轴向的

At 24 h, Ang1 was expressed mainly in the lens, optic cup, mesencephalon, ventral part of hindbrain, and myotomes in the somites, while zfTie2 was mainly expressed in intersomitic vessels including dorsal aorta and axial veins, and sprouting vessels from the dorsal aorta in the trunk. VEGF was expressed mainly in the lens, optic cup, mesencephalon and myotomes in the somites, while zfFlk1 was mainly expressed in intersomitic vessels including dorsal aorta and axial veins, and sprouting vessels from the dorsal aorta in the trunk.

结果从受精卵胚胎发育第12小时可见血管内皮细胞生长因子和血管发生素1及其相应受体flk1和Tie2的表达；在受精卵胚胎发育的第16小时，血管内皮细胞生长因子和血管发生素1主要在头部和尾部胚芽表达；第24小时在眼球、视窝、中脑、后脑的腹前侧和肌节中表达，Tie2和Flk1主要在肌间背部动脉血管、躯干新生血管芽和轴向静脉中表达。

On this foundation the article inducts in detail the method which is based on the relative settlement of calculating unit area end support force at the same time considering the feature of pedestal pile"s "arch effect the article introduces conception of pile effective length and finally obtain the formula of calculating man-made pipe with bulb-shaped axial carrying capacity .

在此基础上论文详细归纳了以相对沉降为依据确定单位面积端承力q_b的计算方法，并考虑扩底桩的&拱效应&特点引入了有效桩长的概念，最后结合公路规范推出了比较实用的人工挖孔扩底桩轴向承载力计算公式。

It is proved that expansion of migrating pingo can produce axis stress of 11 to-21 MPa,formed concentrat...

结果表明，移动冰丘能够产生11~-21MPa的轴向应力和15~-31 MPa的主应力，在桥墩周围形成不同规模的应力集中区，导致桥墩发生显著偏移。

It is proved that expansion of migrating pingo can produce axis stress of 11 to -21MPa, formed concentration of stresses and caused evident displacement and deviation of bridge pier.

结果表明，移动冰丘能够产生11~-21MPa的轴向应力和15~-31MPa的主应力，在桥墩周围形成不同规模的应力集中区，导致桥墩发生显著偏移。

The distributions of the axial pressure in the tube under different injection parameters were measured. The experimental data of the different structure of the slots were also analyzed.

测量了不同射流参数下管内的轴向压力分布，并且对不同结构的射流槽的试验结果进行了比较。

The typical shape of the stress-strain diagram for structural steel is shown in Fig.1, where the axial strains are plotted on the horizontal axis and the corresponding stresses are given by the ordinates to the curve OABCDE .

图1 显示的是结构钢材的应力-应变关系图的典型形状；轴向应变是沿着水平轴线绘制，而相应的应力是以坐标至曲线0ABCDE体现。

We have analysed the relations among the mechanism and effect of the discharge driven catalysis, the parameters and the operating characterisic of our system and the plasma process in it, founded its mathematical model, made program and simulated numerally the distribution of plasma parameters in positive volume of discharge tube as well as the connection with operation of our device.

分析了将单质金作为催化剂，直接置入封离轴向放电型CO〓激光器正柱区毛细管内，充分利用器件工作时产生的短寿命高能态活性氧，在放电激励工作区中就近实时高效催化促复的优越性，肯定了其保持工作物质的浓度，减少有害组分的产生，勿需额外驱动、加热激活乃至排换工作气体。

A comparison of the axial mean velocity results in a chosen normalised radius close to the wall, r/R = 2.8 is shown in Fig.

阿的轴向平均速度的比较在选择靠近墙半径正常化的成果，转/= 2.8 如图所示。

The axial profiles of the worm thread at different sections can be obtained from the gear geometry, lofting the profile curves produces the NURBS (non-uniform rational B-spline) surface of the worm surface.

轴向剖面蠕虫线程在不同路段可从齿轮几何学放样的轮廓线产生的NURBS表面的蠕虫表面。

A new gear grinding way without axial feeding based on the principle of the worm gearing,and how to make up the machine,motions needed in the machine and relationship of the motions are dissertated.

论述了基于这种原理的蜗杆砂轮磨削圆柱齿轮实现无轴向进给磨削的方法及其机床构成和所需要的运动及其相对关系，分析了完成磨削所需要的各种运动及其实现方法。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。