轴承

Discussed its bearing structure design and the reasonable choice of bearing's tolerance and fit,windage, lubrication and airproof .

对其支承结构的设计和轴承的公差配合、轴承的游隙以及润滑与密封等方面的合理选择进行了论述。

MATERIALS : Body of blood pump and impeller were titanium alligation, and shaft bearing was ceramic.

材料：血泵泵体及叶轮为钛合金材料，轴承为陶瓷轴承。

Generally speaking, the angle of twist should not exceed one degree in a shaft length equal to 20 diameters.

因此，轴应该有足够的刚度以防止支承轴承承受力过大。总而言之，在两个轴承支承之间，轴在每英尺长度上的弯曲变形应该超过0.01英寸。

Swedish bearing firm is the parent company of Wo Erwo company, this founds the old name company of nearly hundred years does not have anility not only, develop the manufacturer of the biggest the bearing that cross a state on the world step by step instead, its crop takes the whole world 20% of congener product total output, follower makes an enterprise amount to many 100!

瑞典轴承公司是沃尔沃公司的母公司，这家创立近百年的老字号企业不仅没有老态龙钟，反而一步步发展成世界上最大的跨国轴承制造商，其产量占全球同类产品总产量的20%，属下制造企业多达100多家！

Crankshaft bearings are made as precision inserts that consist of a hard shell of bronze with lining of antifrictional metal or bearing alloy.

曲轴轴承是精密刀片即构成一个硬壳的青铜与衬砌antifrictional金属或轴承合金。

The Shandong provincial quality control and inspecting center for bearings is located in the factory taking up the task of quality inspecting and arbitrament of the province＇s bearing products.

山东省轴承产品质量监督检测中心附设该厂，承担着全省轴承产品质量检验和仲裁任务。

The composition, working principle and control arithmetic of a high - speed aviation engine clutch bearing test machine is introduced.

0引言 发动机离合器轴承是发动机的起动机与工作机之间的连接轴承。

With respect to bearing calorific reason and processing technique introduction are as follows: 1, bearing attaint.

就轴承发热的原因及处理方法介绍如下：1、轴承损坏。

Bearing is calorific, make grease gently attenuant leakage, damage bearing again, cause pecuniary loss to the user.

轴承发热，轻则使润滑脂稀释漏出，重则将轴承损坏，给用户造成经济损失。

Professionally used in marking of all kinds of axletree in axletree industry.

专门应用于轴承行业各种类型轴承的打标生产。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。