轴的

This thesis is combined with the project－"design and exploitation of Automotive Constant Drive-Shaft", which is undertaken by the topic team. Based on the structural simplification to three-dimension solid models of ball-cage type and three column-shaft type constant velocity joint, and the three-dimension solid models are obtained by conversion engineering. Altair/Hpermesh software is used here for generating the finite element mesh of key parts of ball-cage type and three column-shaft type constant velocity joint.

本文结合课题组承担的"汽车等速驱动轴设计开发"项目，在对通过逆向工程方法获得的等速驱动轴的球笼式等速万向节和三枢轴式等速万向节三维实体模型进行结构简化的基础上，利用Altair/Hypermesh软件对球笼式和三枢轴式等速万向节的各关键零件进行了有限元网格划分。

Snood 来源:http://blogs.msdn.com/excel 发表于:2006年7月7日Charting III Tabs and Templates In the previous two charting posts, I wrote about how you can make a professional chart with four simple choices chart type, chart layout

有两个例子：一个是图例的，一个是轴的。从图例图形目录中可以选择图例的位置，从轴图形目录中可以选择可见的轴。其他图形目录还可选择数据标志的位置，分类轴方向和网格线模式。

The tectonic rocks along the fault zone are composed of cataclastic rocks and mylonites formed in higher, middle and lower temperature. Respectively, both of structural features and rocks have the features of multiple phase's of deformation. The deformation features of main minerals in the high temperature mylonites show that: the quartz has the form of long single crystal and the fabric feature of point maximum near X axis; the feldspar has the form of recrystallization assemblage, They present a high amphibolite-granulite facies with temperature ＞600℃ and depth ＞20km. The deformation features of mylonites formed in middle temperature show that: the quartz has the form of polycrystal banding and the fabric feature of point maximum near Y axis and small circle girdle with Y rotational axis; the feldspar has the form of a coremantle structure, They reflect a high greenschist-lower amphibolite facies with temperature from 400℃ to 600℃ and depth from 15km to 20km.

其中，高温糜棱岩主要矿物变形特征组合为：石英为长矩状或长条状单晶、组构为近X轴的点极密，长石为几乎完全重结晶的集合体，形成温度＞600℃，相当于高角闪岩—麻粒岩相，形成深度＞20km；中温糜棱岩主要矿物变形特征组合为：石英为多晶条带、组构为近Y轴点极密和以Y轴为旋转轴的小圆环带，长石发育核幔结构，形成温度为400～600℃，相当于高绿片岩—低角闪岩相，形成深度为15～20km；低温糜棱岩主要矿物变形特征组合为：石英发育核幔结构、组构特征为近Z轴点极密，长石以碎裂为主，形成温度＜400℃，相当于中低绿片岩相，形成深度为8～12km；碎裂岩则主要代表了地表浅层的变形。

Hydraulic forces applied on the agitator are simplified as a main moment and a main force on the agitating shaft, Initial decentration of agitator is determined based on the balance standard. The dynamic responses, such as fluctuating bending stresses and dynamic deflections, of the agitating shaft under no-liquid and normal working conditions are studied.

将搅拌器上的流体作用力简化为一个主矩和主矢；为考虑作用在搅拌轴上的惯性力效应，根据平衡精度预设搅拌器的初始偏心；在转子动力学软件ROTOR中建立搅拌轴的梁盘模型，分别计算了搅拌轴在空载和搅拌工况下的动力响应，并进一步讨论了动力响应与工作转速、轴径和轴长的关系。

Third, the stress-strain and damage parameters on multiaxial fatigue damage critical planes were analyzed. A new multiaxial fatigue damage parameter was presented. This parameter can not only describe multiaxial proportional and nonproportional loading, but also uniaxial loading.

第三，对多轴疲劳损伤临界面上的应力应变及损伤参量进行了分析，在此基础上提出了一种新的多轴疲劳损伤控制参量，该参量不仅能够描述多轴比例与非比例加载下的疲劳损伤，而且可以退化成单轴的形式。

This article introduced the manipulator, it outputs four groups by PLC to actuate the abscissa axis, the z-axis, the chassis rotation, hand-rotating motor separately, and controls the manipulator abscissa axis and the z-axis pint pointing, the micro switch bequeaths the position signal to the PLC main engine; The electrical machinery drives the hand fingernail and the chassis revolve; The solenoid valve controls air valve the switch to control the manipulator hand fingernail to gather, then realizes the manipulator proper motion function.

本文介绍的机械手是由PLC输出四路来分别驱动横轴、竖轴、底盘转动、手转动电机，控制机械手横轴和竖轴的精确定位，微动开关将位置信号传给PLC主机；电机拖动手爪和底盘旋转；电磁阀控制气阀的开关来控制机械手手爪的张合，从而实现机械手精确运动的功能。

WT5BZIf a transfer case with inter axle differential is mounted on the vehicles of whole wheel drive, the torque distribution of respeative axle will be approximately equal to the axle load distribution.

在全轮驱动的汽车上设置带轴间差速器的分动器，可使汽车各轴转矩分配接近其轴荷分配，从而有效地利用各轴的地面附着条件，充分发挥汽车的动力性。

The long V block putted in the arch ribbed plate to limit two degrees of freedom in x axis and the z axes two degrees of freedom, the iron putted in the hole end limit to the degree of freedom which circle the y rotation of axis, the supporting block putted under the ribbed plate to limit degree of freedom along the y axis migration.

长V型块置于拱形肋板后限制x轴的两自由度和z轴的两自由度，挡铁置于孔端限制绕y轴旋转的自由度，支承块置于肋板下方限制沿y轴移动的自由度。

Lead Ph Basic load rating Permissible load F P Nut mass Shaft mass Dynamic rating Ca Static rating C 0 a mm kN kN kN kg kg/m 10 27.6 63.3 2.75 6.51 Type using standard material Standard grease Standard seal Iron-based AFB-LF RR Dimensions of the Ball Screw Nut Attached with Wiper Ring W and QZ Lubricator WW avail- ability QZ avail- ability Dimensions including WW L Length of protrusion with QZ attached QWL Outer diameer of protru- sion with QZ at...

载荷钢球圈列数 DN值预压预压方法导轨型号 2列 2.50圈 70000 无无滚珠丝杠轴加工方式球保持器轴的花键部分中空轴轴承支撑座固定侧的推荐方式精密无无无 BK25，FK25 轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球轴方向刚性 BF25， FF25 单一螺帽右螺纹，左螺纹，左右螺纹无 680.0 螺纹条数。。。

Number of loaded circuits DN Value Preload Method for Providing a Preload Applied preload 3 row 1.00 turns 50000 Yes Constant Pressure Preload 1110 Type of guide Shaft process method Ball cage Splined portion Hollow shaft Ball Rolled None None None Recommended support unit on the Fixed Side type Recommended support unit on the Supported Side type Types of Nuts Threading direction Spacer ball BK30,FK30 BF30, FF30 Simple Nut Right-hand None Rigi...

载荷钢球圈列数 DN值预压预压方法预压负荷 3列 1.00圈 50000 有定压预压 345 导轨型号丝杠轴加工方式球保持器轴的花键部分中空轴滚珠滚轧无无无轴承支撑座固定侧的推荐方式轴承支撑座支撑侧的推荐方式螺母种类螺纹方向间隔钢球 BK15，BK17，BK20，EK15，EK20，FK15，FK20 BF15， BF17， BF20， EF15， EF20， FF15， FF20 简易螺帽右螺纹无轴方向刚性

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。