轴承

The adaptive filter approach, the Park transform approach,the Hilbert transform approach and the instantaneous power approach are usually utilized to detect the rotor bar breaking fault on-1ine.

针对异步电动机轴承故障，本文就基于振动信号分析和定子电流信号分析的轴承故障检测方法分别进行了讨论。

This model includes not only the effects on the dynamic capability of wood-working circular saw machine by the structure and installing position of each rotary components(such as saw,flange, fastening nut,principle axis,pulley,and so on)of wood-working circular saw machine,but also the effects by the structural parameter,working parameter,and the installing position of the bearing axletree.

本文通过对木工圆锯机结构、支承轴承特性及工作过程的分析，以国产MJ-90精密裁板锯转子系统(锯片、塔轮、锯轴、夹持装置和支承轴承)为研究对象，首次将木工圆锯机旋转构件作为转子系统，运用美国Rotating Machinery Analysis公司开发的大型转子系统动力学商业软件包XLROTOR，建立了木工圆锯机转子系统动力学模型。

Mechanical seal assembly: In the dynamic and static loop mirror coating on the 20th floor cleaner lubricants; add lubricant bearing guided, first gently positioning ring static load bearing guide; longer shaft add the oil, the mechanical seal part of the dynamic ring gently into the shaft, the hand-push retractable seal ring should be able to freely (Note that dynamic and static part of the anti-ring to the assembly site to be in place).

机械密封装配：在动、静环镜面上涂一层洁净的20号润滑油；导轴承座抹上润滑油，先把静环轻轻定位装入导轴承座；再在泵轴上抹上润滑油，把机械密封的动环部分轻轻装渗透泵轴上，用手轻推密封环应能伸缩自如（注意动、静环部分的防转部位需装配到位）。

Mechanical seal assembly: In the dynamic and static loop mirror coating on the 20th floor cleaner lubricants; add lubricant bearing guided, first gently positioning ring static load bearing guide; longer shaft add the oil, the mechanical seal part of the dynamic ring gently into the shaft, the hand-push retractable seal ring should be able to freely (Note that dynamic and static part of the anti-ring to the assembly site to be in place).

机械密封装配：在动、静环镜面上涂一层洁净的20号润滑油；导轴承座抹上润滑油，先把静环轻轻定位装入导轴承座；再在泵轴上抹上润滑油，把机械密封的动环部分轻轻装入泵轴上，用手轻推密封环应能伸缩自如（注意动、静环部分的防转部位需装配到位）。

Mechanical seal assembly: In the dynamic and static loop mirror coating on the 20th floor cleaner lubricants; add lubricant bearing guided, first gently positioning ring static load bearing guide; longer shaft add the oil, the mechanical seal part of the dynamic ring gently into the shaft, the hand-push retractable seal ring should be able to freely (Note that dynamic and static part of the anti-ring to the assembly site to be in place).

机械密封装配：在动、静环镜面上涂一层洁净的20号润滑油；导轴承座抹上润滑油，先把静环轻轻定位装入导轴承座；再在泵轴上抹上润滑油，把机械密封的动环部分轻轻装入泵轴上，用手轻推密封环应能伸缩自如（注重动、静环部分的防转部位需装配到位）。

The disadvantages of cone-point footstep bearing and advantages of new be aring have been analysed in this paper,the test was also made for comparing two bearings.

指出了锥点形锭子下轴承所存在的缺陷，分析了新型油膜滑动下轴承的特点，并进行了对比试验。

Most of the CPU fan with ball bearings between the use of lubricants, with the aging of lubricants, the lubricating effect on getting worse, leading to friction between the ball and large bearings.

大部分CPU风扇的滚珠与轴承之间会使用润滑油，随着润滑油的老化，其润滑效果就越来越差，导致滚珠与轴承之间摩擦力变大。

All the actuators of the three-axis turntable are brushless torque motors, all the bearings are aerostatic air bearings, so the friction caused by these elements can be neglected. The main source of friction is the metal-to-metal friction on the slip rings. Hence the "Columb+Viscous+Static" friction model is used here for analysis.

由于三轴转台的驱动系统选用的是无刷电机，轴承则采用的是气浮轴承，轴系上的摩擦力已大大降低，三轴转台上的摩擦主要是滑环轴上金属对金属的摩擦，所以文中选用&库仑＋粘滞＋静摩擦&的摩擦模型来进行分析。

Reasons:(1) If metal friction sound is the turbocharger rotor-bearing or thrust bearing wear too much, turbocharger impeller and shell friction generated.

原因： （1）如有金属摩擦声，是增压器转子轴承或止推轴承磨损过多，叶轮与增压器壳摩擦而产生。

A total of 18 bearings used through the high-efficiency drive train for full-bearing specifications.

共有18个轴承通过使用高效率的驱动列车全轴承规格。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。