轴承

Bearings run in the 48 hours after the grease gun to use to stamp bearing the pressure to add oil into the grease cup.

在轴承运行48个小时后，要用润滑脂枪向轴承盖上的压注油杯注入补充润滑脂。

This Bearing consists of 3 kinds of grooved washer bearing rings, 2 kinds of cage and ball assembly.

这种轴承由3洗衣机槽轴承环，2架和球组装种。

Firstyouneedtheboringfortheshaft,theninstall the stern tube into the stern frame, next fit the gunmetal or whitemetalbush.

首先要镗孔，然后安装尾轴管，接下来装炮铜或白合金制的轴承套，也叫轴承。

The results show that the linear controller described in this paper is effective to control magnetic bearing. Also it offers a theoretical support for design and impletion of magnetic bearing.

仿真结果表明：利用给出的线性控制器可实现电磁轴承的有效控制，该研究为简化电磁轴承控制系统的设计与实现提供了理论依据。

A set of finite element programs has been developed for the calculation for thermal dynamic lubrication of inclinable bush radial bearing s with considerations accorded the characteristics of inclinable bush bearings using the thermal flow dynamic lubrication theory.

根据可倾瓦轴承的特点和热流动力润滑理论，开发了一套可倾瓦径向轴承热动力润滑计算的有限元程序。

Based on the analysis of the short life of the bearings in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearings and the related parts in the speed increaser ,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

Based on the analysis of the short life of the bearing s in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearing s and the related parts in the speed increaser,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

Picker-wheel support structure was used in strip label papers of tobacco industry, but it had appeared some problems: picker-wheel vibrates easily, label paper was picked insecurely, and double-shafts generated deformation and linear bearings wear easily. The ultimate cause was founded by analyzing linear bearings stress from statics and dynamics. The original structure of double-shafts one-side support was replaced by two-side support with one fixed end and one free end.

针对FOCKE350S条盒商标纸拾取轮总成支撑结构拾取轮易振动、商标纸拾取不可靠、双轴易弯曲变形、直线轴承磨损快的情况，从静力学和动力学的角度分析了直线轴承磨损快的根本原因；并将原来双轴单侧支撑结构改为双轴双侧支撑，采用一端固定，一端游动的支撑方式。

Picker-wheel support structure was used in strip label papers of tobacco industry, but it had appeared some problems : picker-wheel vibrates easily, label paper was picked insecurely, and double-shafts generated deformation and linear bearings wear easily. The ultimate cause was founded by analyzing linear bearings stress from statics and dynam-c- teplaced by two-side support with one fixed end and one free end.

针对FOCKE350S条盒商标纸拾取轮总成支撑结构拾取轮易振动、商标纸拾取不可靠、双轴易弯曲变形、直线轴承磨损快的情况，从静力学和动力学的角度分析了直线轴承磨损快的根本原因；并将原来双轴单侧支撑结构改为双轴双侧支撑，采用一端固定，一端游动的支撑方式。

This paper introduces the inverse spectrum and its features ,and presents with some applied experimental examples in the rolling bearing analysis by using this method.

转动轴承故障的倒频谱分析张文苑周湛学刘国众摘要：先容了倒频谱及其特点，列举了其在转动轴承分析中的应用实例。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。