轴向的

By the use of molecular dynamics method, the axial compressive process of both perfect and defective single-walled BN nanotubes was simulated.

采用分子动力学方法，分别模拟了完好的和含有缺陷的氮化硼纳米管的轴向压缩过程。

The extension of crack and shear strain intensity in the across section vary with that in the vertical section.

在垂直轴向应力的横剖面上，脆性裂隙扩展的规模随纵剖面上断层的不断发展而增加，同时剪应变强度也随之不断增强。

The cross section stress problem of variable section round bar in axial tension and compress was studied.

通过分析变截面圆杆轴向拉压时横截面上的应力问题，论证了在该类图杆横截面上存在沿径向的剪应力，导出了计算该剪应力的公式。

The vapor phase deposition, axial screw dislocation and surface diffusion play important roles in the whisker growth.

在大量的Bi系晶须生长实验的基础上，本文提出了晶须生长的机理，气相沉积，轴向螺位错和界面扩散在晶须生长过程中起了重要作用。

Screw pump the working principle is: screw pump work, the liquid after being inhaled into the screw pump shell and sealed by Wai space, when the initiative screw rotation, the screw pump seal volume in the squeezed increase Luoya Screw pump pressure, and along the axial movement.

螺杆泵的工作原理是：螺杆泵工作时，液体被吸入后就进入螺纹与泵壳所围的密封空间，当主动螺杆旋转时，螺杆泵密封容积在螺牙的挤压下提高螺杆泵压力，并沿轴向移动。

According to the simulation of the mixing property for KBME, the axial distributive mixing property and the shear property of reversed kneading blocks are better than those of neutral and forward ones, and those of normal screw element are worst, whereas the kneading disc width has few impacts on these two properties.

通过对捏合盘混炼段的混合性能模拟可知，就轴向分布混合性能和剪切性能而言，反向捏合块元件优于正向元件和中性捏合块元件，捏合盘厚度对这两个性能的影响不大，而常规螺纹元件的这两个性能相对较差。

The effect of aging treatment on microstructure and strain hardening ability during the process of uniaxial small compressive deformation of super-high manganese steel was investigated.

研究了时效处理工艺对超高锰钢的组织及小变形轴向压缩情况下的形变硬化能力的影响。

From dead-end to open-end, surface velocity increases gradually if the filter passage is shorter and surface velocity of both ends is large than that of middle section if the filter passage is longer. Compared with cylindrical filter, the distribution of surface velocity of conical filter is more uniform.

当过滤通道较短时，过滤元件表面速度沿过滤元件轴向逐渐增大；当过滤通道较长时，过滤元件两端的过滤速度比过滤元件中部的大；同圆柱形过滤元件相比，锥形过滤元件过滤速度的分布更为均匀。

And the H∞ control in the control design of magnetic bearing was applied.

采用了基于H∞控制系统的优化设计思想，在对轴向磁轴承H∞控制进行分析的基础上将H∞控制应用于磁轴承的控制器设计中。

The vibratory equation of Timoshenko's beam supported by continuous multilayer elastic-damping system is presented.

本文导出了支承于连续多层弹性阻尼系统上的Timoshenko梁的振动方程，并考虑了轴向力的作用。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。