的热能和动能，借助氨汽轮机的热—机转化功能和发电机的机—电转化功能，实现了太阳能的整个热—电转化过程，将太阳能源源不断地转变为电能，对外供电；低温发电系统要解决的三大技术关键：一是防腐（有的工作介质具有较强的腐蚀性）、二是防爆（有的介质泄漏与空气混合会产生爆炸，控温失灵，急剧升温也会产生爆炸）、三是防轴漏（汽轮机是动态旋转体，必须解决工作介质的防轴漏问题）。

Taking HPAM solutions as an example , the unsteady flow of power-law fluid in eccentric annuli with the inner cylinder reciprocating axially is calculated; the distribution of velocity, flow rate and:stress distribution on the outwall of the inner cyinder is obtained; the effect of eccentricity, stroke and frequency on distribution of velocity is analysed; the effect of eccentricity and axial movement on stress distribution on the outwall of the inner cylinder is analysed too.

在计算上，以HPAM水溶液为例，数值计算了幂律流体在内管做轴向往复运动的偏心环空中的流动，得出了这种流动的速度，流量和流体在内管壁上的压力分布；分析了环空偏心度以及内管冲程和冲次对流体速度分布的影响；分析了环空偏心度和内管轴向运动对流体在内管壁上压力分布的影响。

The theoretical and computational results show that an important reason resulting in eccentric wear of the inner cylinder and the pumping rod lies in the nonuniformity of the stress distribution on the outwall of the inner cylinder which yields excentralization effect of the pumping rod when swabbing fluid flows in eccentric annuli with the pumping rod moving axially in a well.

在实验上，通过不同重量百分比浓度的HPAM水溶液在内管做轴向往复运动的偏心环空中非定常流实验，把由理论公式算得的时间平均流量与实验中测得的时间平均流量做了比较，验证了本文数值计算幂律流体在内管做轴向往复运动的偏心环空中非定常流方法的正确性；上述的理论与计算表明，抽油机井杆管偏磨的一个重要原因是，在聚驱工况下，抽汲液体在抽油杆做轴向运动的井筒中流动时，抽汲液体作用在抽油杆外壁上的压力分布的不均匀性所引起的抽油杆在井筒中的偏心效应。

It simulation results proves that when the inner pipes in the concentric annulus pipes stand still, the turbulent flow nucleus area approaches inner pipes; and when inner pipes circumvolve, the turbulent flow nucleus area approaches outer pipes. The shearing velocity near the inner pipes is the biggest, and the shearing velocity increases with the velocity of the inner pipes increasing.

模拟结果表明：在同心环空管道中当内管静止时，紊流核心区即轴向速度最大值区域靠近内管壁；当内管旋转时，紊流核心区即轴向速度最大值区域靠近外管壁；靠近内管壁处的切向速度最大，且随着内管转速的增加切向速度增大。

RESULTS: After root canal preparation, the mean value of the angles of canal curvature decreased from 36.21° to 21.98°, while the mean value of the radius of the canal curvature increased from 6.25mm to 11.35mm; the canal axes transported and intercrossed with the original axes at 2 points and created 3 intersection zones.

结果：根管预备完毕，根管弯曲角度均值从预备前的36.21°逐渐减小至21.98°，弯曲半径均值从6.28mm增大至11.35mm；根管长轴发生了偏移，与预备前原根管长轴形成2个交点，3个相交区。

The microstructure and the mechanical properties of extruded pipes, as well as the blanks, were alsoanalyzed. The results demonstrate that there are a lot of fibred tissues in extruded pipes which will increaseits mechanical properties along axial direction. And the strength of thedeformed material is much higher than the former.

对挤压前坯料和成型管坯分别进行金相显微分析，扫描电镜分析以及力学性能分析，结果表明：通过等温热挤压得到的管坯在轴向有明显的纤维状组织，极大地改善了其轴向力学性能，挤压管坯的强度比通过锻态钻孔得到的管坯有显著提高。

The results indicated that the axial velocity distribution of the mixture was a parabola-like curve along the radius and the change of the velocity was larger in the region within 0%～25% of the pipe width (about 15 mm) from the pipe walls, but smaller in other positions. The vortex changed greatly in the region within 0%～16.7% of the pipe width (about 10 mm) from the pipe walls and then decreased gradually to zero at the pipe center.

结果表明，混合颗粒的轴向速度呈类似抛物线状分布，在靠近管壁约0%～25%管宽范围内，即在试验装置距管壁约15 mm范围内，轴向速度变化较大，其他位置处变化较小；涡量在靠近管壁约0%～16.7%管宽范围内，即在试验装置距管壁约10 mm范围之内变化明显，从距离管壁10 mm到竖直管中心涡量逐渐减小到接近为零。

The experimental and analytical results show that the axial rigidity of the corrugated pipe is 23.0 percent of the bare pipe with the same thickness and diameter,and the thermal compensation performance of the former is 2.27 times the latter's under equal-stress condition.By using corrugated pipe bundle instead of the bare pipe bundle with the same stiffness as its tube sheet,the axial thermal compensation can be increased by 40.4 percent,and the corresponding pulling-out force is 53.2 percent of that of the bare pipe bundle.

研究结果表明，波节换热管单管的刚度为相应光管的23.4%；在最大应力相同的条件下，波节换热管的轴向热补偿量为相应光管的2.27倍；在光管管束与壳体等刚度条件下，用波节管管束代替光管管束，轴向热补偿量可提高40.4%，相应的拉脱力为光管管束的53.2%。

Guangzhou chuanmu automation specialized production flexible coupling,shaft coupling: Plum blossom shaft coupling, diaphragm shaft coupling,parallel shaft coupling, stainless steel shaft coupling, screw type shaft coupling, small dish diaphragm shaft coupling, metal helical spring axial organ, spring steel system shaft coupling, cross slide shaft coupling, rigid shaft coupling and so on.

广州川木自动化专业生产弹性联轴器、联轴节：梅花形联轴器、金属膜片联轴器、平行式联轴器、编码器联轴器、不锈钢联轴器、螺旋式联轴器、碟形膜片联轴器、波纹管联轴器、胀紧套联轴器、金属螺旋弹簧联轴器、弹簧钢制联轴器、十字滑块联轴器、刚性联轴器等。

Experimental results show that: bearing capacity of JPP is thirty percent higher than that of cast-in-place pile which has the same length and diameter with JPP. The deformation of JPP is controlled by core pile; axial force distribution of PHC is different with soil-cement; and their axial force ratio in same section is their elastic modulus ratio. Distribution of inner and outer friction resistance is similar; and the inner friction is about 1.62 times of the outer one; it is about the ratio of JPP diameter and PHC diameter. Furthermore, the relation between friction resistance and relative displacement is similarly hyperbolic; and the relation between dip resistance and displacement is also hyperbolic.

试验结果表明，JPP桩与同桩长、同桩经灌注桩相比承载力高30%以上；JPP桩变形由芯桩控制，管桩轴力分布与水泥土轴力分布规律不一致，但同一截面上管桩和水泥土的轴力比值约为其弹性模量的比值；内外摩阻沿桩身的分布规律类似，内摩阻是外摩阻的1.62倍左右，约为JPP桩直径和管桩直径的比值；桩侧摩阻力与桩土相对位移近似双曲线分布，桩端阻力和桩端位移也近似双曲线分布。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。