轴承

Since there is no needto power off the machine during the process of measuring, it can reduce the workforce,heighten the production efficiency, depress the waster rate, and better the productcoherence. This kind of system is very suitable for the product pipelining which needshuge batches, such as auto components, axletree parts and so on.

由于它能使操作人员无需停机就能测量工件，减少了劳动强度，提高了生产效率，又降低了废品率，同时加工出的工件尺寸一致性较好，特别适应于在大批量流水线作业中使用，如汽车零部件、轴承零件的加工等。

I want the back bearings to be absolutely perfectly aligned with center. I have a solid drive shaft going farther back than the norm to the gearbox without any universal joints to compensate for any any imperfections.

我想回到轴承，以绝对完美的排列与中心，我有一个坚实的传动轴越走越回到较规范，以变速箱没有任何普遍接头，以补偿任何的任何不完善之处。

Large vessels with large-axis value of expensive bearings used in place there will be wear and tear, can not be used, TG using thermal spray technology shaft to restore the normal size, so that shaft back to life for the users save the cost of the replacement parts, created a value!

大型船舶用大轴价值昂贵，使用中会出现轴承位磨损，无法使用，徐州天工采用热喷涂技术恢复了大轴正常尺寸，使大轴起死回生，为该用户省去了换新件的费用，创造了价值！

The position system by back bearings of main shaft is adopted to prevent vibration caused by spline and ensures current of main motor stable and extends service life of rollers and dies.

采用主轴后轴承定位系统，避免主轴花键间隙造成晃动，制粒机主机电流平稳，延长压模压辊使用寿命。

SN and SD bearing basically are used prop up runner shaft coming back, like conveyer belt, fanner, advocate transmission shaft and pressure delay wait with electromotor.

SN以及SD轴承主要用来支撑旋转轴，如传送带、电风扇、主传动轴以及。。。。。。

Another some of characteristic of this equipment is: Go up automatically line, self-adjusting control a foot, automatic reinforced stitches reachs backstitch; The change spending type of all sorts of stitch amounts to 80 ～ 190 kinds; The automatic lubricant system protecting clean of initiate, oiliness bearing, durable and safe clutch, make this equipment needs what lowest is restricted to maintain only.

此设备的另一些特点是：自动上线，自动调节压脚，自动回针及倒缝；各种针法的花式变化达80～190种；首创的自动润滑保洁系统，含油轴承，耐用安全离合器等，使该设备只需最低限的保养。。。

This paper introduced a field dynamic balancing method for the rotor suspended by active magnetic bearing s.

介绍了对电磁轴承-挠性转子系统进行本机动平衡的方法。

The second bearing is also a ball bearing.

第二轴承也是球轴承。

The result is meaningful to the improvement of the design of the four-fulcrum thrust ball bearing pack of turbodrill.

研究结果对轴承组的设计改进和涡轮钻具轴向间隙的调整有一定指导意义。

Deep groove ball bearing is a bearing.

深沟球轴承是轴承的一种。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。