轴管

The following are the expressions for the mean pressure set up at the detection plate and for the time of the signal to progagate from the radiator to the detector:这里是1个公式,省略） where Re is the real part of the expression appearing within the braces, 0 is the density of the medium, vo is the amplitude of the vibrational velocity, c is the speed of sound in the medium, d2 = I +(r/zcos 8, z is the distance between the emitting and receiving plates, B is the angle between the axis of the acoustic channel and the axis of the tube, r = vro/c, v is the flow speed of the fluid, d is the diameter of the pipe, m is the circular frequency, k is the wave number, where a is the radius of the plate (this is taken as the same for the emitting and receiving plates for simplicity, but there is no difficulty in discussing plates differ~mg in radii),,~ is the vibrational frequency of the emitting plate, and The triple sums in the expressions for N~ and N2 may be neglected if the flow speed is low, since the contributions for these become negligible.

以下的表情为代表的压力设置在检测板甲，手持骑枪和时间的信号 progagate从散热器排出到检测器(这里是1个公式、省略)。在什么地方才是真正的出现在背带，表现为0密度的吗当时的媒介的振幅振动速度、c是声音的速度中、d2 =我+ r / z，8、z是距离的发射和接收板、B之间的角度对声信道和轴轴管，r = vro / c，v的流体的流动速率公式，d 管直径的圆频率，m，凯西是波数公式* n，一个是半径的板(这是作为相同的发射和接收吗为了简单，但板板是毫无困难地讨论不同半径)、镁-，~的振动频率的发光，。总结了三倍的表达方式和N2 ~能忽略的流量速度低，因为这些变得微不足道的贡献。

Firstyouneedtheboringfortheshaft,theninstall the stern tube into the stern frame, next fit the gunmetal or whitemetalbush.

首先要镗孔，然后安装尾轴管，接下来装炮铜或白合金制的轴承套，也叫轴承。

The dielectric barrier corona discharge in a wire-cylinder configuration and the dielectric barrier discharge in a coaxial cylinder configuration are investigated, then the dissipated power and gas gap voltage are calculated by analyzing the measured Lissajous figure.

采用同轴管状反应器产生介质阻档放电，采用同轴线管反应器产生局部电晕放电及介质阻档电晕放电，研究介质阻档放电与介质阻档电晕放电在放电特性与脱硫能耗上的差异。

On the ship center line of the dock, a laser equipment (this laser equipment only can turn in same vertical face)is put on someplace between the Fr –3# and the Fr 7.5#.

在船坞底船体中心线上，-3#肋位与艉轴管后端面所在肋位之间某处放一激光仪（此激光仪只能在同一重垂面内转动），然后分别用激光打-3#肋位及艉轴管后端面两处的钢丝心，确定这两点在船中心面的内，及已确定了整根轴线在同一中心面上。

In thin sections and macerated specimens, axial canal and concentric stratification within the sponge spicules can be observed.

骨针形态完整，并保存了内部轴丝、轴管以及同心圈层等微细构造。

Respectively lase both sides of the stern tube in order to measure the boring dimensions roughly.

在艉轴管前后分别用激光粗打镗孔余量的分布情况。

The wire winding wheel has one left disc with two sections of circular wall to form the power cable inlet and embedding opening and positioning hole in the peripheral of the shaft pipe; one right disc with central shaft pipe, positioning expansion pipe capable of being inserted into the positioning hole and circular wall in the same radius as that in the left disc; and one power cable winding shaft inserted into the circular walls to form one integral and with power cable inlet.

本发明在左内凹盘的反面圆台上相对位置突出2段弧形围壁，成为电源线导入口和对侧的嵌入豁口，轴管外围分设定位孔；右内凹盘反面圆台中央也突出轴管，其外围对应定位孔的位置上设置可插入孔内的定位胀管，环设的环围壁与左内凹盘的反面圆台上弧形围壁对应等径；嵌入围壁插入嵌入豁口而成为一体的设有电源线导入口的绕线轴。

Preparing work before tail shaft installation, the flushing oil and the integrity of stern tube should be delivered to ship-owner and surveyor.

安装前的清洁：用压缩空气和棉布将艉轴管及艉轴彻底清洗干净。3。艉轴安装前的准备工作：艉管串油与艉管密性已经交检结束。

The main products have the stern tube shaft, stern tube bearing white alloy, rubber bearings, high-polymer bearings, tail shaft, intermediate shaft, the upper and lower rudder stock, oil lubrication, water lubricated seal device and its accessories.

主要产品有艉轴管，艉管白合金轴承，橡胶轴承，高聚体轴承，尾轴，中间轴，上、下舵杆，油润滑、水润滑密封装置及其配件等。

Repair List) The clearance between the tailshaft and stern tube to be measured before and after repair, and records in three copies to be handed over to the chief engineer.

修理单在修理前后，尾轴和尾轴管之间的间隙需测量，记录一式三份交给轮机长。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了